Focke-Wulf Fw 191

The Focke-Wulf Fw 191 was a prototype German bomber of World War II, as the Focke-Wulf firm's entry for the Bomber B advanced medium bomber design competition. Two versions were intended to be produced, a twin-engine version using the Junkers Jumo 222 engine and a four-engine variant which was to have used the smaller Daimler-Benz DB 605 engine. The project was eventually abandoned due to technical difficulties with the engines.

Design and development

In July 1939, the RLM issued a specification for a high-performance medium bomber (the "Bomber B" program). It was to have a maximum speed of 600 km/h (370 mph) and be able to carry a bomb load of 4,000 kg (8,820 lb) to any part of Britain from bases in France or Norway. Furthermore, the new bomber was to have a pressurized crew compartment, of the then-generalized "stepless cockpit" design (with no separate windscreen for the pilot) pioneered by the He 111P shortly before the war and used on most German bombers during the war, remotely controlled armament, and was to utilize two of the new 2,500 PS (2,466 hp, 1,839 kW) class of engines then being developed (Jumo 222 or Daimler-Benz DB 604), with the Jumo 222 being specified for the great majority of such twin-engined designs, that Arado, Dornier, Focke-Wulf and Junkers had created airframe designs to use. The Arado Ar E340 was eliminated. The Dornier Do 317 was put on a low-priority development contract; and the Junkers Ju 288 and Focke-Wulf Fw 191 were chosen for full development.

Dipl. Ing E. Kösel, who also worked on the Fw 189 reconnaissance plane, was supposed to have led the design team for the Fw 191. Overall, the Fw 191 was a clean, all-metal aircraft that featured a shoulder-mounted wing. Two 24-cylinder Jumo 222 engines (which showed more promise than the DB 604 engines) were mounted in nacelles on the wings. An interesting feature was the inclusion of the Multhopp-Klappe, an ingenious form of combined landing flap and dive brake, which was developed by Hans Multhopp. The entire fuel supply was carried in five tanks located above the internal bomb bay, and in two tanks in the wing between the engine nacelles and fuselage.

The tail section was of a twin fins and rudders design, with the tailplane having a small amount of dihedral. The main landing gear legs retracted to the rear and rotated 90° to lie flat in each engine nacelle with the mainwheels resting atop the lower ends of the gear struts when fully retracted, much like the main gear on the production versions of the Ju 88 already did. Also, the tailwheel retracted forwards into the fuselage. A crew of four sat in the pressurized cockpit, and a large Plexiglas dome was provided for the navigator; the radio operator could also use this dome to aim the remotely controlled rear guns.

The Fw 191 followed established Luftwaffe practice in concentrating the crew in the nose compartment, also including the nearly ubiquitous ''Bola'', inverted- casemate undernose gondola for defensive weapons mounts first used on the Ju 88A before the war, and in the use of a "stepless cockpit", having no separate windscreen for the pilot, as the later -P and -H versions of the Heinkel He 111 already did. This was pressurised for high-altitude operations. The proposed operational armament consisted of one 20 mm MG 151 cannon in a chin turret, twin 20 mm MG 151 in a remotely controlled dorsal turret, twin 20 mm MG 151 in a remotely controlled ventral turret, a tail turret with one or two machine guns and remotely controlled weapons in the rear of the engine nacelles. However, different combinations were mounted in the prototype aircraft. Sighting stations were provided above the crew compartment, as well as at the ends of the aforementioned ''Bola'' beneath the nose.

The aircraft had an internal bomb bay. In addition, bombs or torpedoes could be carried on external racks between the fuselage and the engine nacelles. The design was to have had a maximum speed of 600 km/h (370 mph), a bomb load of 4,000 kg (8,820 lb), and a range allowing it to bomb any target in Britain from bases in France and Norway.

Failure and end of program

It is said that the intention to use electric power for almost all of the aircraft's auxiliary systems (also a fact for the successful Fw 190 fighter), requiring the installation of a large number of electric motors and wiring led to the nickname for the Fw 191 of "''Das fliegende Kraftwerk''" (the flying powerstation). This also had the detrimental effect of adding even more weight to the overburdened airframe, plus there was also the danger of a single enemy bullet putting every system out of action if the generator was hit. Dipl. Ing Melhorn took the Fw 191 ''V1'' on its maiden flight early in 1942, with immediate problems arising from the lower rated engines not providing enough power, as was anticipated. One surprising problem that was encountered were the Multhopp-Klappe, which presented severe flutter problems when extended, and pointed to the need for a redesign. At this point, only dummy gun installations were fitted and no bomb load was carried. After completing ten test flights, the Fw 191 ''V1'' was joined by the similar ''V2'', but only a total of ten hours of test flight time was logged. The 2,500 PS (2,466 hp, 1,839 kW) Junkers Jumo 222 engines which would have powered the Fw 191 proved troublesome. In total only three prototype aircraft, ''V1'', ''V2'' and ''V6'', were built. The project was crippled by engine problems and an extensive use of electrical motor-driven systems. Problems arose almost immediately when the Jumo 222 engines were not ready in time for the first flight tests, so a pair of 1,560 PS (1,539 hp, 1,147 kW) BMW 801A radial engines were fitted. This made the Fw 191 ''V1'' seriously underpowered. Another problem arose with the RLM's insistence that all systems that would normally be hydraulic or mechanically activated should be operated by electric motors.

At this point, the RLM allowed the redesign and removal of the electric motors (to be replaced by the standard hydraulics), so the Fw 191 ''V3'', ''V4'' and ''V5'' were abandoned. The Fw 191 ''V6'' was then modified to the new design, and also a pair of specially prepared Jumo 222 engines were fitted that developed 2,200 PS (2,170 hp, 1,618 kW) for takeoff. The first flight of the new Fw 191 took place in December 1942 with ''Flugkapitän'' Hans Sander at the controls. Although the ''V6'' flew better, the Jumo 222 were still not producing their design power, and the whole Jumo 222 development prospect was considered dubious due to the shortage of special metals for it. The Fw 191 ''V6'' was to have been the production prototype for the Fw 191A series.

Due to the German aviation engine industry having chronic problems in producing engines capable of equal to or more than the 1,500 kW (2,000 PS) figure during the war, that were fit for service, the Jumo 222 engines were having a lot of teething problems and the Daimler Benz DB 604 had already been abandoned, a new proposal was put forth for the Fw 191B series. The ''V7'' through ''V12'' machines were abandoned in favor of using the Fw 191 V13 to install a pair of Daimler Benz DB 606 or 610 "power system" engines, which were basically coupled pairs of either DB 601 or 605 12-cylinder engines. Their lower power-to-weight ratio from their 1.5 tonne weight for each "power system", meant that the armament and payload would have to be reduced. It had already been decided to delete the engine nacelle gun turrets, and to make the rest manually operated. Five more prototypes were planned with the new engine arrangement, ''V14'' through ''V18'', but none were ever built, possibly from the August 1942 condemnation by ''Reichsmarschall'' Hermann Göring of the coupled "power system" DB 606 and 610 powerplants as "welded-together engines", in regards to their being the primary cause of the unending series of powerplant problems in their primary use, as the engines on Heinkel's He 177A ''Greif'', Germany's only production heavy bomber of World War II.

One final attempt was made to save the Fw 191 program, this time the Fw 191C was proposed as a four engined aircraft, using either the 1,340 PS (1,322 hp, 986 kW) Jumo 211F, the 1,350 PS (1,332 hp, 993 kW) DB 601E, the 1,475 PS (1,455 hp, 1,085 kW) DB 605A or similar rated DB 628 engines. Also, the cabin would be unpressurized and the guns manually operated, with a rear step in the bottom of the deepened fuselage — in the manner of the near-ubiquitous ''Bola'' gondola used by the majority of German bombers for ventral defense under the nose — being provided for the gunner. Focke-Wulf used the designations Fw 391 and Fw 491 for the different variants of the Fw 191C, but these were unofficial and never allocated by the RLM.Herwig, Dieter; Rode, Heinz (2000). Luftwaffe secret projects : strategic bombers 1935-45 (1st English ed.). Earl Shilton: Midland. p 29. .

The "Bomber B" program had been canceled, due mainly to no engines of the 2,500 PS class being available, which was one of the primary requirements in the "Bomber B" program. Although the Fw 191 will be remembered as a failure, the airframe and design eventually proved themselves to be sound; only the underpowered engines and insistence on electric motors to operate all the systems doomed the aircraft. There were only three Fw 191s built (''V1'', ''V2'' and ''V6''), and no examples of the Fw 191B or C ever advanced past the design stage. The RLM kept in reserve for Focke-Wulf the future number: Fw 391 for follow-up designs but nothing came of it and the project was eventually scrapped.

Specifications (Fw 191B - DB 610 engines)

See also

Comparable aircraft
* Avro Manchester
* Dornier Do 317
* Junkers Ju 288
* Martin XB-33

References

Notes

Bibliography

* ''Jane's All the World's Aircraft 1945'', page 117c and addendum 23
* ''Jane's Fighting Aircraft of World War II''. London. Studio Editions Ltd, 1989.

External links

Fw 191

WW2 in Color

{{Authority control

Fw 191
1940s German bomber aircraft
Shoulder-wing aircraft
Aircraft first flown in 1942
Twin piston-engined tractor aircraft