|
Helicopter Rotor
A helicopter main rotor or rotor system is the combination of several rotary wings (rotor blades) with a control system, that generates the aerodynamic lift force that supports the weight of the helicopter, and the thrust that counteracts aerodynamic drag in forward flight. Each main rotor is mounted on a vertical mast over the top of the helicopter, as opposed to a helicopter tail rotor, which connects through a combination of drive shaft(s) and gearboxes along the tail boom. The blade pitch is typically controlled by the pilot using the helicopter flight controls. Helicopters are one example of rotary-wing aircraft (rotorcraft). The name is derived from the Greek words ''helix'', helik-, meaning spiral; and ''pteron'' meaning wing. Design principles Overview The helicopter rotor is powered by the engine, through the transmission, to the rotating mast. The mast is a cylindrical metal shaft that extends upward from—and is driven by—the transmission. At the top of the mast i ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
AH-1 Blade Flight , longest route of the ''Asian Highway Network''
{{Letter-NumberCombDisambig ...
AH-1 or variant may refer to: Minor planets * ''1981 AH1'', or 2684 Douglas * ''1983 AH1'', or 4783 Wasson * ''1991 AH1'', or 8166 Buczynski * ''1994 AH1'', or 7257 Yoshiya * ''1996 AH1'', or 37699 Santini-Aichl * ''2002 AH1'', or 95008 Ivanobertini Vehicles * Bell Huey derived attack helicopters: ** Bell AH-1 Cobra, single engine attack helicopter ** Bell AH-1 SuperCobra, dual engine attack helicopter ** Bell 309 KingCobra, attack helicopter * , a hospital ship Other uses * AH1 Asian Highway 1 (AH1) is the longest route of the Asian Highway Network, running from Tokyo, Japan via Korea, China, Southeast Asia, Bangladesh, India, Pakistan, Afghanistan and Iran to the border between Turkey and Bulgaria west of Istanbul ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Slowed Rotor
The slowed rotor principle is used in the design of some helicopters. On a conventional helicopter the rotational speed of the rotor is constant; reducing it at lower flight speeds can reduce fuel consumption and enable the aircraft to fly more economically. In the compound helicopter and related aircraft configurations such as the gyrodyne and winged autogyro, reducing the rotational speed of the rotor and offloading part of its lift to a fixed wing reduces drag, enabling the aircraft to fly faster. Introduction Traditional helicopters get both their propulsion and lift from the main rotor; by using a dedicated propulsion device such as a propeller or jet engine, the rotor burden is lessened.Chandler, Jay.Advanced rotor designs break conventional helicopter speed restrictions (page 1) The "relative blade tip speed" u is the tip speed relative to the aircraft (not the airspeed of the tip). Thus the formula for Advance ratio is \mu = \frac = \frac where Omega (Ω) is the rot ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hiller YH-32 Hornet
The Hiller YH-32 Hornet (company designation HJ-1) was an American ultralight helicopter built by Hiller Aircraft in the early 1950s. It was a small and unique design because it was powered by two Hiller 8RJ2B ramjet engines mounted on the rotor blade tips which weigh each and deliver an equivalent of for a total of . Versions of the HJ-1 Hornet were built for the United States Army and the United States Navy in the early 1950s. The Hiller Museum identifies the YH-32A, named the ''Sally Rand'', as the first Attack Helicopter, helicopter gunship. Design and development The Hiller HJ-1 Hornet was an early attempt to build a jet-powered helicopter using ramjets. Before that there had been experiments with the XH-26 Jet Jeep tip rotor pulse jets. The HJ-1 ramjet tipped rotor propels the rotor and the aircraft. Unlike a conventional helicopter, this mechanically simple design avoids the need for a tail rotor. Unfortunately, the tip speeds on helicopter rotor blades are subsonic, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Kaman K-MAX
The Kaman K-MAX (company designation K-1200) is an American helicopter with intermeshing rotors (synchropter) by Kaman Aircraft. It is optimized for external cargo load operations, and is able to lift a payload of over , which is more than the helicopter's empty weight. An unmanned aerial vehicle version with optional remote control has been developed and evaluated in extended practical service in the war in Afghanistan. After being out of production for more than a decade, in June 2015 Kaman announced it was restarting production of the K-MAX due to it receiving ten commercial orders.Kaman restarts K-Max production on new commercial orders Flightglobal The first flight of a K-MAX from the restarted production took place in May ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Titanium
Titanium is a chemical element with the symbol Ti and atomic number 22. Found in nature only as an oxide, it can be reduced to produce a lustrous transition metal with a silver color, low density, and high strength, resistant to corrosion in sea water, aqua regia, and chlorine. Titanium was discovered in Cornwall, Great Britain, by William Gregor in 1791 and was named by Martin Heinrich Klaproth after the Titans of Greek mythology. The element occurs within a number of minerals, principally rutile and ilmenite, which are widely distributed in the Earth's crust and lithosphere; it is found in almost all living things, as well as bodies of water, rocks, and soils. The metal is extracted from its principal mineral ores by the Kroll and Hunter processes. The most common compound, titanium dioxide, is a popular photocatalyst and is used in the manufacture of white pigments. Other compounds include titanium tetrachloride (TiCl4), a component of smoke screens and catalysts; and ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Wingtip Vortices
Wingtip vortices are circular patterns of rotating air left behind a wing as it generates lift.Clancy, L.J., ''Aerodynamics'', section 5.14 One wingtip vortex trails from the tip of each wing. Wingtip vortices are sometimes named ''trailing'' or ''lift-induced vortices'' because they also occur at points other than at the wing tips. Indeed, vorticity is trailed at any point on the wing where the lift varies span-wise (a fact described and quantified by the lifting-line theory); it eventually rolls up into large vortices near the wingtip, at the edge of flap devices, or at other abrupt changes in wing planform. Wingtip vortices are associated with induced drag, the imparting of downwash, and are a fundamental consequence of three-dimensional lift generation. Careful selection of wing geometry (in particular, wingspan), as well as of cruise conditions, are design and operational methods to minimize induced drag. Wingtip vortices form the primary component of wake turbulence. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Washout (aviation)
Washout is a characteristic of aircraft wing design which deliberately reduces the lift distribution across the span of an aircraft’s wing. The wing is designed so that the angle of incidence is greater at the wing roots and decreases across the span, becoming lowest at the wing tip. This is usually to ensure that at stall speed the wing root stalls before the wing tips, providing the aircraft with continued aileron control and some resistance to spinning. Washout may also be used to modify the spanwise lift distribution to reduce lift-induced drag. Design considerations Washout is commonly achieved by designing the wing with a slight twist, reducing the angle of incidence from root to tip, and therefore causing a lower angle of attack at the tips than at the roots. This feature is sometimes referred to as structural washout, to distinguish it from aerodynamic washout. Wingtip stall is unlikely to occur symmetrically, especially if the aircraft is maneuvering. As an air ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Glider (sailplane)
A glider or sailplane is a type of glider aircraft used in the leisure activity and sport of gliding (also called soaring). This unpowered aircraft can use naturally occurring currents of rising air in the atmosphere to gain altitude. Sailplanes are aerodynamically streamlined and so can fly a significant distance forward for a small decrease in altitude. In North America the term 'sailplane' is also used to describe this type of aircraft. In other parts of the English-speaking world, the word 'glider' is more common. Types Gliders benefit from producing the least drag for any given amount of lift, and this is best achieved with long, thin wings, a slender fuselage and smooth surfaces with an absence of protuberances. Aircraft with these features are able to soar – climb efficiently in rising air produced by thermals or hills. In still air, sailplanes can glide long distances at high speed with a minimum loss of height in between. Sailplanes have rigid wings and eithe ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Wingtip Vortices
Wingtip vortices are circular patterns of rotating air left behind a wing as it generates lift.Clancy, L.J., ''Aerodynamics'', section 5.14 One wingtip vortex trails from the tip of each wing. Wingtip vortices are sometimes named ''trailing'' or ''lift-induced vortices'' because they also occur at points other than at the wing tips. Indeed, vorticity is trailed at any point on the wing where the lift varies span-wise (a fact described and quantified by the lifting-line theory); it eventually rolls up into large vortices near the wingtip, at the edge of flap devices, or at other abrupt changes in wing planform. Wingtip vortices are associated with induced drag, the imparting of downwash, and are a fundamental consequence of three-dimensional lift generation. Careful selection of wing geometry (in particular, wingspan), as well as of cruise conditions, are design and operational methods to minimize induced drag. Wingtip vortices form the primary component of wake turbulence. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Aspect Ratio (wing)
In aeronautics, the aspect ratio of a wing is the ratio of its span to its mean chord. It is equal to the square of the wingspan divided by the wing area. Thus, a long, narrow wing has a high aspect ratio, whereas a short, wide wing has a low aspect ratio.Kermode, A.C. (1972), ''Mechanics of Flight'', Chapter 3, (p.103, eighth edition), Pitman Publishing Limited, London Aspect ratio and other features of the planform are often used to predict the aerodynamic efficiency of a wing because the lift-to-drag ratio increases with aspect ratio, improving the fuel economy in powered airplanes and the gliding angle of sailplanes. Definition The aspect ratio \text is the ratio of the square of the wingspan b to the projected wing area S, which is equal to the ratio of the wingspan b to the standard mean chord \text: \text \equiv \frac = \frac Mechanism As a useful simplification, an airplane in flight can be imagined to affect a circular cylinder of air with a diameter equal to th ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Airfoil
An airfoil (American English) or aerofoil (British English) is the cross-sectional shape of an object whose motion through a gas is capable of generating significant lift, such as a wing, a sail, or the blades of propeller, rotor, or turbine. A solid body moving through a fluid produces an aerodynamic force. The component of this force perpendicular to the relative freestream velocity is called lift. The component parallel to the relative freestream velocity is called drag. An airfoil is a streamlined shape that is capable of generating significantly more lift than drag. Airfoils can be designed for use at different speeds by modifying their geometry: those for subsonic flight generally have a rounded leading edge, while those designed for supersonic flight tend to be slimmer with a sharp leading edge. All have a sharp trailing edge. Foils of similar function designed with water as the working fluid are called hydrofoils. The lift on an airfoil is primarily the result o ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Igor Bensen
Igor Vasilevich Bensen (russian: И́горь Васи́льевич Бенсен; April 1, 1917 – February 10, 2000) was a Russian-American engineer. He founded Bensen Aircraft, a US company which produced a successful line of gyrogliders (rotor kites) and autogyros. Early life and education He was born in Rostov-on-Don, Russia, and eventually reached the United States in 1937. He began studies at age 17 while in Belgium, won a scholarship to study in the US three years later. He received a Bachelor of Science degree in mechanical engineering from Stevens Institute of Technology in Hoboken, New Jersey in 1940, later becoming a Registered Professional Engineer. Career Bensen flew his first towed gyroglider in 1954. He founded the Popular Rotorcraft Association (PRA) in 1962, a non-profit interest group for owners and homebuilders of autogyros and helicopters, based in Mentone, Indiana. He was the group's president from 1962 to 1971. Honors and awards He received an hon ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
