operation code

In computing, an opcode (abbreviated from operation code) is an enumerated value that specifies the operation to be performed. Opcodes are employed in hardware devices such as arithmetic logic units (ALUs), central processing units (CPUs), and software instruction sets. In ALUs, the opcode is directly applied to circuitry via an input signal bus. In contrast, in CPUs, the opcode is the portion of a machine language instruction that specifies the operation to be performed.

CPUs

Opcodes are found in the machine language instructions of CPUs as well as in some abstract computing machines. In CPUs, an opcode may be referred to as an instruction machine code, instruction code, instruction syllable, instruction parcel, or opstring. For any particular processor (which may be a general CPU or a more specialized processing unit), the opcodes are defined by the processor's instruction set architecture (ISA). They can be described using an opcode table. The types of operations may include arithmetic, data copying, logical operations, program control, and special instructions (e.g., CPUID).

In addition to the opcode, many instructions specify the data (known as operands) the operation will act upon, although some instructions may have implicit operands or none. Some instruction sets have nearly uniform fields for opcode and operand specifiers, whereas others (e.g., x86 architecture) have a less uniform, variable-length structure. Instruction sets can be extended through opcode prefixes, which add a subset of new instructions made up of existing opcodes following reserved byte sequences.

Sample opcode table

This table shows opcodes of a simple 8-bit microprocessor, the Intel 8008 from 1972.

Each opcode is 8 bits long. Each is shown as a binary pattern of ones and zeros in the Opcode column. Up to two additional fields may be embedded into the opcode. Some 3-bit fields are labeled DDD, SSS, CC, and ALU. The SSS (source) and DDD (destination) fields specify one of the eight possible 8008 registers or memory: A, B, C, D, E, H, L, or M. CC specifies a condition that will activate certain JMP, CAL, and RET instructions. ALU specifies one of a possible eight arithmetic logic unit functions to be performed during an instruction, specifically, add, add with carry, subtract, subtract with borrow, logical AND, logical XOR, logical OR, and compare. The X in some fields means that either a 1 or 0 can be inserted with no effect.

The fixed ones and zeros are combined with the parameter fields to build the 8-bit opcode. Additionally, the full instruction might require one or two additional bytes of operands. These are shown in the second major column of the table, labeled "Operands". If no operands are required, the column is filled with a dash (—).

Since the ones and zeros are difficult to remember, the Mnemonic column shows a short, easy to remember letter code that an assembly language programmer may use to invoke the required opcode.

The Description column shows the function performed by the microprocessor when it encounters a specific opcode.

Software instruction sets

Opcodes can be found in bytecodes and other representations intended for execution by software interpreters. These often employ slightly higher-level data types and operations than those found in hardware opcodes but are nevertheless constructed along similar lines. Examples include the byte code found in Java class files, which are interpreted by Java virtual machines, the byte code used in GNU Emacs for compiled Lisp code, and NET Common Intermediate Language.

See also

* Gadget (machine instruction sequence)
* Illegal opcode
* Syllable (computing)
* Fused operation

References

{{X86 assembly topics

Machine code