|
Listed Buildings In Sutton Upon Tern
Sutton upon Tern is a civil parish in Shropshire, England. It contains 24 listed buildings that are recorded in the National Heritage List for England. Of these, four are listed at Grade II*, the middle of the three grades, and the others are at Grade II, the lowest grade. The parish contains the village of Sutton upon Tern and is otherwise largely rural. The Shropshire Union Canal passes through the parish, and the listed buildings associated with it are two bridges and a milepost. In the parish are the country houses Buntingsdale Hall Buntingsdale Hall is a historic country house in the parish of Sutton upon Tern, to the southwest of Market Drayton in Shropshire, England. It became a Grade II* listed building on 14 February 1979. History Buntingsdale Hall was first built for ... and Pell Wall, and another large house, Colehurst Manor, which are listed together with associated structures. The other listed buildings are farmhouses, farm buildings, a road brid ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sutton Upon Tern
Sutton upon Tern is a civil parish in Shropshire, England. Expanded in 1914 after the abolition of the parish Drayton in Hales, Its name in Old English means 'South farm/settlement' on the River Tern. It is situated south of Market Drayton, on the River Tern. About In the 2011 census it had a population of 1,232, the majority of them between the ages of 35–55. A description of Sutton upon Tern was written in the early 1870s: :"SUTTON, a township in Drayton-in-Hales parish, Salop; 1 mile SSW of Market-Drayton. Pop lation, 177" It is unusual in that a small area of the parish, at Ternhill, is almost an exclave of the parish (only a 5m wide strip of land joins it with the bulk of the parish). Located north-west within the parish, is Service Family Accommodation for nearby Clive Barracks. The housing estates are not "behind the wire" and consist of two areas; Buntingsdale Park (mainly Officer's housing) and Buntingsdale Estate for other ranks. There is a local Primary School ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Slate
Slate is a fine-grained, foliated, homogeneous metamorphic rock derived from an original shale-type sedimentary rock composed of clay or volcanic ash through low-grade regional metamorphism. It is the finest grained foliated metamorphic rock. Foliation may not correspond to the original sedimentary layering, but instead is in planes perpendicular to the direction of metamorphic compression. The foliation in slate is called "slaty cleavage". It is caused by strong compression causing fine grained clay flakes to regrow in planes perpendicular to the compression. When expertly "cut" by striking parallel to the foliation, with a specialized tool in the quarry, many slates will display a property called fissility, forming smooth flat sheets of stone which have long been used for roofing, floor tiles, and other purposes. Slate is frequently grey in color, especially when seen, en masse, covering roofs. However, slate occurs in a variety of colors even from a single locality; for ex ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Entablature
An entablature (; nativization of Italian , from "in" and "table") is the superstructure of moldings and bands which lies horizontally above columns, resting on their capitals. Entablatures are major elements of classical architecture, and are commonly divided into the architrave (the supporting member immediately above; equivalent to the lintel in post and lintel construction), the frieze (an unmolded strip that may or may not be ornamented), and the cornice (the projecting member below the pediment). The Greek and Roman temples are believed to be based on wooden structures, the design transition from wooden to stone structures being called petrification. Overview The structure of an entablature varies with the orders of architecture. In each order, the proportions of the subdivisions (architrave, frieze, cornice) are defined by the proportions of the column. In Roman and Renaissance interpretations, it is usually approximately a quarter of the height of the column. Varian ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Fluting (architecture)
Fluting in architecture consists of shallow grooves running along a surface. The term typically refers to the grooves (flutes) running vertically on a column shaft or a pilaster, but need not necessarily be restricted to those two applications. If the hollowing out of material meets in a point, the point (sharp ridge) is called an arris. If the raised ridge between two flutes is blunt, the ridge is a . Purpose Fluting promotes a play of light on a column which helps the column appear more perfectly round than a smooth column. As a strong vertical element it also has the visual effect of minimizing any horizontal joints. Greek architects viewed rhythm as an important design element. As such, fluting was often used on buildings and temples to increase the sense of rhythm. It may also be incorporated in columns to make them look thinner, lighter, and more elegant. There is debate as to whether fluting was originally used in imitation of ancient woodworking practices, mimicking ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Capital (architecture)
In architecture the capital (from the Latin ''caput'', or "head") or chapiter forms the topmost member of a column (or a pilaster). It mediates between the column and the load thrusting down upon it, broadening the area of the column's supporting surface. The capital, projecting on each side as it rises to support the abacus, joins the usually square abacus and the usually circular shaft of the column. The capital may be convex, as in the Doric order; concave, as in the inverted bell of the Corinthian order; or scrolling out, as in the Ionic order. These form the three principal types on which all capitals in the classical tradition are based. The Composite order established in the 16th century on a hint from the Arch of Titus, adds Ionic volutes to Corinthian acanthus leaves. From the highly visible position it occupies in all colonnaded monumental buildings, the capital is often selected for ornamentation; and is often the clearest indicator of the architectural orde ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Composite Order
The Composite order is a mixed order, combining the volutes of the Ionic order capital with the acanthus leaves of the Corinthian order.Henig, Martin (ed.), ''A Handbook of Roman Art'', p. 50, Phaidon, 1983, In many versions the composite order volutes are larger, however, and there is generally some ornament placed centrally between the volutes. The column of the composite order is typically ten diameters high, though as with all the orders these details may be adjusted by the architect for particular buildings. The Composite order is essentially treated as Corinthian except for the capital, with no consistent differences to that above or below the capital. The Composite order is not found in ancient Greek architecture and until the Renaissance was not ranked as a separate order. Instead it was considered as an imperial Roman form of the Corinthian order. Though the Arch of Titus, in the forum in Rome and built in 82 AD, is sometimes cited as the first prominent survivin ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pilaster
In classical architecture Classical architecture usually denotes architecture which is more or less consciously derived from the principles of Greek and Roman architecture of classical antiquity, or sometimes even more specifically, from the works of the Roman architect V ..., a pilaster is an :Architectural elements, architectural element used to give the appearance of a supporting column and to articulate an extent of wall, with only an ornamental function. It consists of a flat surface raised from the main wall surface, usually treated as though it were a column, with a Capital (architecture), capital at the top, plinth (base) at the bottom, and the various other column elements. In contrast to a pilaster, an engaged column or buttress can support the structure of a wall and roof above. In human anatomy, a pilaster is a ridge that extends vertically across the femur, which is unique to modern humans. Its structural function is unclear. Definition In discussing Leon Battis ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Samuel Pountney Smith
Samuel Pountney Smith JP (2 November 1812Obituary. Date stated to be his birthday. – 5 November 1883) was an English architect who practised in Shrewsbury, Shropshire, England. Smith was a native of Munslow, where he was baptised on 17 December 1812, Baptism register transcription in Corvedale, Shropshire, son of an innkeeper, Edward Smith and his wife Anne. He learned the trades of builder and architect with his uncle John Smalman Obituary. at Quatford near Bridgnorth, and came to Shrewsbury in about 1840 after working in the latter's business. The National Heritage List for England shows that his major works were mainly in Shropshire, with occasional works in the neighbouring county of Herefordshire. He also carried out some works nearby in North Wales. An example of his Welsh work is St Collen’s Church, Llangollen. According to the authors of the ''Buildings of England'' series, his work was strongly influenced by A. W. N. Pugin, and his designs we ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Dormer
A dormer is a roofed structure, often containing a window, that projects vertically beyond the plane of a pitched roof. A dormer window (also called ''dormer'') is a form of roof window. Dormers are commonly used to increase the usable space in a loft and to create window openings in a roof plane. A dormer is often one of the primary elements of a loft conversion. As a prominent element of many buildings, different types of dormer have evolved to complement different styles of architecture. When the structure appears on the spires of churches and cathedrals, it is usually referred to as a ''lucarne''. History The word ''dormer'' is derived from the Middle French , meaning "sleeping room", as dormer windows often provided light and space to attic-level bedrooms. One of the earliest uses of dormers was in the form of lucarnes, slender dormers which provided ventilation to the spires of English Gothic churches and cathedrals. An early example are the lucarnes of the spire of C ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Transom (architecture)
In architecture, a transom is a transverse horizontal structural beam or bar, or a crosspiece separating a door from a window above it. This contrasts with a mullion, a vertical structural member. Transom or transom window is also the customary U.S. word used for a transom light, the window over this crosspiece. In Britain, the transom light is usually referred to as a fanlight, often with a semi-circular shape, especially when the window is segmented like the slats of a folding hand fan. A prominent example of this is at the main entrance of 10 Downing Street, the official residence of the British prime minister. History In early Gothic ecclesiastical work, transoms are found only in belfry unglazed windows or spire lights, where they were deemed necessary to strengthen the mullions in the absence of the iron stay bars, which in glazed windows served a similar purpose. In the later Gothic, and more especially the Perpendicular Period, the introduction of transoms became common i ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Mullion
A mullion is a vertical element that forms a division between units of a window or screen, or is used decoratively. It is also often used as a division between double doors. When dividing adjacent window units its primary purpose is a rigid support to the glazing of the window. Its secondary purpose is to provide structural support to an arch or lintel above the window opening. Horizontal elements separating the head of a door from a window above are called transoms. History Stone mullions were used in Armenian, Saxon and Islamic architecture prior to the 10th century. They became a common and fashionable architectural feature across Europe in Romanesque architecture, with paired windows divided by a mullion, set beneath a single arch. The same structural form was used for open arcades as well as windows, and is found in galleries and cloisters. In Gothic architecture windows became larger and arrangements of multiple mullions and openings were used, both for structure and ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bressumer
A bressummer, breastsummer, summer beam (somier, sommier, sommer, somer, cross-somer, summer, summier, summer-tree, or dorman, dormant tree) is a load-bearing beam in a timber-framed building. The word ''summer'' derived from sumpter or French sommier, "a pack horse", meaning "bearing great burden or weight". "To support a superincumbent wall", "any beast of burden", and in this way is similar to a wall plate. The use and definition of these terms vary but generally a bressummer is a jetty sill and a summer is an interior beam supporting ceiling joists, see below: * (UK) In the outward part of the building, and the middle floors (not in the garrets or ground floors) into which the girders are framed. In the inner parts of a building, such beams are called "summers". It is part of the timber-frame construction in the overhanging upper story in jettying. * (UK) "Horizontal beam over a fireplace opening (alternatively ''lintel'', mantel beam), or set forward from the lower part o ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
.jpg "Click for more on -> Transom (architecture)")
