|
EMD DD35A
The EMD DD35A, also known as the EMD DDA35, was a diesel-electric locomotive of D-D wheel arrangement built by General Motors Electro-Motive Division exclusively for the Union Pacific Railroad. They were a cab-equipped variant of the previous, cabless booster (B unit) EMD DD35 (sometimes erroneously called the 'DD35B'). Fifteen DD35A locomotives were built between May and July 1965; they were assigned road numbers 70 through 84. This request also led to the introduction of the ALCO Century 855 and GE U50. A further development of the 8 axle, twin-engined locomotive produced the final, best known type, the DDA40X "Centennial". History Like its cabless predecessor, the DD35A was essentially two EMD GP35 locomotives on a common frame, riding on a pair of 4-axle Flexicoil trucks. The cab of a GP35 was fitted to the front end, requiring a longer frame than the DD35; the fuel tank beneath was lengthened, and the center pass-through walkway was offset a little to the rear because of th ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
GE U50
The GE U50 was an eight-axle, diesel-electric locomotive built by GE Rail. They were twin-engined locomotives, combining two diesel engines. Configuration The U50 rode on four two-axle trucks, grouped in pairs linked by span bolsters, giving a wheel arrangement of B+B-B+B. The trucks and bolsters were re-used from scrapped UP turbine locomotives built by GE during the 1950s. The U50 is sometimes inaccurately referred to as the U50D, a back-formation from the U50C name given to the six-axle units. The name is incorrect and was never used by the manufacturer or the railroad. The U50 did not ride on D trucks in any case. It is also sometimes referred to as the U50B, but this is incorrect as well. The U50 was built in response to the Union Pacific Railroad's requirement, issued in the early 1960s, for a 3-unit locomotive intended to replace the turbines. The design was effectively two U25B locomotives on a single frame; each diesel engine and generator powered only the tw ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
GE U50C
The GE U50C was a diesel-electric locomotive built by GE Transportation Systems. Each was powered by two diesel engines. History Forty were built between November 1969 and November 1971 solely for Union Pacific, which numbered them 5000 to 5039. The U50C used a pair of three-axle trucks instead of the four two-axle trucks used on the earlier U50. Again, these were reused trucks, this time from the later, GE turbine locomotives. Development of the U50C was to the same UP specification that produced the EMD DDA40X "Centennial" units—a requirement for a high power locomotive for the railroad's high-speed freight trains. The span-bolster B+B-B+B design was not suited to this service, and the requirement for power at speed rather than low-speed hauling meant six powered axles would be sufficient. The design incorporated extensive weight saving features. GE replaced the 16-cylinder prime movers of the U50 with advanced 12-cylinder engines, lighter and shorter. The engines wer ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
EMD DDM45
The EMD DDM45 is a Metre-gauge railway, meter-gauge Diesel-electric transmission, diesel-electric locomotive built by Electro-Motive Diesel, EMD. The DD in the name means that it has eight axles in two trucks, giving it a AAR wheel arrangement#D-D wheel arrangement, while the M stands for the meter-gauge track it was to operate on, and the 45 represents the EMD SD45 that the engine was derived from. They were built for service on the Estrada de Ferro Vitória a Minas (EFVM) in Brazil. In the early 1970s, the EFVM needed not only to expand its locomotive roster, but to use the most powerful single-engined locomotives available, and the EMD SD45, SD45 represented the highest-rated model that EMD had to offer at the time. However, a large locomotive like an SD45 with its three-axle trucks was not readily adaptable to the EFVM's meter gauge trackage. The smaller traction motors of the meter gauge locomotive were unable to handle the full current capacity from the prime mover. EMD pro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Utah
Utah ( , ) is a state in the Mountain West subregion of the Western United States. Utah is a landlocked U.S. state bordered to its east by Colorado, to its northeast by Wyoming, to its north by Idaho, to its south by Arizona, and to its west by Nevada. Utah also touches a corner of New Mexico in the southeast. Of the fifty U.S. states, Utah is the 13th-largest by area; with a population over three million, it is the 30th-most-populous and 11th-least-densely populated. Urban development is mostly concentrated in two areas: the Wasatch Front in the north-central part of the state, which is home to roughly two-thirds of the population and includes the capital city, Salt Lake City; and Washington County in the southwest, with more than 180,000 residents. Most of the western half of Utah lies in the Great Basin. Utah has been inhabited for thousands of years by various indigenous groups such as the ancient Puebloans, Navajo and Ute. The Spanish were the first Europe ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Salt Lake City
Salt Lake City (often shortened to Salt Lake and abbreviated as SLC) is the Capital (political), capital and List of cities and towns in Utah, most populous city of Utah, United States. It is the county seat, seat of Salt Lake County, Utah, Salt Lake County, the most populous county in Utah. With a population of 200,133 in 2020, the city is the core of the Salt Lake City metropolitan area, which had a population of 1,257,936 at the 2020 census. Salt Lake City is further situated within a larger metropolis known as the Salt Lake City–Provo–Orem Combined Statistical Area, Salt Lake City–Ogden–Provo Combined Statistical Area, a corridor of contiguous urban and suburban development stretched along a segment of the Wasatch Front, comprising a population of 2,746,164 (as of 2021 estimates), making it the 22nd largest in the nation. It is also the central core of the larger of only two major urban areas located within the Great Basin (the other being Reno, Nevada). Salt Lake C ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Teething Troubles
Teething is the process by which an infant's first teeth (the deciduous teeth, often called "baby teeth" or "milk teeth") appear by emerging through the gums, typically arriving in pairs. The mandibular central incisors are the first primary teeth to erupt, usually between 6 and 10 months of age and usually causes discomfort and pain to the infant. It can take several years for all 20 teeth to complete the tooth eruption. Though the process of teething is sometimes referred to as "cutting teeth", when teeth emerge through the gums they do not cut through the flesh. Instead, hormones are released within the body that cause some cells in the gums to die and separate, allowing the teeth to come through. Teething may cause a slightly elevated temperature, but not rising into the fever range of greater than . Higher temperatures during teething are due to some form of infection, such as a herpes virus, initial infection of which is extremely widespread among children of teething ag ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
EMD SD40
The EMD SD40 is an American 6-axle diesel-electric locomotive built by General Motors Electro-Motive Division between January 1966 and August 1972. 1,268 locomotives were built between 1966 and 1972. In 1972, an improved version with new electronics was developed and marketed as a new locomotive, the SD40-2. Design Like its predecessor in EMD's catalog, the SD35, the SD40 is a high-horsepower, six-axle freight locomotive. The SD40 is a member of EMD's long-running Special Duty class of locomotives, which all are built with 6 axles. In 1966, EMD updated its locomotive catalog with entirely new models, all powered by the new 645 diesel engine. These included six-axle models SD38, SD40, SDP40 and SD45. All shared standardized components, including the frame, cab, generator, trucks, traction motors, and air brakes. The primary difference was the power output: SD38 = from a non-turbocharged V16, SD40 = from a turbocharged V16, and SD45 = from a turbocharged V20. Original ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
EMD 645
The EMD 645 is a family of diesel engines that was designed and manufactured by the Electro-Motive Division of General Motors. While the 645 series was intended primarily for locomotive, marine and stationary engine use, one 16-cylinder version powered the 33-19 "Titan" prototype haul truck designed by GM's Terex division. The 645 series was an evolution of the earlier 567 series and a precursor to the later 710 series. First introduced in 1965, the EMD 645 series remained in production on a by-request basis long after it was replaced by the 710, and most 645 service parts are still in production. The EMD 645 engine series is currently supported by Electro-Motive Diesel, Inc., which purchased the assets of the Electro-Motive Division from General Motors in 2005. In 1951, E. W. Kettering wrote a paper for the ASME entitled, ''History and Development of the 567 Series General Motors Locomotive Engine'', which goes into great detail about the technical obstacles that were enco ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bogie
A bogie ( ) (in some senses called a truck in North American English) is a chassis or framework that carries a wheelset, attached to a vehicle—a modular subassembly of wheels and axles. Bogies take various forms in various modes of transport. A bogie may remain normally attached (as on many railroad cars and semi-trailers) or be quickly detachable (as the dolly in a road train or in railway bogie exchange); it may contain a suspension within it (as most rail and trucking bogies do), or be solid and in turn be suspended (as most bogies of tracked vehicles are); it may be mounted on a swivel, as traditionally on a railway carriage or locomotive, additionally jointed and sprung (as in the landing gear of an airliner), or held in place by other means (centreless bogies). In Scotland, the term is used for a child’s (usually home-made) wooden cart. While ''bogie'' is the preferred spelling and first-listed variant in various dictionaries, bogey and bogy are also used. Rai ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Flexicoil
Flexicoil suspension is a type of secondary suspension for railway vehicles, typically having steel coil springs between the bogie trucks and chassis/frame of a passenger coach, goods freight wagon, or locomotive. Suspension systems using steel springs are more common than those with air springs, as steel springs are less costly to make, relatively wear resistant, and require less maintenance. History Flexicoil (though not known by this term) suspensions were fitted to locomotives in Spain, the Soviet Union and Africa Africa is the world's second-largest and second-most populous continent, after Asia in both cases. At about 30.3 million km2 (11.7 million square miles) including adjacent islands, it covers 6% of Earth's total surface area ... as early as the 1930s. In Germany, Flexicoil suspensions were first used in the 1950s under high-speed electric locomotives, notably the DB Class 103. British Rail Between 1969 and 1971, British Rail ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
