Yacht-mainsheet-jibsheet-vang-downhaul-jib halyard

Rigging comprises the system of ropes, cables and chains, which support a

sailing ship A sailing ship is a sea-going vessel that uses sails mounted on masts to harness the power of wind and propel the vessel. There is a variety of sail plans that propel sailing ships, employing square-rigged or fore-and-aft sails. Some ships c ...

sail boat A sailboat or sailing boat is a boat propelled partly or entirely by sails and is smaller than a sailing ship. Distinctions in what constitutes a sailing boat and ship vary by region and maritime culture. Types Although sailboat terminology ...

's masts—''standing rigging'', including

shrouds Shroud usually refers to an item, such as a cloth, that covers or protects some other object. The term is most often used in reference to '' burial sheets'', mound shroud, grave clothes, winding-cloths or winding-sheets, such as the famous S ...

and stays—and which adjust the position of the vessel's sails and spars to which they are attached—the ''running rigging'', including

halyard In sailing, a halyard or halliard is a line (rope) that is used to hoist a ladder, sail, flag or yard. The term ''halyard'' comes from the phrase "to haul yards". Halyards, like most other parts of the running rigging, were classically made of n ...

s, braces,

sheets A bed sheet is a rectangular piece of cloth used either singly or in a pair as bedding, which is larger in length and width than a mattress, and which is placed immediately above a mattress or bed, but below blankets and other bedding (such as ...

and vangs.

Etymology

According to the

Encyclopædia Britannica Eleventh Edition The ''Encyclopædia Britannica'' Eleventh Edition (1910–1911) is a 29-volume reference work, an edition of the ''Encyclopædia Britannica''. It was developed during the encyclopaedia's transition from a British to an American publication. So ...

"rigging" derives from

Anglo-Saxon The Anglo-Saxons were a Cultural identity, cultural group who inhabited England in the Early Middle Ages. They traced their origins to settlers who came to Britain from mainland Europe in the 5th century. However, the ethnogenesis of the Anglo- ...

''wrigan'' or ''wringing'', "to clothe". The same source points out that "rigging" a sailing vessel refers to putting all the components in place to allow it to function, including the masts, spars, sails and the rigging.

Types of rigging

Rigging is divided into two classes, ''

standing Standing, also referred to as orthostasis, is a position in which the body is held in an ''erect'' ("orthostatic") position and supported only by the feet. Although seemingly static, the body rocks slightly back and forth from the ankle in the s ...

'', which supports the mast (and bowsprit), and ''running'', which controls the orientation of the sails and their degree of

reefing Reefing reduces the area of a sail, usually by folding or rolling one edge of the canvas in on itself and attaching the unused portion to a spar or a stay, as the primary measure to preserve a sailing vessel's stability in strong winds. Restoring ...

. Configurations differ for each type of rigging, between ''

fore-and-aft rig A fore-and-aft rig is a sailing vessel rigged mainly with sails set along the line of the keel, rather than perpendicular to it as on a square rigged vessel. Description Fore-and-aft rigged sails include staysails, Bermuda rigged sails, gaff ...

ged'' vessels and ''

square-rig Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called ''yards'' and ...

ged'' vessels.

Standing

Standing rigging Standing rigging comprises the fixed lines, wires, or rods, which support each mast or bowsprit on a sailing vessel and reinforce those spars against wind loads transferred from the sails. This term is used in contrast to running rigging, whic ...

is cordage which is fixed in position. Standing rigging is almost always between a mast and the deck, using

tension Tension may refer to: Science * Psychological stress * Tension (physics), a force related to the stretching of an object (the opposite of compression) * Tension (geology), a stress which stretches rocks in two opposite directions * Voltage or el ...

to hold the mast firmly in place. Due to its role, standing rigging is now most commonly made of steel cable. It was historically made of the same materials as running rigging, only coated in tar for added strength and protection from the elements.

Fore-and-aft rigged vessels

Most fore-and-aft rigged vessels have the following types of standing rigging: a

forestay On a sailing vessel, a forestay, sometimes just called a stay, is a piece of standing rigging which keeps a mast from falling backwards. It is attached either at the very top of the mast, or in fractional rigs between about 1/8 and 1/4 from the t ...

, a

backstay A backstay is a piece of standing rigging on a sailing vessel that runs from the mast to either its transom or rear quarter, counteracting the forestay and jib. It is an important sail trim control and has a direct effect on the shape of the main ...

, and upper and lower

(side stays). Less common rigging configurations are diamond stays and jumpers. Both of these are used to keep a thin mast in column especially under the load of a large down wind sail or in strong wind. Rigging parts include

swageless terminal In 1973 Sta-Lok launched the swageless terminal system for wire rope at the London Boat Show. The swageless terminal can be fitted by using hand tools, unlike a swage terminal which requires a special press, roller die or rotary hammer machine t ...

swage terminal A swage terminal is a product used to terminate wire. A swaging machine is used to terminate the wire. The wire is passed into a deep hole in the swage terminal which is then pressed onto the terminal by applying force. This type of product is use ...

s, shackle toggle terminals and fail-safe wire rigging insulators.

Square-rigged vessels

Whereas 20th-century square-rigged vessels were constructed of steel with steel standing rigging, prior vessels used wood masts with hemp-fiber standing rigging. As rigs became taller by the end of the 19th century, masts relied more heavily on successive spars, stepped one atop the other to form the whole, from bottom to top: the ''lower mast'', ''top mast'', and ''topgallant mast''. This construction relies heavily on support by a complex array of stays and shrouds. Each stay in either the fore-and-aft or athwartships direction has a corresponding one in the opposite direction providing counter-tension. Fore-and-aft the system of tensioning start with the stays that are anchored in front of each mast. Shrouds are tensioned by pairs of

deadeye A deadeye is an item used in the standing and running rigging of traditional sailing ships. It is a smallish round thick wooden (usually lignum vitae) disc with one or more holes through it, perpendicular to the plane of the disc. Single and tripl ...

s, circular blocks that have the large-diameter line run around them, whilst multiple holes allow smaller line—''lanyards''—to pass multiple times between the two and thereby allow tensioning of the shroud. In addition to overlapping the mast below, the top mast and topgallant mast are supported laterally by shrouds that pass around either a platform, called a "

top A spinning top, or simply a top, is a toy with a squat body and a sharp point at the bottom, designed to be spun on its vertical axis, balancing on the tip due to the gyroscopic effect. Once set in motion, a top will usually wobble for a few ...

", or cross-wise beams, called " crosstrees". Each additional mast segment is supported fore and aft by a series of stays that lead forward. These lines are countered in tension by backstays, which are secured along the sides of the vessel behind the shrouds.

Running

Running rigging Running rigging is the rigging of a sailing vessel that is used for raising, lowering, shaping and controlling the sails on a sailing vessel—as opposed to the standing rigging, which supports the mast and bowsprit. Running rigging varies bet ...

is the cordage used to control the shape and position of the sails. Materials have evolved from the use of

Manilla rope Manila rope is a type of rope made from manila hemp. Manila hemp is a type of fiber obtained from the leaves of the abacá. It is not actually hemp, but named so because hemp was long a major source of fiber, and other fibers were sometimes ...

to synthetic fibers, which include

dacron Polyethylene terephthalate (or poly(ethylene terephthalate), PET, PETE, or the obsolete PETP or PET-P), is the most common thermoplastic polymer resin of the polyester family and is used in fibres for clothing, containers for liquids and foods ...

nylon Nylon is a generic designation for a family of synthetic polymers composed of polyamides ( repeating units linked by amide links).The polyamides may be aliphatic or semi-aromatic. Nylon is a silk-like thermoplastic, generally made from petro ...

and

kevlar Kevlar (para-aramid) is a strong, heat-resistant synthetic fiber, related to other aramids such as Nomex and Technora. Developed by Stephanie Kwolek at DuPont in 1965, the high-strength material was first used commercially in the early 1970s a ...

. Running rigging varies between ''fore-and-aft rigged'' vessels and ''square-rigged'' vessels. They have common functions between them for supporting, shaping and orienting sails, which employ different mechanisms. For supporting sails,

s (sometimes haulyards), are used to raise sails and control luff tension. On

gaff-rig Gaff rig is a sailing rig (configuration of sails, mast and stays) in which the sail is four-cornered, fore-and-aft rigged, controlled at its peak and, usually, its entire head by a spar (pole) called the ''gaff''. Because of the size and sha ...

ged vessels,

topping lift The topping lift (more rarely known as an uphaul) is a line which applies upward force on a boom on a sailboat. Part of the running rigging, topping lifts are primarily used to hold a boom up when the sail is lowered. This line would run from ne ...

s hold the yards across the top of the sail aloft. Sail shape is usually controlled by lines that pull at the corners of the sail, including the

outhaul An outhaul is a control line found on a sailboat. It is an element of the running rigging, used to attach the mainsail Parts of a sail#Corners, clew to the boom (sailing), boom and tensions the Sail components#Edges, foot of the sail. It commonly ...

at the

clew Sail components include the features that define a sail's shape and function, plus its constituent parts from which it is manufactured. A sail may be classified in a variety of ways, including by its orientation to the vessel (e.g. ''fore-and-a ...

and the

downhaul The downhaul is a line which is part of the rigging on a sailboat; it applies downward force on a spar or sail. The most common downhaul on a modern sailboat is attached to the spinnaker pole, though this may be referred to as the foreguy in some ...

at the

tack TACK is a group of archaea acronym for Thaumarchaeota (now Nitrososphaerota), Aigarchaeota, Crenarchaeota (now Thermoproteota), and Korarchaeota, the first groups discovered. They are found in different environments ranging from acidophilic the ...

on fore-and-aft rigs. The orientation of sails to the wind is controlled primarily by sheets, but also by braces, which position the yard arms with respect to the wind on square-rigged vessels.

References

External links

Photos of different types of ship rigging
at GlobalSecurity.org {{Authority control Sailing rigs and rigging Marine occupations