Chemlight

A glow stick, also known as a light stick, chem light, light wand, light rod, and rave light, is a self-contained, short-term light-source. It consists of a translucent plastic tube containing isolated substances that, when combined, make light through chemiluminescence. The light cannot be turned off and can be used only once. The used tube is then thrown away. Glow sticks are often used for recreation, such as for events, camping, outdoor exploration, and concerts. Glow sticks are also used for light in military and emergency services applications. Industrial uses include marine, transportation, and mining.

History

Bis(2,4,5-trichlorophenyl-6-carbopentoxyphenyl)oxalate, trademarked "Cyalume", was invented in 1971 by Michael M. Rauhut, of American Cyanamid, based on work by Edwin A. Chandross of Bell Labs.

Other early work on chemiluminescence was carried out at the same time, by researchers under Herbert Richter at China Lake Naval Weapons Center.

Several US patents for glow stick-type devices were issued in 1973-74. A later 1976 patent recommended a single glass ampoule that is suspended in a second substance, that when broken and mixed together, provide the chemiluminescent light. The design also included a stand for the signal device so it could be thrown from a moving vehicle and remain standing in an upright position on the road. The idea was this would replace traditional emergency roadside flares and would be superior, since it was not a fire hazard, would be easier and safer to deploy, and would not be made ineffective if struck by passing vehicles. This design, with its single glass ampoule inside a plastic tube filled with a second substance that when bent breaks the glass and then is shaken to mix the substances, most closely resembles the typical glow stick sold today.

In the early 1980s the majority of glow sticks were produced in Novato, California by Omniglow Corp. Omniglow completed a leveraged buyout of American Cyanamid's chemical light division in 1994 and became the leading supplier of glow sticks worldwide until going out of business in 2014. Most glow sticks seen today are now made in China.

Uses

Glow sticks are waterproof, do not use batteries, consume no oxygen, generate no or negligible heat, produce neither spark nor flame, can tolerate high pressures such as those found under water, are inexpensive, and are reasonably disposable. This makes them ideal as light sources and light markers by military forces, campers, spelunkers, and recreational divers.

Entertainment

Glowsticking is the use of glow sticks in dancing. They are frequently used for entertainment at parties (in particular raves), concerts, and dance clubs. They are used by marching band conductors for evening performances; glow sticks are also used in festivals and celebrations around the world. Glow sticks also serve multiple functions as toys, readily visible night-time warnings to motorists, and luminous markings that enable parents to keep track of their children. Another use is for balloon-carried light effects. Glow sticks are also used to create special effects in low light photography and film.

The ''Guinness Book of Records'' recorded the world's largest glow stick was cracked at tall. It was created by the University of Wisconsin–Whitewater's Chemistry Department to celebrate the school's sesquicentennial, or 150th birthday in Whitewater, Wisconsin and cracked on 9 September 2018.

Recreation and survival

Glow sticks are used for outdoor recreation, often used at night for marking. Scuba divers use diving-rated glow sticks to mark themselves during night dives, and then can turn off bright diving lights. This is done to enable visibility of bioluminescent marine organisms, which cannot be seen while a bright dive light is illuminated. Glow sticks are used on backpacks, tent pegs, and on jackets during overnight camping expeditions. Often, glow sticks are recommended as an addition to survival kits.

Industry

There are specific industrial uses of glow sticks, which are often used as a light source in circumstances where electric lighting and LEDs are not best suited. For example, in the mining industry, glow sticks are required for emergency evacuation in the case of a gas leak. Use of an electric light source in this case may cause an unintended explosion. Chemiluminescence, the type of light used in glow sticks, is a "cold-light" and does not use electricity, and will not cause a gas leak to ignite.

Glow sticks are also used worldwide in the marine industry, often used as fishing lures in long-line, recreational, and commercial fishing, as well as for personnel safety.

Military

Glow sticks are used by militaries, and occasionally also police tactical units, as light sources during night operations or close-quarters combat in dark areas. They are also used to mark secured areas or objects of note. When worn, they can be used to identify friendly soldiers during nighttime operations.

Emergency services

Glow sticks are used by police, fire, and emergency medical services as light sources, similar to their military applications. Often, emergency rescue crews will hand out glow sticks in order to keep track of people at night, who may not have access to their own lighting. Glow sticks are sometimes attached to life vests and lifeboats on passenger and commercial vessels, to ensure night time visibility.

Glow sticks are often part of emergency kits to provide basic lighting and provide ease of identification in dark areas. They can be found in emergency lighting kits in buildings, public transportation vehicles, and subway stations.

Operation

Glow sticks emit light when two chemicals are mixed. The reaction between the two chemicals is catalyzed by a base, usually sodium salicylate. The sticks consist of a tiny, brittle container within a flexible outer container. Each container holds a different solution. When the outer container is flexed, the inner container breaks, allowing the solutions to combine, causing the necessary chemical reaction. After breaking, the tube is shaken to thoroughly mix the components.

The glow stick contains two chemicals, a base catalyst, and a suitable dye ( sensitizer, or fluorophor). This creates an exergonic reaction. The chemicals inside the plastic tube are a mixture of the dye, the base catalyst, and diphenyl oxalate. The chemical in the glass vial is hydrogen peroxide. By mixing the peroxide with the phenyl oxalate ester, a chemical reaction takes place, yielding two moles of phenol and one mole of peroxyacid ester ( 1,2-dioxetanedione). The peroxyacid decomposes spontaneously to carbon dioxide, releasing energy that excites the dye, which then relaxes by releasing a photon. The wavelength of the photon—the color of the emitted light—depends on the structure of the dye. The reaction releases energy mostly as light, with very little heat. The reason for this is that the reverse + 2photocycloadditions of 1,2-dioxetanedione is a forbidden transition (it violates Woodward–Hoffmann rules) and cannot proceed through a regular thermal mechanism.

By adjusting the concentrations of the two chemicals and the base, manufacturers can produce glow sticks that glow either brightly for a short amount of time or more dimly for an extended length of time. This also allows glow sticks to perform satisfactorily in hot or cold climates, by compensating for the temperature dependence of reaction. At maximum concentration (typically found only in laboratory settings), mixing the chemicals results in a furious reaction, producing large amounts of light for only a few seconds. The same effect can be achieved by adding copious amounts of sodium salicylate or other bases. Heating a glow stick also causes the reaction to proceed faster and the glow stick to glow more brightly for a brief period. Cooling a glow stick slows the reaction a small amount and causes it to last longer, but the light is dimmer. This can be demonstrated by refrigerating or freezing an active glow stick; when it warms up again, it will resume glowing. The dyes used in glow sticks usually exhibit fluorescence when exposed to ultraviolet radiation—even a spent glow stick may therefore shine under a black light.

The light intensity is high immediately after activation, then exponentially decays. Leveling of this initial high output is possible by refrigerating the glow stick before activation.

A combination of two fluorophores can be used, with one in the solution and another incorporated to the walls of the container. This is advantageous when the second fluorophore would degrade in solution or be attacked by the chemicals. The emission spectrum of the first fluorophore and the absorption spectrum of the second one have to largely overlap, and the first one has to emit at shorter wavelength than the second one. A downconversion from ultraviolet to visible is possible, as is conversion between visible wavelengths (e.g., green to orange) or visible to near-infrared. The shift can be as much as 200 nm, but usually the range is about 20–100 nm longer than the absorption spectrum. Glow sticks using this approach tend to have colored containers, due to the dye embedded in the plastic. Infrared glow sticks may appear dark-red to black, as the dyes absorb the visible light produced inside the container and reemit near-infrared.

On the other hand, various colors can also be achieved by simply mixing several fluorophores within the solution to achieve the desired effect. These various colors can be achieved due to the principles of additive color. For example, a combination of red, yellow, and green fluorophores is used in orange light sticks, and a combination of several fluorescers is used in white light sticks.

Fluorophores used

*9,10-Diphenylanthracene (DPA) emits blue light
* 9-(2-phenylethenyl) anthracene emits teal light
* 1-chloro-9,10-diphenylanthracene (1-chloro(DPA)) and 2-chloro-9,10-diphenylanthracene (2-chloro(DPA)) emit blue-green light more efficiently than nonsubstituted DPA
* 9,10-Bis(phenylethynyl)anthracene (BPEA) emits green light with maximum at 486 nm
* 1-Chloro-9,10-bis(phenylethynyl)anthracene emits yellow-green light, used in 30-minute high-intensity Cyalume sticks
* 2-Chloro-9,10-bis(phenylethynyl)anthracene emits green light, used in 12-hour low-intensity Cyalume sticks
* 1,8-dichloro-9,10-bis(phenylethynyl)anthracene emits yellow light, used in Cyalume sticks
*Rubrene emits orange-yellow at 550 nm
* 2,4-di-tert-butylphenyl 1,4,5,8-tetracarboxynaphthalene diamide emits deep red light, together with DPA is used to produce white or hot-pink light, depending on their ratio
*Rhodamine B emits red light. It is rarely used, as it breaks down in contact with CPPO, shortening the shelf life of the mixture.
* 5,12-Bis(phenylethynyl)naphthacene emits orange light
*Violanthrone emits orange light at 630 nm
* 16,17-(1,2-ethylenedioxy)violanthrone emits red at 680 nm
* 16,17-dihexyloxyviolanthrone emits infrared at 725 nm
* 16,17-butyloxyviolanthrone emits infrared
* N,N'-bis(2,5,-di-tert-butylphenyl)-3,4,9,10-perylenedicarboximide emits redBindra, Perminder S.; Burris, Andrew D.; Carlson, Carl R.; Smith, Joann M.; Tyler, Orville Z. and Watson, David L. Jr. (2010-03-09) "Chemiluminescent compositions and methods of making and using thereof"
* 1-N,N-dibutylaminoanthracene emits infrared
* 6-methylacridinium iodide emits infrared

Image:9,10-diphenylanthracene.svg, 9,10-diphenylanthracene yields blue light
Image:9,10-bis(phenylethynyl)anthracene.svg, 9,10-bis(phenylethynyl) anthracene yields green light
Image:1-Chloro-BPEA.svg, 1-chloro- 9,10-bis(phenylethynyl) anthracene yields yellow-green light
Image:rubrene.svg, rubrene (5,6,11,12-tetraphenyl naphthacene) yields yellow light
Image:BPEN.svg, 5,12-bis(phenylethynyl) naphthacene yields orange light
Image:Rhodamine 6G.svg, Rhodamine 6G yields orange light
Image:Rhodamine B.svg, Rhodamine B yields red light

Safety issues

Toxicity

In glow sticks, phenol is produced as a byproduct. It is advisable to keep the mixture away from skin and to prevent accidental ingestion if the glow stick case splits or breaks. If spilled on skin, the chemicals could cause slight skin irritation, swelling, or, in extreme circumstances, vomiting and nausea. Some of the chemicals used in older glow sticks were thought to be potential carcinogens. The sensitizers used are polynuclear aromatic hydrocarbons, a class of compounds known for their carcinogenic properties.

Dibutyl phthalate, a plasticizer sometimes used in glow sticks (and many plastics), has raised some health concerns. It was put on California's list of suspected teratogens in 2006. Glow stick liquid contains ingredients that can act as a plasticizer, softening plastics onto which it leaks. Diphenyl oxalate can sting and burn eyes, irritate and sting skin and can burn the mouth and throat if ingested.

Researchers in Brazil, concerned about waste from glowsticks used in fishing in their country, published a study in 2014 on this topic. It measured the secondary reactions that continue within used glow sticks, toxicity to cells in culture, and chemical reactions with DNA ''in vitro.'' The authors found "high toxicity" of light stick solutions, and evidence of reactivity with DNA. They concluded that light stick solutions "are hazardous and that the health risks associated with exposure have not yet been properly evaluated."

Single-use plastics

Glow sticks also contribute to the plastic waste problem, as glow sticks are single-use and made from plastic. Additionally, since the inner vial is often made from glass and the chemicals inside are dangerous if improperly handled, the plastic used for glow sticks is non-recoverable by recycling services, so glow sticks are categorized as non-recyclable waste.

Safety improvements

By the 2020s, work was being done to create safer glow sticks and alternatives. Canadian company Nyoka Design Labs developed glow stick alternatives. The Light Wand is biodegradable and glows with bioluminescence, rather than the chemiluminescence. The LUMI is a reusable and non-toxic alternative that glows with phosphorescence and is chemically and biologically inert.

See also

* Tritium illumination
* Glowmatography

References

External links

Glowsticks chemistry

{{Parties

Underwater diving safety equipment
Lighting
Luminescence
Party equipment
Light sources