Penryn (microprocessor)

Penryn is the code name of a processor from Intel that is sold in varying configurations as Core 2 Solo, Core 2 Duo, Core 2 Quad, Pentium and Celeron.

During development, Penryn was the Intel code name for the 2007/2008 "Tick" of Intel's Tick-Tock cycle which shrunk Merom to 45 nanometers as CPUID model 23. The term "Penryn" is sometimes used to refer to all 45 nm chips with the Core architecture.

Chips with Penryn architecture come in two sizes, with 6 MB and 3 MB L2 cache.

Low power versions of Penryn are known as the Penryn-L; these are single-core processors. The Penryn-QC quad-cores are made from two chips with two cores and 6 MB of cache per chip.

The desktop version of Penryn is Wolfdale and the dual-socket server version is Wolfdale-DP.
Penryn-QC is related to Yorkfield on the desktop and Harpertown in servers. The MP server Dunnington chip is a more distant relative based on a different chip but using the same 45 nm Core microarchitecture.

Penryn was replaced by the Nehalem-based Arrandale (dual core) and Clarksfield (quad core).

Variants

Penryn

The successor to the Merom core for the Core 2 Duo T5000/T7000 series mobile processors, code-named Penryn, debuted on the 45 nanometer process. Many details about Penryn appeared at the April 2007 Intel Developer Forum. Intel's new 45 nm Penryn-based Core 2 Duo and Core 2 Extreme processors were released on January 6, 2008. The new processors launched exclusively with a TDP of 35 W; later releases were more energy efficient. HP began to offer the first model, the T9500, from late January 2008. The T9500 offered a 2.6 GHz clock rate, higher than all but the Extreme Edition of the Merom range, and 6 MB (rather than 4 MB) of Level 2 Cache.

Important advances included the addition of new instructions including SSE4 (also known as Penryn New Instructions) and new fabrication materials; most significantly a hafnium-based high-k dielectric.

All SL9xxx, SP9xxx, P9xxx, T9xxx and X9xxx processors are Penryn with the full 6 MB L2 cache enabled, while P7xxx, P8xxx and T8xxx can be either Penryn-3M or Penryn with only 3 MB cache enabled. They are indistinguishable by software, but Penryn uses product code 80576.

Intel released an Apple-only Exxx chip on April 28, 2008 that increased the clock rate to 3.06 GHz as well as increasing the Front Side Bus to 1066 MT/s, and changed the Cache to 6 MB shared L2. While it is used in desktop computers and has an E8xxx name, it uses the same packaging as mobile CPUs and is therefore considered a Penryn and not Wolfdale.

On desktops, Penryn pairs with the 2007 desktop Bearlake chipset series, some of whose models include an increase in bus performance (connection to the northbridge, etc.) to 1333 MT/s and support for DDR3 SDRAM. In notebooks and other mobile equipment, Penryn initially paired with the mobile Crestline chipset series which supports DDR2 but not DDR3, (although when Penryn was released, Intel believed future DDR3 support would benefit mobile equipment's power- and heat-constrained environments). Mobile Penryns were later paired with the Cantiga chipset series which (among other enhancements) added DDR3 support.

Penryn-3M

The smaller (82 mm² instead of 107 mm²) Penryn-3M is used in mobile processors with an L2 Cache 3 MB or less as a successor to Merom-2M. Its product code is 80577.
The entry level Penryn-3M Core 2 processor is the T6xxx series, with 2 MB L2 Cache and begins with the T6400 at a clock rate of 2 GHz.
Other Penryn-3M based processor series are Celeron T3xxx, Pentium T4xxx, as well as most Core 2 Duo SU9xxx, P7xxx, P8xxx, T8xxx processors.

In September 2009, Intel introduced new Consumer Ultra-Low Voltage

HOME


Content is Copyleft
Website design, code, and AI is Copyrighted (c) 2014-2017 by Stephen Payne


Consider donating to Wikimedia



As an Amazon Associate I earn from qualifying purchases