|
Listed Buildings In Nottingham (Mapperley Ward)
Mapperley is an Wards of the United Kingdom, electoral ward in the city of Nottingham, England. The ward contains 24 Listed building#England and Wales, listed buildings that are recorded in the National Heritage List for England. Of these, one is listed at Grade II*, the middle of the three grades, and the others are at Grade II, the lowest grade. The ward is a mainly residential area to the north of the city centre. Most of the listed buildings are houses and associated structures, and the others include churches and a vicarage, a former lodge, three boundary markers, a former hospital chapel and theatre, and a former cinema. __NOTOC__ Key Buildings References Citations Sources * * * * * * * * * * * * * * * * * * * * * * * * * * {{DEFAULTSORT:Nottingham (Mapperley ward) Lists of listed buildings in Nottinghamshire Nottingham, L ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Mapperley
Mapperley is a residential and commercial area of north-eastern Nottingham, England. The area is bounded by Sherwood to the north-west, Thorneywood to the south and Gedling to the east. History At various periods the terms 'Mapperley' and 'Mapperley Plains' have been applied to lands, on either side of Woodborough Road (B684), from a point at the junction of Mapperley Road, north-east for a distance of some , to that point where the road forks towards Woodborough village. The stretch of Woodborough Road from Mapperley Road to Porchester Road is called 'Mapperley Plains' on Jackson's map of 1851–66, for example. This section considers the history of the suburb within the present day city boundary. The origins of the city of Nottingham suburb called Mapperley seem to be found in the fourteenth century. Writing in the 1670s about lands in the lordship of Basford,(i.e. west of present-day Woodborough Road) which were called ''cornerswong'', Dr Robert Thoroton, notes: :In the t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Entablature
An entablature (; nativization of Italian , from "in" and "table") is the superstructure of moldings and bands which lies horizontally above columns, resting on their capitals. Entablatures are major elements of classical architecture, and are commonly divided into the architrave (the supporting member immediately above; equivalent to the lintel in post and lintel construction), the frieze (an unmolded strip that may or may not be ornamented), and the cornice (the projecting member below the pediment). The Greek and Roman temples are believed to be based on wooden structures, the design transition from wooden to stone structures being called petrification. Overview The structure of an entablature varies with the orders of architecture. In each order, the proportions of the subdivisions (architrave, frieze, cornice) are defined by the proportions of the column. In Roman and Renaissance interpretations, it is usually approximately a quarter of the height of the column. Varian ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Finial
A finial (from '' la, finis'', end) or hip-knob is an element marking the top or end of some object, often formed to be a decorative feature. In architecture, it is a small decorative device, employed to emphasize the Apex (geometry), apex of a dome, spire, tower, roof, or gable or any of various distinctive ornaments at the top, end, or corner of a building or structure. A finial is typically carved in stone. Where there are several such elements they may be called pinnacles. The very top of a finial can be a floral or foliated element called a bouquet. Smaller finials in materials such as metal or wood are used as a decorative ornament on the tops or ends of poles or rods such as tent-poles or curtain rods or any object such as a piece of furniture. These are frequently seen on top of bed posts or clocks. Decorative finials are also commonly used to fasten lampshades, and as an ornamental element at the end of the handles of souvenir spoons. The charm at the end of a pull chain ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Tourelle (architecture)
A tourelle is a type of turret, sometimes used in Chateauesque architecture. A general dictionary defines tourelle as "a small tower (as one springing from corbeling or pier)". An architectural dictionary defines it more specifically as a "corbelled turret, circular in plan, cone-roofed, sometimes containing a circular stair, set at the angle of a tower or wall at high level, and common in Scottish-Baronial architecture".''Oxford Dictionary of Architecture'' A distinction may be made between turrets that are atop corner towers going all the way down to the ground, vs. turret Turret may refer to: * Turret (architecture), a small tower that projects above the wall of a building * Gun turret, a mechanism of a projectile-firing weapon * Objective turret, an indexable holder of multiple lenses in an optical microscope * M ...s that project out and up. A tourelle is the latter. References {{reflist Architectural elements ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hipped Roof
A hip roof, hip-roof or hipped roof, is a type of roof where all sides slope downwards to the walls, usually with a fairly gentle slope (although a tented roof by definition is a hipped roof with steeply pitched slopes rising to a peak). Thus, a hipped roof has no gables or other vertical sides to the roof. A square hip roof is shaped like a pyramid. Hip roofs on houses may have two triangular sides and two trapezoidal ones. A hip roof on a rectangular plan has four faces. They are almost always at the same pitch or slope, which makes them symmetrical about the centerlines. Hip roofs often have a consistent level fascia, meaning that a gutter can be fitted all around. Hip roofs often have dormer slanted sides. Construction Hip roofs are more difficult to construct than a gabled roof, requiring more complex systems of rafters or trusses. Hip roofs can be constructed on a wide variety of plan shapes. Each ridge is central over the rectangle of the building below it. The tri ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Timber Framing
Timber framing (german: Holzfachwerk) and "post-and-beam" construction are traditional methods of building with heavy timbers, creating structures using squared-off and carefully fitted and joined timbers with joints secured by large wooden pegs. If the structural frame of load-bearing timber is left exposed on the exterior of the building it may be referred to as half-timbered, and in many cases the infill between timbers will be used for decorative effect. The country most known for this kind of architecture is Germany, where timber-framed houses are spread all over the country. The method comes from working directly from logs and trees rather than pre-cut dimensional lumber. Hewing this with broadaxes, adzes, and draw knives and using hand-powered braces and augers (brace and bit) and other woodworking tools, artisans or framers could gradually assemble a building. Since this building method has been used for thousands of years in many parts of the world, many styles ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bargeboard
Bargeboard (probably from Medieval Latin ''bargus'', or ''barcus'', a scaffold, and not from the now obsolete synonym "vergeboard") or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof. History Historically, bargeboards are sometimes moulded only or carved, but as a rule the lower edges were cusped and had tracery in the spandrels besides being otherwise elaborated. An example in Britain was one at Ockwells in Berkshire (built 1446–1465), which was moulded and carved as if it were intended for internal work. Modern residential rake fascias are typically made of 2-by dimensional lumber, with trim added for decoration and/or weatherproofing later. See also * Antefix * Cornice * Eaves * Fascia * Karamon – use in Japanese architecture * Soffit A soffit is an exterior or interior architectural feature, generally the horiz ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Gable
A gable is the generally triangular portion of a wall between the edges of intersecting roof pitches. The shape of the gable and how it is detailed depends on the structural system used, which reflects climate, material availability, and aesthetic concerns. The term gable wall or gable end more commonly refers to the entire wall, including the gable and the wall below it. Some types of roof do not have a gable (for example hip roofs do not). One common type of roof with gables, the gable roof, is named after its prominent gables. A parapet made of a series of curves (Dutch gable) or horizontal steps (crow-stepped gable) may hide the diagonal lines of the roof. Gable ends of more recent buildings are often treated in the same way as the Classic pediment form. But unlike Classical structures, which operate through trabeation, the gable ends of many buildings are actually bearing-wall structures. Gable style is also used in the design of fabric structures, with varying degree ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Watson Fothergill
Watson Fothergill (12 July 1841 – 6 March 1928) was a British architect who designed over 100 unique buildings in Nottingham in the East Midlands of England, his influences were mainly from the Gothic Revival and Old English vernacular architecture styles. His work dates from 1864 (when he set himself up in practice) to around 1912. His earliest surviving known building dates from 1866. Early life Born Fothergill Watson in Mansfield, Nottinghamshire in 1841, he was the son of wealthy Nottingham Lace merchant Robert Watson and Mary Ann Fothergill. He changed his name to Watson Fothergill in 1892 to continue his maternal family name. Family He married Anne Hage in 1867 at St. John's Church, Mansfield. They had the following children: *Marian Watson (1868–1955) *Annie Forbes Watson (1869–1930) *Edith Mary Watson (1871–1936) *Eleanor Fothergill Watson (1872–1946) *Samuel Fothergill Watson (1875–1915) *Harold H Watson (1877-1905) *Clarice Watson (1877–1955) His father ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
St Andrews House - Geograph
ST, St, or St. may refer to: Arts and entertainment * Stanza, in poetry * Suicidal Tendencies, an American heavy metal/hardcore punk band * Star Trek, a science-fiction media franchise * Summa Theologica, a compendium of Catholic philosophy and theology by St. Thomas Aquinas * St or St., abbreviation of "State", especially in the name of a college or university Businesses and organizations Transportation * Germania (airline) (IATA airline designator ST) * Maharashtra State Road Transport Corporation, abbreviated as State Transport * Sound Transit, Central Puget Sound Regional Transit Authority, Washington state, US * Springfield Terminal Railway (Vermont) (railroad reporting mark ST) * Suffolk County Transit, or Suffolk Transit, the bus system serving Suffolk County, New York Other businesses and organizations * Statstjänstemannaförbundet, or Swedish Union of Civil Servants, a trade union * The Secret Team, an alleged covert alliance between the CIA and American indus ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cant (architecture)
A cant in architecture is an angled (oblique-angled) line or surface that cuts off a corner. Something with a cant is ''canted''. Canted facades are a typical of, but not exclusive to, Baroque architecture. The angle breaking the facade is less than a right angle, thus enabling a canted facade to be viewed as, and remain, one composition. Bay windows frequently have canted sides. A cant is sometimes synonymous with ''chamfer A chamfer or is a transitional edge between two faces of an object. Sometimes defined as a form of bevel, it is often created at a 45° angle between two adjoining right-angled faces. Chamfers are frequently used in machining, carpentry, fu ...'' and '' bevel''. References Architectural elements Building engineering {{Architecturalelement-stub ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bay Window
A bay window is a window space projecting outward from the main walls of a building and forming a bay in a room. Types Bay window is a generic term for all protruding window constructions, regardless of whether they are curved or angular, or run over one or multiple storey A storey (British English) or story (American English) is any level part of a building with a floor that could be used by people (for living, work, storage, recreation, etc.). Plurals for the word are ''storeys'' (UK) and ''stories'' (US). T ...s. In plan, the most frequently used shapes are isosceles trapezoid (which may be referred to as a ''canted (architecture), canted bay window'') and rectangle. But other polygonal shapes with more than two corners are also common as are curved shapes. If a bay window is curved it may alternatively be called ''bow window.'' Bay windows in a triangular shape with just one corner exist but are relatively rare. A bay window supported by a corbel, Bracket (archite ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
