|
Frame Synchronization
In telecommunications, frame synchronization or framing is the process by which, while receiving a stream of fixed-length frames, the receiver identifies the frame boundaries, permitting the data bits within the frame to be extracted for decoding or retransmission. When packets of varying length are sent, it is necessary to have an instantly recognizable packet-end delimiter (e.g., Ethernet's end of stream symbol). Loss of carrier signal can be interpreted as a packet-end delimiter in some cases. When a continuous stream of fixed-length frames are sent, a synchronized receiver can in principle identify frame boundaries forever. In practice, receivers can usually maintain synchronization despite transmission errors; bit slips are much rarer than bit errors. Thus, it is acceptable to use a much smaller frame boundary marker, at the expense of a lengthier process to establish synchronization in the first place. Frame synchronization is achieved when the incoming frame alignme ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Telecommunications
Telecommunication, often used in its plural form or abbreviated as telecom, is the transmission of information over a distance using electronic means, typically through cables, radio waves, or other communication technologies. These means of transmission may be divided into communication channels for multiplexing, allowing for a single medium to transmit several concurrent Session (computer science), communication sessions. Long-distance technologies invented during the 20th and 21st centuries generally use electric power, and include the electrical telegraph, telegraph, telephone, television, and radio. Early telecommunication networks used metal wires as the medium for transmitting signals. These networks were used for telegraphy and telephony for many decades. In the first decade of the 20th century, a revolution in wireless communication began with breakthroughs including those made in radio communications by Guglielmo Marconi, who won the 1909 Nobel Prize in Physics. Othe ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
CRC-based Framing
CRC-based framing is a kind of frame synchronization used in Asynchronous Transfer Mode (ATM) and other similar protocols. The concept of CRC-based framing was developed by StrataCom, Inc. in order to improve the efficiency of a pre-standard Asynchronous Transfer Mode (ATM) link protocol. This technology was ultimately used in the principal link protocols of ATM itself and was one of the most significant developments of StrataCom. An advanced version of CRC-based framing was used in the ITU-T SG15 G.7041 Generic Framing Procedure (GFP), which itself is used in several packet link protocols. Overview of CRC-based framing The method of CRC-Based framing re-uses the header cyclic redundancy check (CRC), which is present in ATM and other similar protocols, to provide framing on the link with no additional overhead. In ATM, this field is known as the Header Error Control/Check (HEC) field. It consists of the remainder of the division of the 32 bits of the header (taken as the coeffici ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Superframe
In telecommunications, superframe (SF) is a T1 framing standard. In the 1970s it replaced the original T1/D1 framing scheme of the 1960s in which the framing bit simply alternated between 0 and 1. Superframe is sometimes called D4 Framing to avoid confusion with single-frequency signaling. It was first supported by the D2 channel bank, but it was first widely deployed with the D4 channel bank. In order to determine where each channel is located in the stream of data being received, each set of 24 channels is aligned in a frame. The frame is 192 bits long (8 * 24), and is terminated with a 193rd bit, the framing bit, which is used to find the end of the frame. In order for the framing bit to be located by receiving equipment, a predictable pattern is sent on this bit. Equipment will search for a bit which has the correct pattern, and will align its framing based on that bit. The pattern sent is 12 bits long, so every group of 12 frames is called a superframe. The patter ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Self-synchronizing Code
In coding theory, especially in telecommunications, a self-synchronizing code is a uniquely decodable code in which the symbol stream formed by a portion of one code word, or by the overlapped portion of any two adjacent code words, is not a valid code word. Put another way, a set of strings (called "code words") over an alphabet is called a self-synchronizing code if for each string obtained by concatenating two code words, the substring starting at the second symbol and ending at the second-last symbol does not contain any code word as substring. Every self-synchronizing code is a prefix code, but not all prefix codes are self-synchronizing. Other terms for self-synchronizing code are synchronized code or, ambiguously, comma-free code. A self-synchronizing code permits the proper framing of transmitted code words provided that no uncorrected errors occur in the symbol stream; external synchronization is not required. Self-synchronizing codes also allow recovery from uncor ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Phase Synchronization
{{no footnotes, date=June 2017 Phase synchronization is the process by which two or more cyclic signals tend to oscillate with a repeating sequence of relative phase angles. Phase synchronisation is usually applied to two waveforms of the same frequency with identical phase angles with each cycle. However it can be applied if there is an integer relationship of frequency, such that the cyclic signals share a repeating sequence of phase angles over consecutive cycles. These integer relationships are called Arnold tongues which follow from bifurcation of the circle map. One example of phase synchronization of multiple oscillators can be seen in the behavior of Southeast Asian fireflies. At dusk, the flies begin to flash periodically with random phases and a gaussian distribution of native frequencies. As night falls, the flies, sensitive to one another's behavior, begin to synchronize their flashing. After some time all the fireflies within a given tree (or even larger area) will ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Asynchronous Start-stop
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Synchronization (clock recovery) is done by data-embedded signal: the data stream contains synchronization information in a form of start and stop signals set before and after each payload transmission. The start signal prepares the receiver for arrival of data and the stop signal resets its state to enable triggering of a new sequence. A common kind of start-stop transmission is ASCII over RS-232, for example for use in teletypewriter operation. Origin Mechanical teleprinters using 5-bit codes (see Baudot code) typically used a stop period of 1.5 bit times.Dead link: 2015-Oct-03 Very early electromechanical teletypewriters (pre-1930) could require 2 stop bits to allow mechanical impression without buffering. Hardware which does not support fractional stop bits can communicate with a device that uses ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Commutation
Commute, commutation or commutative may refer to: * Commuting, the process of travelling between a place of residence and a place of work Mathematics * Commutative property, a property of a mathematical operation whose result is insensitive to the order of its arguments **Equivariant map, a function whose composition with another function has the commutative property **Commutative diagram, a graphical description of commuting compositions of arrows in a mathematical category **Commutative semigroup, commutative monoid, abelian group, and commutative ring, algebraic structures with the commutative property **Commuting matrices, sets of matrices whose products do not depend on the order of multiplication **Commutator, a measure of the failure of two elements to be commutative in a group or ring * Commutation matrix, a permutation matrix which is used for transforming the vectorized form of another matrix into the vectorized form of its transpose Science and technology * Commutator ( ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
LSI Logic Corporation
LSI Logic Corporation was an American company founded in Santa Clara, California, was a pioneer in the ASIC and EDA industries. It evolved over time to design and sell semiconductors and software that accelerated storage and networking in data centers, mobile networks and client computing. In April 2007, LSI Logic merged with Agere Systems and rebranded the firm as LSI Corporation. On May 6, 2014, LSI Corporation was acquired by Avago Technologies (now known as Broadcom Inc.) for $6.6 billion. History 1981–2004 LSI Logic Corporation was incorporated in November 1980 by Wilfred J. Corrigan and began operating in early 1981 using leased facilities in Santa Clara, California. The name "LSI" referred to Large Scale Integration. Corrigan recruited co-founders Bill O'Meara (VP Marketing and Sales), Rob Walker (VP Engineering) and Mitchell "Mick" Bohn (CFO) as co-founders. Initial funding of $6 million came from a consortium of venture capitalists, including Kleiner Perkins ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Decommutation
In telemetry, commutation is a process whereby multiple data streams ("measurands"), possibly with differing data rates, are combined into a single frame-based stream for transmission, before being separated again (decommutated) upon reception; it is a form of time-division multiplexing. Frame synchronization must be achieved before a data stream can be decommutated. Etymology Commutation is named by analogy with electric commutators, which engage multiple electrical contacts in sequence as they rotate; similarly, telemetry commutation involves sampling a sequence of data sources in turn, before returning to the first data source. Hardware or software which performs commutation is referred to as a commutator; its opposite at the receiving end is a decommutator. Dedicated hardware generally supports faster commutation and decommutation than software on a general purpose architecture. Mechanism A set of data words, together with synchronization and ID or counter words, consti ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse-code Modulated
Pulse-code modulation (PCM) is a method used to digitally represent analog signals. It is the standard form of digital audio in computers, compact discs, digital telephony and other digital audio applications. In a PCM stream, the amplitude of the analog signal is sampled at uniform intervals, and each sample is quantized to the nearest value within a range of digital steps. Alec Reeves, Claude Shannon, Barney Oliver and John R. Pierce are credited with its invention. Linear pulse-code modulation (LPCM) is a specific type of PCM in which the quantization levels are linearly uniform. This is in contrast to PCM encodings in which quantization levels vary as a function of amplitude (as with the A-law algorithm or the μ-law algorithm). Though ''PCM'' is a more general term, it is often used to describe data encoded as LPCM. A PCM stream has two basic properties that determine the stream's fidelity to the original analog signal: the sampling rate, which is the number of times p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Telemetry
Telemetry is the in situ collection of measurements or other data at remote points and their automatic transmission to receiving equipment (telecommunication) for monitoring. The word is derived from the Greek roots ''tele'', 'far off', and ''metron'', 'measure'. Systems that need external instructions and data to operate require the counterpart of telemetry: telecommand. Although the term commonly refers to wireless data transfer mechanisms (e.g., using radio, ultrasonic, or infrared systems), it also encompasses data transferred over other media such as a telephone or computer network, optical link or other wired communications like power line carriers. Many modern telemetry systems take advantage of the low cost and ubiquity of GSM networks by using SMS to receive and transmit telemetry data. A ''telemeter'' is a physical device used in telemetry. It consists of a sensor, a transmission path, and a display, recording, or control device. Electronic devices are widely u ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
PCM Stream
Pulse-code modulation (PCM) is a method used to digitally represent analog signals. It is the standard form of digital audio in computers, compact discs, digital telephony and other digital audio applications. In a PCM stream, the amplitude of the analog signal is sampled at uniform intervals, and each sample is quantized to the nearest value within a range of digital steps. Alec Reeves, Claude Shannon, Barney Oliver and John R. Pierce are credited with its invention. Linear pulse-code modulation (LPCM) is a specific type of PCM in which the quantization levels are linearly uniform. This is in contrast to PCM encodings in which quantization levels vary as a function of amplitude (as with the A-law algorithm or the μ-law algorithm). Though ''PCM'' is a more general term, it is often used to describe data encoded as LPCM. A PCM stream has two basic properties that determine the stream's fidelity to the original analog signal: the sampling rate, which is the number of times p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
