Kilotons

TNT equivalent is a convention for expressing energy, typically used to describe the energy released in an explosion. The is a unit of energy defined by that convention to be , which is the approximate energy released in the detonation of a metric ton (1,000 kilograms) of TNT. In other words, for each gram of TNT exploded, (or 4184 joules) of energy is released.

This convention intends to compare the destructiveness of an event with that of conventional explosive materials, of which TNT is a typical example, although other conventional explosives such as dynamite contain more energy.

Kiloton and megaton

The "kiloton (of TNT)" is a unit of energy equal to 4.184 terajoules ().

The "megaton (of TNT)" is a unit of energy equal to 4.184 petajoules ().

The kiloton and megaton of TNT have traditionally been used to describe the energy output, and hence the destructive power, of a nuclear weapon. The TNT equivalent appears in various nuclear weapon control treaties, and has been used to characterize the energy released in asteroid impacts.

Historical derivation of the value

Alternative values for TNT equivalency can be calculated according to which property is being compared and when in the two detonation processes the values are measured.

Where for example the comparison is by energy yield, an explosive's energy is normally expressed for chemical purposes as the thermodynamic work produced by its detonation. For TNT this has been accurately measured as 4686 J/g from a large sample of air blast experiments, and theoretically calculated to be 4853 J/g.

But, even on this basis, comparing the actual energy yields of a large nuclear device and an explosion of TNT can be slightly inaccurate. Small TNT explosions, especially in the open, don't tend to burn the carbon-particle and hydrocarbon products of the explosion. Gas-expansion and pressure-change effects tend to "freeze" the burn rapidly. A large open explosion of TNT may maintain fireball temperatures high enough so that some of those products do burn up with atmospheric oxygen.

Such differences can be substantial. For safety purposes a range as wide as has been stated for a gram of TNT upon explosion.

So, one can state that a nuclear bomb has a yield of 15 kt (); but an actual explosion of a pile of TNT may yield (for example) due to additional carbon/hydrocarbon oxidation not present with small open-air charges.

These complications have been sidestepped by convention. The energy liberated by one gram of TNT was arbitrarily defined as a matter of convention to be 4184 J, which is exactly one kilocalorie.

A kiloton of TNT can be visualized as a cube of TNT on a side.

Conversion to other units

1 ton TNT equivalent is approximately:
* calories
* joules
* British thermal units
* foot-pounds
* kilowatt-hours

Examples

Relative effectiveness factor

The relative effectiveness factor (RE factor) relates an explosive's demolition power to that of TNT, in units of the TNT equivalent/kg (TNTe/kg). The RE factor is the relative mass of TNT to which an explosive is equivalent: The greater the RE, the more powerful the explosive.

This enables engineers to determine the proper masses of different explosives when applying blasting formulas developed specifically for TNT. For example, if a timber-cutting formula calls for a charge of 1 kg of TNT, then based on octanitrocubane's RE factor of 2.38, it would take only 1.0/2.38 (or 0.42) kg of it to do the same job. Using PETN, engineers would need 1.0/1.66 (or 0.60) kg to obtain the same effects as 1 kg of TNT. With ANFO or ammonium nitrate, they would require 1.0/0.74 (or 1.35) kg or 1.0/0.32 (or 3.125) kg, respectively.

Calculating a single RE factor for an explosive is, however, impossible. It depends on the specific case or use. Given a pair of explosives, one can produce 2× the shockwave output (this depends on the distance of measuring instruments) but the difference in direct metal cutting ability may be 4× higher for one type of metal and 7× higher for another type of metal. The relative differences between two explosives with shaped charges will be even greater. The table below should be taken as an example and not as a precise source of data.

Nuclear examples

See also

* Brisance
* Net explosive quantity
* Nuclear weapon yield
* Orders of magnitude (energy)
* Relative effectiveness factor
* Table of explosive detonation velocities
* Ton
* Tonne
* Tonne of oil equivalent, a unit of energy almost exactly 10 tonnes of TNT

References

*

Nuclear Weapons FAQ Part 1.3
*
*
*
*
*
*
*

{{Nuclear technology

Explosives
Explosives engineering
Scales
Units of energy
Equivalent units