The Hunter 36 is an American

sailboat A sailboat or sailing boat is a boat propelled partly or entirely by sails and is smaller than a sailing ship. Distinctions in what constitutes a sailing boat and ship vary by region and maritime culture. Types Although sailboat terminolo ...

that was designed by John Cherubini as a cruising sailboat and first built in 1980. The design can be confused with the 1990 Hunter 36 Vision, 2008 Hunter 36-2 (sold as the Hunter 36) and the 2001

Hunter 36 Legend The Hunter 36 Legend is an American sailboat, that was designed by Glenn Henderson and first built in 2001. The design can be confused with the 1980 Hunter 36, 2008 Hunter 36-2 (sold as the Hunter 36) and the 1990 Hunter 36 Vision, all sail ...

, all sailboats with similar names by the same builder.

Production

The design was built by Hunter Marine in the

United States The United States of America (U.S.A. or USA), commonly known as the United States (U.S. or US) or America, is a country primarily located in North America. It consists of 50 states, a federal district, five major unincorporated territori ...

between 1980-1983, but it is now out of production.

Design

The Hunter 36 is a recreational

keelboat A keelboat is a riverine cargo-capable working boat, or a small- to mid-sized recreational sailing yacht. The boats in the first category have shallow structural keels, and are nearly flat-bottomed and often used leeboards if forced in open w ...

, built predominantly of

fiberglass Fiberglass (American English) or fibreglass ( Commonwealth English) is a common type of fiber-reinforced plastic using glass fiber. The fibers may be randomly arranged, flattened into a sheet called a chopped strand mat, or woven into glass clo ...

, with wood trim. It has a

masthead sloop A masthead rig on a sailing vessel consists of a forestay and backstay both attached at the top of the mast. The Bermuda rig can be split into two groups: the masthead rig and the fractional rig. The masthead rig has larger and more headsails, ...

rig, a

raked stem The stem is the most forward part of a boat or ship's bow and is an extension of the keel itself. It is often found on wooden boats or ships, but not exclusively. Description The stem is the curved edge stretching from the keel below, up to ...

, a raised

reverse transom A transom is the vertical reinforcement which strengthens the stern of a boat. This flat termination of the stern is typically above the waterline. The term was used as far back as Middle English in the 1300s, having come from Latin ''transvers ...

, an internally-mounted spade-type

rudder A rudder is a primary control surface used to steer a ship, boat, submarine, hovercraft, aircraft, or other vehicle that moves through a fluid medium (generally air or water). On an aircraft the rudder is used primarily to counter adve ...

controlled by a wheel and a fixed fin

keel The keel is the bottom-most longitudinal structural element on a vessel. On some sailboats, it may have a hydrodynamic and counterbalancing purpose, as well. As the laying down of the keel is the initial step in the construction of a ship, in Br ...

. It displaces and carries of ballast. The boat has a draft of with the standard keel fitted. The boat is fitted with an

inboard An inboard motor is a marine propulsion system for boats. As opposed to an outboard motor where an engine is mounted outside the hull of the craft, an ''inboard motor'' is an engine enclosed within the hull of the boat, usually connected to a pr ...

diesel engine The diesel engine, named after Rudolf Diesel, is an internal combustion engine in which ignition of the fuel is caused by the elevated temperature of the air in the cylinder due to mechanical compression; thus, the diesel engine is a so-ca ...

. The design features two private cabins, one forward and one aft, a head with a shower, a U-shaped dining area which converts to a berth, a galley with an oven and a two-burner stove, plus an icebox that can be accessed from the cockpit while under way. The jib is

roller furling Roller furling is a method of furling (i.e. reefing) a yacht's staysail by rolling the sail around a stay. Roller furling is typically used for foresails such as jibs or genoas. A mainsail may also be furled by a similar system, whereby the ...

and dual two-speed, self-tailing winches are provided as standard equipment. The design has a

hull speed Hull speed or displacement speed is the speed at which the wavelength of a vessel's bow wave is equal to the waterline length of the vessel. As boat speed increases from rest, the wavelength of the bow wave increases, and usually its crest-to-t ...

of .

References

External links

Official brochure
{{Hunter Marine Keelboats 1980s sailboat type designs Sailing yachts Sailboat type designs by John Cherubini Sailboat types built by Hunter Marine

Production

Design

See also

References

External links