|
Orin Safier V. Western Digital Corporation
A binary prefix is a unit prefix for multiples of units. It is most often used in data processing, data transmission, and digital information, principally in association with the bit and the byte, to indicate multiplication by a power of 2. As shown in the table to the right there are two sets of symbols for binary prefixes, one set established by International Electrotechnical Commission (IEC) and several other standards and trade organizations using two-letter symbols, e.g. ''Mi'' indicating with a second set established by semiconductor industry convention using one-letter symbols, e.g., ''M'' also indicating . In most contexts, industry uses the multipliers ''kilo'' (''k''), ''mega'' (''M''), ''giga'' (''G''), etc., in a manner consistent with their meaning in the International System of Units (SI), namely as powers of 1000. For example, a 500-gigabyte hard disk holds bytes, and a 1 Gbit/s (gigabit per second) Ethernet connection transfers data at nominal ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Unit Prefix
A unit prefix is a specifier or mnemonic that is prepended to units of measurement to indicate multiples or fractions of the units. Units of various order of magnitude, sizes are commonly formed by the use of such prefixes. The Metric prefix, prefixes of the metric system, such as ''kilo-, kilo'' and ''milli-, milli'', represent multiplication by exponentiation, powers of ten. In information technology it is common to use binary prefixes, which are based on power of 2, powers of two. Historically, many prefixes have been used or proposed by various sources, but only a narrow set has been recognised by standards organisations. Metric prefixes The prefixes of the metric system precede a basic unit of measure to indicate a decimal, decadic multiple (mathematics), multiple and fraction (mathematics), fraction of a unit. Each prefix has a unique symbol that is prepended to the unit symbol. Some of the prefixes date back to the introduction of the metric system in the 1790s, but new p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Kibibyte
The byte is a unit of digital information that most commonly consists of eight bits. Historically, the byte was the number of bits used to encode a single character of text in a computer and for this reason it is the smallest addressable unit of memory in many computer architectures. To disambiguate arbitrarily sized bytes from the common 8-bit definition, network protocol documents such as The Internet Protocol () refer to an 8-bit byte as an octet. Those bits in an octet are usually counted with numbering from 0 to 7 or 7 to 0 depending on the bit endianness. The first bit is number 0, making the eighth bit number 7. The size of the byte has historically been hardware-dependent and no definitive standards existed that mandated the size. Sizes from 1 to 48 bits have been used. The six-bit character code was an often-used implementation in early encoding systems, and computers using six-bit and nine-bit bytes were common in the 1960s. These systems often had memory words ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Address Line
In computer architecture, a bus (shortened form of the Latin '' omnibus'', and historically also called data highway or databus) is a communication system that transfers data between components inside a computer, or between computers. This expression covers all related hardware components (wire, optical fiber, etc.) and software, including communication protocols. Early computer buses were parallel electrical wires with multiple hardware connections, but the term is now used for any physical arrangement that provides the same logical function as a parallel electrical busbar. Modern computer buses can use both parallel and bit serial connections, and can be wired in either a multidrop (electrical parallel) or daisy chain topology, or connected by switched hubs, as in the case of Universal Serial Bus (USB). Background and nomenclature Computer systems generally consist of three main parts: * The central processing unit (CPU) that processes data, * The memory that holds the p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IBM 702
The IBM 702 was an early generation tube-based digital computer produced by IBM in the early to mid-1950s. It was the company's response to Remington Rand's UNIVAC—the first mainframe computer to use magnetic tapes. As these machines were aimed at the business market, they lacked the leading-edge computational power of the IBM 701 and ERA 1103, which were favored for scientific computing, weather forecasting, the aircraft industry, and the military and intelligence communities. Within IBM, the 702 was notable for adapting the new technology of magnetic-core memory for random-access applications. The 702 was announced September 25, 1953, and withdrawn October 1, 1954, but the first production model was not installed until July 1955. It was superseded by the IBM 705. History Fourteen 702s were built. The first one was used at IBM. Due to problems with the Williams tubes, the decision was made to switch to magnetic-core memory instead. The fourteenth 702 was built using ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Word (data Type)
In computing, a word is the natural unit of data used by a particular processor design. A word is a fixed-sized datum handled as a unit by the instruction set or the hardware of the processor. The number of bits or digits in a word (the ''word size'', ''word width'', or ''word length'') is an important characteristic of any specific processor design or computer architecture. The size of a word is reflected in many aspects of a computer's structure and operation; the majority of the registers in a processor are usually word-sized and the largest datum that can be transferred to and from the working memory in a single operation is a word in many (not all) architectures. The largest possible address size, used to designate a location in memory, is typically a hardware word (here, "hardware word" means the full-sized natural word of the processor, as opposed to any other definition used). Documentation for older computers with fixed word size commonly states memory sizes in words ra ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IBM 701
The IBM 701 Electronic Data Processing Machine, known as the Defense Calculator while in development, was IBM’s first commercial scientific computer and its first series production mainframe computer, which was announced to the public on May 21, 1952. It was invented and developed by Jerrier Haddad and Nathaniel Rochester based on the IAS machine at Princeton. The IBM 701 was the first computer in the IBM 700/7000 series, which were IBM’s high-end computers until the arrival of the IBM System/360 in 1964. The business-oriented sibling of the 701 was the IBM 702 and a lower-cost general-purpose sibling was the IBM 650, which gained fame as the first mass-produced computer in the world. History IBM 701 competed with Remington Rand's UNIVAC 1103 in the scientific computation market, which had been developed for the NSA, so it was held secret until permission to market it was obtained in 1951. In early 1954, a committee of the Joint Chiefs of Staff requested that the two ma ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Conférence Générale Des Poids Et Mesures
The General Conference on Weights and Measures (GCWM; french: Conférence générale des poids et mesures, CGPM) is the supreme authority of the International Bureau of Weights and Measures (BIPM), the intergovernmental organization established in 1875 under the terms of the Metre Convention through which member states act together on matters related to measurement science and measurement standards. The CGPM is made up of delegates of the governments of the member states and observers from the Associates of the CGPM. Under its authority, the International Committee for Weights and Measures (ICWM; ) executes an exclusive direction and supervision of the BIPM. Initially the Metre Convention was only concerned with the kilogram and the metre, but in 1921 the scope of the treaty was extended to accommodate all physical measurements and hence all aspects of the metric system. In 1960 the 11th CGPM approved the International System of Units, usually known as "SI". The General Confer ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Germinal (month)
Germinal () was the seventh month in the French Republican Calendar. The month was named after the Latin word ''germen'', "germination". Germinal was the first month of the spring quarter (''mois de printemps''). It started March 21 or March 22, and ended April 19 or April 20. It follows Ventôse and precedes Floréal. In the context of the French Revolution, ''Germinal'' sometimes refers to the downfall and execution of the Indulgents, Georges Danton and Camille Desmoulins, which took place during Germinal of 1794, four months before the Thermidorian Reaction in which Robespierre himself was executed. The events of Germinal 1794 signaled the beginning of the end of the Reign of Terror. Day name table Like all FRC months, Germinal lasted 30 days and was divided into three 10-day weeks called ''décades'' (decades). Every day had the name of an agricultural plant, except the 5th (Quintidi) and 10th day (Decadi) of every decade, which had the name of a domestic animal (Qui ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Demi (metric Prefix)
A metric prefix is a unit prefix that precedes a basic unit of measure to indicate a multiple or submultiple of the unit. All metric prefixes used today are decadic. Each prefix has a unique symbol that is prepended to any unit symbol. The prefix ''kilo-'', for example, may be added to ''gram'' to indicate ''multiplication'' by one thousand: one kilogram is equal to one thousand grams. The prefix '' milli-'', likewise, may be added to ''metre'' to indicate ''division'' by one thousand; one millimetre is equal to one thousandth of a metre. Decimal multiplicative prefixes have been a feature of all forms of the metric system, with six of these dating back to the system's introduction in the 1790s. Metric prefixes have also been used with some non-metric units. The SI prefixes are metric prefixes that were standardised for use in the International System of Units (SI) by the International Bureau of Weights and Measures (BIPM) in resolutions dating from 1960 to 2022. Since 2009, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Double (metric Prefix)
A metric prefix is a unit prefix that precedes a basic unit of measure to indicate a multiple or submultiple of the unit. All metric prefixes used today are decadic. Each prefix has a unique symbol that is prepended to any unit symbol. The prefix ''kilo-'', for example, may be added to ''gram'' to indicate ''multiplication'' by one thousand: one kilogram is equal to one thousand grams. The prefix ''milli-'', likewise, may be added to ''metre'' to indicate ''division'' by one thousand; one millimetre is equal to one thousandth of a metre. Decimal multiplicative prefixes have been a feature of all forms of the metric system, with six of these dating back to the system's introduction in the 1790s. Metric prefixes have also been used with some non-metric units. The SI prefixes are metric prefixes that were standardised for use in the International System of Units (SI) by the International Bureau of Weights and Measures (BIPM) in resolutions dating from 1960 to 2022. Since 2009, the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Metric System
The metric system is a system of measurement that succeeded the Decimal, decimalised system based on the metre that had been introduced in French Revolution, France in the 1790s. The historical development of these systems culminated in the definition of the International System of Units (SI) in the mid-20th century, under the oversight of an international standards body. Adopting the metric system is known as ''metrication''. The historical evolution of metric systems has resulted in the recognition of several principles. Each of the fundamental dimensions of nature is expressed by a single base unit (measurement), base unit of measure. The definition of base units has increasingly been realisation (metrology), realised from natural principles, rather than by copies of physical artefacts. For quantities derived from the fundamental base units of the system, units SI derived unit, derived from the base units are used—e.g., the square metre is the derived unit for area, a qu ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
United States District Court For The Northern District Of California
The United States District Court for the Northern District of California (in case citations, N.D. Cal.) is the federal United States district court whose jurisdiction comprises the following counties of California: Alameda, Contra Costa, Del Norte, Humboldt, Lake, Marin, Mendocino, Monterey, Napa, San Benito, San Francisco, San Mateo, Santa Clara, Santa Cruz, and Sonoma. The court hears cases in its courtrooms in Eureka, Oakland, San Francisco, and San Jose. It is headquartered in San Francisco. Cases from the Northern District of California are appealed to the United States Court of Appeals for the Ninth Circuit (except for patent claims and claims against the U.S. government under the Tucker Act, which are appealed to the Federal Circuit). Because it covers San Francisco and Silicon Valley, the Northern District of California has become known as the presumptive destination for major federal lawsuits (such as large class actions and multi-district litigation) involv ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
