|
IEEE 802.11
IEEE 802.11 is part of the IEEE 802 set of local area network (LAN) technical standards, and specifies the set of medium access control (MAC) and physical layer (PHY) protocols for implementing wireless local area network (WLAN) computer communication. The standard and amendments provide the basis for wireless network products using the Wi-Fi brand and are the world's most widely used wireless computer networking standards. IEEE 802.11 is used in most home and office networks to allow laptops, printers, smartphones, and other devices to communicate with each other and access the Internet without connecting wires. IEEE 802.11 is also a basis for vehicle-based communication networks with IEEE 802.11p. The standards are created and maintained by the Institute of Electrical and Electronics Engineers (IEEE) LAN/Metropolitan area network, MAN Standards Committee (IEEE 802). The base version of the standard was released in 1997 and has had subsequent amendments. While each amendment ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Carrier-sense Multiple Access With Collision Avoidance
Carrier-sense multiple access with collision avoidance (CSMA/CA) in computer networking, is a link layer multiple access method in which carrier sensing is used. Under CSMA/CA, nodes attempt to avoid collisions by beginning transmission only after the channel is sensed to have no traffic. When they do transmit, nodes transmit frames in their entirety. This technique is primarily used in wireless networks, where the alternative with collision detection CSMA/CD is not possible due to wireless transmitters de-sensing (turning off) their receivers during packet transmission. CSMA/CA is unreliable due to the hidden node problem. Details Collision avoidance is used to improve the performance of the CSMA method by attempting to divide the channel somewhat equally among all transmitting nodes within the collision domain. # Carrier Sense: prior to transmitting, a node first listens to the shared medium (such as listening for wireless signals in a wireless network) to determine whet ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Part 97
In the U.S., Part 97 is the section of Federal Communications Commission (FCC) rules and regulations that pertains to amateur radio and the conduct of amateur radio operators. It is a part of Title 47 of the Code of Federal Regulations (CFR). Subparts Part 97 consists of six subparts (A through F) and two appendices. A. General Provisions Subpart A contains fifteen sections, numbered 97.1–29. Subpart A defines a number of terms relevant to the provisions of Part 97 and establishes the amateur service as a "voluntary, noncommercial communications service" devoted to advancement of the amateur art, the skills associated with it, and the international goodwill that it brings, especially with regard to the provision of emergency communications. It also establishes the basic constraints and rights that pertain to amateur licensing and conduct, including licensing requirements and limitations on station equipment and power output. B. Station Operating Standards Subpart B ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Amateur Radio
Amateur radio, also known as ham radio, is the use of the radio frequency radio spectrum, spectrum for purposes of non-commercial exchange of messages, wireless experimentation, self-training, private recreation, radiosport, contesting, and emergency, emergency communications. The term ''"radio amateur"'' is used to specify ''"a duly authorized person interested in radioelectric practice with a purely personal aim and without wikt:pecuniary, pecuniary interest"'' (either direct monetary or other similar reward); and to differentiate it from commercial broadcasting, public safety (police and fire), or two-way radio professional services (maritime, aviation, taxis, etc.). The amateur radio service (''amateur service'' and ''amateur-satellite service'') is established by the International Telecommunication Union (ITU) through their recommended radio regulations. National governments regulate technical and operational characteristics of transmissions and issue individual station li ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
List Of WLAN Channels
Wireless LAN (WLAN) channels are frequently accessed using IEEE 802.11 protocols. The 802.11 standard provides several radio frequency bands for use in Wi-Fi communications, each divided into a multitude of channels numbered at 5 MHz spacing (except in the 45/60 GHz band, where they are 0.54/1.08/2.16 GHz apart) between the centre frequency of the channel. The standards allow for channels to be bonded together into wider channels for faster throughput. 860/900 MHz (802.11ah) 802.11ah operates in sub-gigahertz unlicensed bands. Each world region supports different sub-bands, and the channels number depends on the starting frequency on the sub-band it belongs to. Therefore there is no global channels numbering plan, and the channels numbers are incompatible between world regions (and even between sub-bands of a same world region). The following sub-bands are defined in the 802.11ah specifications: 2.4 GHz (802.11b/g/n/ax/be) 14 channels are designated in t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
U-NII
The Unlicensed National Information Infrastructure (U-NII) radio band, as defined by the United States Federal Communications Commission, is part of the radio frequency spectrum used by WLAN devices and by many wireless ISPs. As of March 2021, U-NII consists of eight ranges. U-NII 1 through 4 are for 5 GHz WLAN ( 802.11a and newer), and 5 through 8 are for 6 GHz WLAN ( 802.11ax) use. U-NII 2 is further divided into three subsections. Wireless ISPs generally use 5.725–5.825 GHz. In the USA licensed amateur radio operators are authorized 5.650–5.925 GHz by Part 97.303 of the FCC rules. U-NII power limits are defined by the United States CFR Title 47 (Telecommunication), Part 15 - Radio Frequency Devices, Subpart E - Unlicensed National Information Infrastructure Devices, Paragraph 15.407 - General technical requirements. Many other countries use similar bands for Wireless communication due to a shared IEEE standard. However, regulatory use in individual countrie ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Orthogonal Frequency-division Multiplexing
In telecommunications, orthogonal frequency-division multiplexing (OFDM) is a type of digital transmission used in digital modulation for encoding digital (binary) data on multiple carrier frequencies. OFDM has developed into a popular scheme for wideband digital communication, used in applications such as digital television and audio broadcasting, DSL internet access, wireless networks, power line networks, and 4G/ 5G mobile communications. OFDM is a frequency-division multiplexing (FDM) scheme that was introduced by Robert W. Chang of Bell Labs in 1966. In OFDM, the incoming bitstream representing the data to be sent is divided into multiple streams. Multiple closely spaced orthogonal subcarrier signals with overlapping spectra are transmitted, with each carrier modulated with bits from the incoming stream so multiple bits are being transmitted in parallel. [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Direct-sequence Spread Spectrum
In telecommunications, direct-sequence spread spectrum (DSSS) is a spread-spectrum modulation technique primarily used to reduce overall signal interference. The direct-sequence modulation makes the transmitted signal wider in bandwidth than the information bandwidth. After the despreading or removal of the direct-sequence modulation in the receiver, the information bandwidth is restored, while the unintentional and intentional interference is substantially reduced. Swiss inventor, Gustav Guanella proposed a "means for and method of secret signals". With DSSS, the message symbols are modulated by a sequence of complex values known as ''spreading sequence''. Each element of the spreading sequence, a so-called ''chip'', has a shorter duration than the original message symbols. The modulation of the message symbols scrambles and spreads the signal in the spectrum, and thereby results in a bandwidth of the spreading sequence. The smaller the chip duration, the larger the bandw ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bluetooth
Bluetooth is a short-range wireless technology standard that is used for exchanging data between fixed and mobile devices over short distances and building personal area networks (PANs). In the most widely used mode, transmission power is limited to 2.5 milliwatts, giving it a very short range of up to . It employs Ultra high frequency, UHF radio waves in the ISM bands, from 2.402GHz to 2.48GHz. It is mainly used as an alternative to wired connections to exchange files between nearby portable devices and connect cell phones and music players with wireless headphones, wireless speakers, HIFI systems, car audio and wireless transmission between TVs and soundbars. Bluetooth is managed by the Bluetooth Special Interest Group (SIG), which has more than 35,000 member companies in the areas of telecommunication, computing, networking, and consumer electronics. The Institute of Electrical and Electronics Engineers, IEEE standardized Bluetooth as IEEE 802.15.1 but no longer maintains ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cordless Telephone
A cordless telephone or portable telephone has a portable telephone handset that connects by radio to a base station connected to the public telephone network. The operational range is limited, usually to the same building or within some short distance from the base station. A cordless telephone differs functionally from a mobile phone in its limited range and by depending on the base station on the subscriber premises. Current cordless telephone standards, such as Personal Handy-phone System, PHS and DECT, have blurred the once clear-cut line between cordless and mobile telephones by implementing cell handoff (handover); various advanced features, such as data-transfer; and even, on a limited scale, international roaming. In specialized models, a commercial mobile network operator may maintain base stations and users subscribe to the service. Unlike a corded telephone, a cordless telephone needs mains electricity (to power the base station). The cordless handset contains a re ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Microwave Oven
A microwave oven, or simply microwave, is an electric oven that heats and cooks food by exposing it to electromagnetic radiation in the microwave frequency range. This induces Dipole#Molecular dipoles, polar molecules in the food to rotate and produce thermal energy (heat) in a process known as dielectric heating. Microwave ovens heat food quickly and efficiently because the heating effect is fairly uniform in the outer of a homogeneous, high-water-content food item. The development of the cavity magnetron in the United Kingdom made possible the production of electromagnetic waves of a small enough wavelength (microwaves) to efficiently heat up water molecules. American electrical engineer Percy Spencer is generally credited with developing and patenting the world's first commercial microwave oven, the "Radarange", which was first sold in 1947. He based it on British radar technology which had been developed before and during World War II. Raytheon later licensed its patents ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Electromagnetic Interference At 2
In physics, electromagnetism is an interaction that occurs between particles with electric charge via electromagnetic fields. The electromagnetic force is one of the four fundamental forces of nature. It is the dominant force in the interactions of atoms and molecules. Electromagnetism can be thought of as a combination of electrostatics and magnetism, which are distinct but closely intertwined phenomena. Electromagnetic forces occur between any two charged particles. Electric forces cause an attraction between particles with opposite charges and repulsion between particles with the same charge, while magnetism is an interaction that occurs between charged particles in relative motion. These two forces are described in terms of electromagnetic fields. Macroscopic charged objects are described in terms of Coulomb's law for electricity and Ampère's force law for magnetism; the Lorentz force describes microscopic charged particles. The electromagnetic force is responsible for ma ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
