Sanitary sewer overflow (SSO) is a condition in which untreated sewage
is discharged from a sanitary sewer
into the environment prior to reaching sewage treatment
facilities. When caused by rainfall it is also known as wet weather overflow. It is primarily meaningful in developed countries
, which have extensive treatment facilities. Frequent causes of SSO spills include:
* Blockage of sewer lines
of excessive stormwater
into sewer lines during heavy rainfall
* Malfunction of pumping station
lifts or electrical power failure
* Broken sewer lines.
SSOs can cause gastrointestinal illness
es, beach closures and restrictions on fish and shellfish consumption.
Magnitude of the problem
Developed countries such as the United States
, most Western Europe
an nations (e.g. Italy
, South Korea
are struggling with public health problems of SSO prevention. The magnitude of the problem is much greater in most developing countries.
The U.S. Environmental Protection Agency
(EPA) estimates that at least 23,000 to 75,000 SSO events occur in the United States each year. EPA estimated that upgrading every municipal treatment and collection system to reduce the frequency of overflow events to no more than once every five years would cost about $88 billion as of 2004.
This cost would be in addition to approximately $10 billion already invested. Although the volume of untreated sewage discharged to the environment is less than 0.01 percent of all treated sewage in the United States, the total volume amounts to several billion gallons per annum and accounts for thousands of cases of gastrointestinal illness each year.
Developed European countries and Japan have similar or somewhat larger percentages of SSO events compared to the U.S.
In developing countries
, most wastewater is still not treated when discharged into the environment. The People's Republic of China
discharged about 55 percent of all sewage without treatment of any type, as of 2001. In a relatively developed Middle East
ern country such as Iran
, the majority of Tehran
's population has totally untreated sewage injected to the city’s groundwater. In Venezuela
, a below-average country in South America
with respect to wastewater treatment, 97 percent of the country’s sewage is discharged untreated into the environment.
In many countries there are obligations to measure and report SSO occurrence using real-time telemetry
to warn the public, bathers and shellfishery operators.
more than two meters in diameter.
Sewers that were built in the early stages of urbanization were usually built before sewage treatment
was implemented. Early sewers were simple drainage systems to remove surface runoff
with any waste material it might contain. These drainage systems became combined sewers
when sewage from kitchens, baths, and toilets was added; and the discharge became offensive. Early sewage treatment plants were built to treat the sewage during dry weather; but it was infeasible to treat the larger volume of mixed sewage and precipitation runoff from combined sewers during wet weather. Some cities built sanitary sewers to keep sewage from being mixed with surface runoff so the sewage could be efficiently treated during both wet and dry weather. (About 860 communities in the U.S. continue to use combined sewers.)
Decentralized failures in dry weather mainly occur from collection sewer line blockages, which can arise from a debris
clog or tree root intrusion into the line itself. Approximately half of SSOs in the United States are caused by blockage.
is the blocking agent in approximately half of U.S. SSOs attributed to blockage, and solid debris is the blocking agent for another 25 percent. Root
s are a contributing factor in approximately one-quarter of United States SSOs attributed to blockage. Grease deposits are caused by cooking fats liquified with hot water for discharge to sanitary sewers. These fats congeal as solid deposits in the cooler sewer. Solid debris includes soiled clothing, diaper
s, and sanitary napkin
s flushed down the toilet rather than being put in a waste bin.
One of the main problems of a decentralized line failure is the difficulty of defining the location of overflow, since a typical urban system contains thousands of miles of collection pipes, and the central treatment plant has no way of communicating with all the lines, unless expensive monitoring equipment has been installed. Companies in the UK have widely deployed bulk dielectric transducer
s suspended in the sewers to detect high levels and to report the events back over fixed wireless data networks. In certain locations this practice has permitted the reduction of pollution events by up to 60 percent.
Dry weather blockage is less likely within combined sewers; because combined sewers designed for the additional volume of surface runoff are much larger than sanitary sewers. Combined sewer storm water regulators may be vulnerable to blockage by debris, but overflow from such blockage typically enters the diversion outfall
to avoid flooding private or public property.
Approximately one-quarter of United States SSOs occur during heavy rainfall
events, which can cause inflow of stormwater
into sanitary sewers through damage, improper connections, or flooding buildings and lift station
s in low-lying areas of the collection system. The combined flow of sewage and stormwater exceeds the capacity of the sanitary sewer system and sewage is released into homes, businesses and streets.
This circumstance is most prevalent in older cities whose subsurface infrastructure is quite old; Paris
, New York City
, Washington, DC
, and Oakland, California
are typical examples of such locations. Inflow into the sanitary lines can be caused by tree root rupture of subsurface lines or by mechanical fracture due to age and overpressure from trucks and buildings.
Another mode of system failure can include power outage
s, which may disable lift station
pumps and cause sewage overflow from the lift station wet well. Lift station mechanical or power failure causes approximately ten percent of United States SSOs. This type of discharge is uncommon from combined sewers, because the combined volume of sewage and storm water discourages use of lift stations. Broken sewer lines are responsible for approximately ten percent of U.S. SSOs.
Power failure, human error
, or mechanical failure may cause similar discharge of untreated or partially treated sewage from a sewage treatment plant; but this is typically regarded as a sewage treatment plant malfunction rather than a sanitary sewer overflow. Sewage treatment plants may be designed to capture overflow from malfunctioning units and discharge it to alternative treatment facilities. Flooding of private or public property is typically avoided by discharging the overflow to an outfall designed for discharge of treated sewage.
Human health and ecological consequences
Human health impacts include significant numbers of gastrointestinal illness
each year, although death from one overflow event is uncommon. Additional human impacts include beach
restrictions and prohibition of the consumption of certain aquatic animals (particularly certain mollusc
s) after overflow events. Ecological consequences include fish kill
s, harm to plankton
and other aquatic microflora and microfauna. Turbidity increase and dissolved oxygen decrease in receiving waters can lead to accentuated effects beyond the obvious pathogen
ic induced damage to aquatic ecosystem
s. It is possible that higher life forms such as marine mammal
s can be affected since certain seals and sea lion
s are known to experience peaks in pathogenic harm.
The concept of SSO containment valves has been pioneered in the UK and they are installed to mitigate dry spills, by correlating rainfall data with SSO spill activity.
250px|Sewage treatment plant
used to create the Wonga Wetlands, [[Australia
Since medieval times rulers have been aware of the impact of raw sewage improperly discharged to the environment. Before treatment systems existed in 16th century [[England, [[Henry VIII of England|King Henry VIII decreed that sewage troughs should be kept flowing so that they would not stagnate in London
prior to reaching the River Thames
(London sewer system
In the 19th century, sewage treatment plants were first developed and installed in the U.S. and parts of Europe, and the concept of SSO was identified. SSOs were not recognized as a widespread environmental problem until the rise of environmental awareness in the 1960s. Around that time government agencies in the U.S. began identifying locations and frequencies of SSOs in a systematic way. Local governments heard complaints of citizens, and beach closure protocols were systematised to reduce risks to public health.
After passage of the Clean Water Act
in 1972, the U.S. spent billions of dollars on upgrades to sewage treatment plants, with some associated repairs and improvements to the associated collection systems, where the overflows occur. EPA continues to provide funding for low-interest loans to communities for addressing SSO problems, through the Clean Water State Revolving Fund
In the 1990s Japan
, the UK
and a number of other European countries began earnest investigation of some of their countries’ overflow issues.
* Water pollution
External linksTechnical reports and additional SSO resources