|
NSAP Address
A network service access point address (NSAP address), defined in ISO/IEC 8348, is an identifying label for a service access point (SAP) used in OSI model, OSI networking. These are roughly comparable to IP addresses used in the Internet Protocol; they can specify a piece of equipment connected to an Asynchronous Transfer Mode (ATM) network. A specific stream, analogous to a TCP/IP Computer port (software), port or Berkeley sockets, socket, is specified by using a transport service access point (TSAP). ATM can also use a presentation (PSAP) and session (SSAP) access point, but these may also be unspecified; this is up to the application. Allocation and scope NSAP addresses are allocated by the International Organization for Standardization (ISO), through a system of delegated authorities, which are generally national standards organizations. One of the schemes to generate NSAPs uses E.164 which is the addressing format describing telephone numbers. NSAP addresses do not specify ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Service Access Point
A Service Access Point (SAP) is an identifying label for network endpoints used in Open Systems Interconnection (OSI) networking. The SAP is a conceptual location at which one OSI layer can request the services of another OSI layer. As an example, PD-SAP or PLME-SAP in IEEE 802.15.4 can be mentioned, where the medium access control (MAC) layer requests certain services from the physical layer. Service access points are also used in IEEE 802.2 Logical Link Control in Ethernet and similar data link layer protocols. When using the OSI Network system (CONS or CLNS), the base for constructing an address for a network element is an NSAP address, similar in concept to an IP address. OSI protocols as well as Asynchronous Transfer Mode (ATM) can use Transport (TSAP), Session (SSAP) or Presentation (PSAP) Service Access Points to specify a destination address for a connection. These SAPs consist of NSAP addresses combined with optional transport, session and presentation selectors, whic ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Synchronous Digital Hierarchy
Synchronous Optical Networking (SONET) and Synchronous Digital Hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates, data can also be transferred via an electrical interface. The method was developed to replace the plesiochronous digital hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without the problems of synchronization. SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications, e.g. DS1, DS3, from a variety of different sources. However, they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
OSI Protocols
The Open Systems Interconnection protocols are a family of information exchange standards developed jointly by the International Organization for Standardization, ISO and the ITU-T. The standardization process began in 1977. While the seven-layer OSI model is often used as a reference for teaching and documentation, the protocols originally conceived for the model did not gain popularity, and only X.400, X.500, and IS-IS have achieved lasting impact. The goal of an open-standard protocol suite instead has been met by the Internet protocol suite, maintained by the Internet Engineering Task Force (IETF). Overview The OSI Communications protocols, protocol stack is structured into seven conceptual layers. The layers form a hierarchy of functionality starting with the physical hardware components to the user interfaces at the software application level. Each layer receives information from the layer above, processes it and passes it down to the next layer. Each layer adds encapsula ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Address Resolution Protocol
The Address Resolution Protocol (ARP) is a communication protocol for discovering the link layer address, such as a MAC address, associated with a internet layer address, typically an IPv4 address. The protocol, part of the Internet protocol suite, was defined in 1982 by , which is Internet Standard STD 37. ARP enables a host to send an IPv4 packet to another node in the local network by providing a protocol to get the MAC address associated with an IP address. The host broadcasts a request containing the node's IP address, and the node with that IP address replies with its MAC address. ARP has been implemented with many combinations of network and data link layer technologies, such as IPv4, Chaosnet, DECnet and Xerox PARC Universal Packet (PUP) using IEEE 802 standards, FDDI, X.25, Frame Relay and Asynchronous Transfer Mode (ATM). In Internet Protocol Version 6 (IPv6) networks, the functionality of ARP is provided by the Neighbor Discovery Protocol (NDP). Operating scope T ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Layer
In the seven-layer OSI model of computer networking, the network layer is layer 3. The network layer is responsible for packet forwarding including routing through intermediate Router (computing), routers. Functions The network layer provides the means of transferring variable-length network packets from a source to a destination Host (network), host via one or more networks. Within the service layering semantics of the OSI (Open Systems Interconnection) network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer. Functions of the network layer include: ; Connectionless communication : For example, Internet Protocol is connectionless, in that a data packet can travel from a sender to a recipient without the recipient having to send an acknowledgement. Connection-oriented protocols exist at other, higher layers of the OSI model. ; Host addressing :Every host in the network must have a unique addr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IS-IS
Intermediate System to Intermediate System (IS-IS, also written ISIS) is a routing protocol designed to move information efficiently within a computer network, a group of physically connected computers or similar devices. It accomplishes this by determining the best route for data through a packet switching network. The IS-IS protocol is defined in ISO/IEC 10589:2002 as an international standard within the Open Systems Interconnection (OSI) reference design. In 2005, IS-IS was called "the ''de facto'' standard for large service provider network backbones". Description IS-IS is an interior gateway protocol, designed for use within an administrative domain or network. This is in contrast to exterior gateway protocols, primarily Border Gateway Protocol (BGP), which is used for routing between autonomous systems. IS-IS is a link-state routing protocol, operating by reliably flooding link state information throughout a network of routers. Each IS-IS router independent ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Frame Relay
Frame Relay (FR) is a standardized wide area network (WAN) technology that specifies the Physical layer, physical and data link layers of digital telecommunications channels using a packet switching methodology. Frame Relay was originally developed as a simplified version of the X.25 system designed to be carried over the emerging Integrated Services Digital Network (ISDN) networks. X.25 had been designed to operate over normal telephone lines that were subject to noise that would result in lost data, and the protocol featured extensive error correction to address this. ISDN offered dramatically lower error rates, in effect zero, and the extensive error correction overhead was no longer needed. The new protocol suite was essentially a cut-down X.25 with no error correction, leading to lower overhead, better channel efficiency, and often significantly overall higher performance than X.25. Like X.25, Frame Relay is normally used in a circuit switched layout, where connections betw ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
ITU-T
The International Telecommunication Union Telecommunication Standardization Sector (ITU-T) is one of the three Sectors (branches) of the International Telecommunication Union (ITU). It is responsible for coordinating Standardization, standards for telecommunications and Information Communication Technology, such as X.509 for cybersecurity, Y.3172 and Y.3173 for machine learning, and H.264/MPEG-4 AVC for video compression, between its Member States, Private Sector Members, and Academia Members. The World Telecommunication Standardization Assembly (WTSA), the sector's governing conference, convenes every four years. ITU-T has a permanent Secretariat (administrative office), secretariat called the Telecommunication Standardization Bureau (TSB), which is based at the ITU headquarters in Geneva, Switzerland. The current director of the TSB is Seizo Onoe (of Japan), whose 4-year term commenced on 1 January 2023. Seizo Onoe succeeded Chaesub Lee of South Korea, who was director from 1 J ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Operations Centre
A network operations center (NOC, pronounced like the word ''knock''), also known as a "network management center", is one or more locations from which network monitoring and control, or network management, is exercised over a computer, telecommunication or satellite network. __TOC__ History The earliest NOCs started during the 1960s. A Network Control Center was opened in New York by AT&T in 1962 which used status boards to display switch and routing information, in real-time, from AT&T's most important toll switches. AT&T later replaced this Network Control Center with a modernized NOC in 1977, located in Bedminster, New Jersey. Purpose NOCs are implemented by business organizations, public utilities, universities, and government agencies that oversee complex networking environments that require high availability. NOC personnel are responsible for monitoring one or many networks for certain conditions that may require special attention to avoid degraded service. Organizations ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Synchronous Optical Networking
Synchronous Optical Networking (SONET) and Synchronous Digital Hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates, data can also be transferred via an electrical interface. The method was developed to replace the plesiochronous digital hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without the problems of synchronization. SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications, e.g. DS1, DS3, from a variety of different sources. However, they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Virtual Circuit Identifier
Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic. ATM was developed to meet the needs of the Broadband Integrated Services Digital Network as defined in the late 1980s, and designed to integrate telecommunication networks. It can handle both traditional high-throughput data traffic and real-time, low-latency content such as telephony (voice) and video.ATM Forum, The User Network Interface (UNI), v. 3.1, , Prentice Hall PTR, 1995, page 2. ATM is a cell switching technology, providing functionality that combines features of circuit switching and packet switching In telecommunications, packet switching is a method of grouping Data (computing), data into short messages in fixed format, i.e. ''network packet, packets,'' that are transmitted over a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
OSI Model
The Open Systems Interconnection (OSI) model is a reference model developed by the International Organization for Standardization (ISO) that "provides a common basis for the coordination of standards development for the purpose of systems interconnection." In the OSI reference model, the components of a communication system are distinguished in seven abstraction layers: Physical, Data Link, Network, Transport, Session, Presentation, and Application. The model describes communications from the physical implementation of transmitting bits across a transmission medium to the highest-level representation of data of a distributed application. Each layer has well-defined functions and semantics and serves a class of functionality to the layer above it and is served by the layer below it. Established, well-known communication protocols are decomposed in software development into the model's hierarchy of function calls. The Internet protocol suite as defined in and is a model of net ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
