|
Porro Prism
In optics, a Porro prism, named for its inventor Ignazio Porro, is a type of ''reflection prism'' used in optical instruments to alter the orientation of an image. Description It consists of a block of material shaped like a right geometric prism with right-angled triangular end faces. In operation, light enters the large rectangular face of the prism, undergoes total internal reflection twice from the sloped faces, and exits again through the large rectangular face. When the light enters and therefore exits the glass at normal incidence, the prism is not dispersive. An image travelling through a Porro prism is rotated by 180° and exits in the opposite direction offset from its entry point. While a single Porro prism can be constructed to work as well as a roof prism, it is seldom used as such. Therefore, to reduce the cost of production for a Porro prism, the edge of the roof is usually left out. Sometimes only one small window as an entrance surface and one window as e ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Perger Prism
A Perger prism or Perger–Porro prism system is a prism, that is used to invert (rotate by 180°) an image. The special feature of this prism is that, like a traditional double Porro prism system, it manages this with only four beam deflections and has neither a roof edge with the accompanying phase correction problems, a mirrored surface or an air gap. However, in contrast to the traditional double Porro prism, it leads to a significantly reduced eyepiece/objective axis offset. The reduced beam offset allows for slimmer, more straight binocular housings usually found in roof prism binoculars. Complicating production requirements make high-quality roof prism binoculars relatively costly to produce compared to in optical quality equivalent Porro prism or "Perger–Porro prism system" binoculars. Dr. Andreas Perger patented the inversion system in 2011, and it was initially used in the Geovid HD laser rangefinding binoculars (2013 third generation) from the manufacturer Leica. Th ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Optical Telescope
An optical telescope gathers and focus (optics), focuses light mainly from the visible spectrum, visible part of the electromagnetic spectrum, to create a magnification, magnified image for direct visual inspection, to make a photograph, or to collect data through electronic image sensors. There are three primary types of optical telescope : * ''Refracting telescopes'', which use lens (optics), lenses and less commonly also Prism (optics), prisms (dioptrics) * ''Reflecting telescopes'', which use mirrors (catoptrics) * ''Catadioptric system#Catadioptric telescopes, Catadioptric telescopes'', which combine lenses and mirrors An optical telescope's ability to resolve small details is directly related to the diameter (or aperture) of its objective (optics), objective (the primary lens or mirror that collects and focuses the light), and its light-gathering power is related to the area of the objective. The larger the objective, the more light the telescope collects and the finer det ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Olympus E-300
The Olympus E-300 (Olympus Evolt E-300 in North America) is an 8-megapixel digital SLR manufactured by Olympus of Japan and based on the Four Thirds System. Announced at photokina 2004, it became available at the end of 2004. It was the second camera (after the Olympus E-1) to use the Four Thirds System, and the first intended for the consumer market. Features The camera's appearance was unique, as it lacked the ubiquitous SLR pentaprism "hump". Instead, a Porro prism system was used; it fitted sideways within the camera, with a sideways-swinging mirror, and located the viewfinder eyepiece to the left (seen from behind) relative to the lens centerline. The body was largely of ABS plastic over a metal frame; the lens mount was metal, and there was a metal covered area on the left top of the camera. This area also contained the onboard flash, which popped up and forward at the touch of a button. The onboard flash popup mechanism is manual. In low light scenarios the flash will n ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Olympus Pen F
The Olympus Pen F, Pen FT and Pen FV are very similar half-frame 35 mm single-lens reflex (SLR) cameras with interchangeable lenses produced by Olympus of Japan between 1963-1966 (Pen F), 1966-1972 (Pen FT) and 1967-1970 (Pen FV). The original Pen F has a double-stroke film advance and a distinctive logo rendered in a gothic font. The later Pen FT added a single-stroke film advance, and an uncoupled, integrated light meter, which uses a system of exposure numbers rather than f-stops. The exposure numbers were added to the aperture rings of later Pen F lenses; the rings could be pulled out and rotated to show conventional f-stops instead. A side-effect of the FT's light meter was a dimmer viewfinder. The Pen FV was essentially a Pen FT with the light meter deleted and the F's brighter viewfinder reinstated. ''Half frame'' means that the camera uses an 18×24 mm vertical (portrait A portrait is a painting, photograph, sculpture, or other artistic representation ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pentaprism
A pentaprism is a five-sided reflecting prism (optics), prism used to deviate a beam of light by a constant 90°, even if the entry beam is not at 90° to the prism. The beam reflects inside the prism ''twice'', allowing the transmission of an image through a right angle without inverting it (that is, without changing the image's Chirality (electromagnetism), handedness) as an ordinary right-angle prism or mirror would. The reflections inside the prism are not caused by total internal reflection, since the beams are incident at an angle less than the critical angle (optics), critical angle (the minimum angle for total internal reflection). Instead, the two faces are coated to provide mirror surfaces. The two opposite transmitting faces are often coated with an anti-reflective coating, antireflection coating to reduce spurious reflections. The fifth face of the prism is not used optically but truncates what would otherwise be an awkward angle joining the two mirrored faces. In c ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single Lens Reflex Camera
In photography, a single-lens reflex camera (SLR) is a type of camera that uses a mirror and prism system to allow photographers to view through the lens and see exactly what will be captured. SLRs became the dominant design for professional and consumer-level cameras throughout the late 20th century, offering interchangeable lenses, through-the-lens (TTL) metering, and precise framing. Originating in the 1930s and popularized in the 1960s and 70s, SLR technology played a crucial role in the evolution of modern photography. Although digital single-lens reflex (DSLR) cameras succeeded film-based models, the rise of mirrorless cameras in the 2010s has led to a decline in SLR use and production. With twin lens reflex and rangefinder cameras, the viewed image could be significantly different from the final image. When the shutter button is pressed on most SLRs, the mirror flips out of the light path and allows light to pass through to the light receptor and the image to be captured. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Binoculars
Binoculars or field glasses are two refracting telescopes mounted side-by-side and aligned to point in the same direction, allowing the viewer to use both eyes (binocular vision) when viewing distant objects. Most binoculars are sized to be held using both hands, although sizes vary widely from opera glasses to large pedestal-mounted military models. Unlike a (monocular) telescope, binoculars give users a stereopsis, three-dimensional image: each eyepiece presents a slightly different image to each of the viewer's eyes and the parallax allows the visual cortex to generate an depth perception, impression of depth. Optical design evolution Galilean Almost from the invention of the telescope in the 17th century the advantages of mounting two of them side by side for binocular vision seems to have been explored. Most early binoculars used Galilean telescope, Galilean optics; that is, they used a convex lens, convex objective (optics), objective and a concave lens, concave eyepi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Binoculars
Binoculars or field glasses are two refracting telescopes mounted side-by-side and aligned to point in the same direction, allowing the viewer to use both eyes (binocular vision) when viewing distant objects. Most binoculars are sized to be held using both hands, although sizes vary widely from opera glasses to large pedestal-mounted military models. Unlike a (monocular) telescope, binoculars give users a stereopsis, three-dimensional image: each eyepiece presents a slightly different image to each of the viewer's eyes and the parallax allows the visual cortex to generate an depth perception, impression of depth. Optical design evolution Galilean Almost from the invention of the telescope in the 17th century the advantages of mounting two of them side by side for binocular vision seems to have been explored. Most early binoculars used Galilean telescope, Galilean optics; that is, they used a convex lens, convex objective (optics), objective and a concave lens, concave eyepi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Chirality (mathematics)
In geometry, a figure is chiral (and said to have chirality) if it is not identical to its mirror image, or, more precisely, if it cannot be mapped to its mirror image by Rotation (mathematics), rotations and Translation (geometry), translations alone. An object that is not chiral is said to be ''achiral''. A chiral object and its mirror image are said to be enantiomorphs. The word ''chirality'' is derived from the Greek (cheir), the hand, the most familiar chiral object; the word ''enantiomorph'' stems from the Greek (enantios) 'opposite' + (morphe) 'form'. Examples Some chiral three-dimensional objects, such as the helix, can be assigned a right or left handedness, according to the right-hand rule. Many other familiar objects exhibit the same chiral symmetry of the human body, such as gloves and shoes. Right shoes differ from left shoes only by being mirror images of each other. In contrast thin gloves may not be considered chiral if you can wear them wiktionary:inside ou ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
