IS-7
   HOME

TheInfoList



OR:

The IS-7 heavy tank, also known by its project name Object 260, is a
Soviet The Soviet Union,. officially the Union of Soviet Socialist Republics. (USSR),. was a transcontinental country that spanned much of Eurasia from 1922 to 1991. A flagship communist state, it was nominally a federal union of fifteen nation ...
tank that began development in 1945. The vehicle existed only in prototype form and was cancelled in favor of the
T-10 tank The T-10 (also known as Object 730 or, IS-8) was a Soviet heavy tank of the Cold War, the final development of the IS tank series. During development, it was called IS-8 and IS-9. It was accepted into production in 1952 as the IS-10 (''Iosif ...
.


Design and production

The IS-7 heavy tank design began in
Leningrad Saint Petersburg ( rus, links=no, Санкт-Петербург, a=Ru-Sankt Peterburg Leningrad Petrograd Piter.ogg, r=Sankt-Peterburg, p=ˈsankt pʲɪtʲɪrˈburk), formerly known as Petrograd (1914–1924) and later Leningrad (1924–1991), i ...
in 1945 by Nikolai Fedorovich Shashmurin Weighing 68
tonne The tonne ( or ; symbol: t) is a unit of mass equal to 1000  kilograms. It is a non-SI unit accepted for use with SI. It is also referred to as a metric ton to distinguish it from the non-metric units of the short ton ( United State ...
s, thickly armoured and armed with a 130 mm S-70 long-barrelled gun, it was the largest and heaviest member of the IS family and one of the most advanced heavy tank designs. The armour was engineered in a similar fashion to the IS-3, with a pike nose on the upper glacis sporting 150mm of armor sloped at 65°. This armor was designed to defeat rounds from the
Jagdtiger The ''Jagdtiger'' ("Hunting Tiger"; officially designated ''Panzerjäger Tiger Ausf. B'') is a German casemate-type heavy tank destroyer (''Jagdpanzer'') of World War II. It was built upon the slightly lengthened chassis of a Tiger II. Its or ...
's 12.8 cm Pak 44 from as close as . The lower glacis was designed to be 100mm but a measure taken by Nicholas Moran found it to be as thick as 110-120mm depending on welding variations. The armor on the sides was also 150mm on the upper side plate and 100mm on the lower side plate. Behind the lower side plate, inflatable bags could hold fuel. The turret mantlet was 350mm thick and the turret itself between 240-250mm angled at 50-60 degrees. When shot at frontally, the extreme angle that the pike nose presents results in a much higher likelihood of a ricochet. Thus, armour protection could be enhanced without having to use excessive amounts of materials. However, if the pike nose was shot at a sideways angle, it would not have a relative thickness high enough to ricochet the shell. The tank's interior has a "V" shape seen from the front of the tank so that the side armor was spaced. In spite of its weight, it was easy to drive due to numerous hydraulic assists. The loaders noted that the IS-7 was comfortable and that the autoloader was easy to use. It was also able to achieve a top speed of 60 km/h, thanks to a 1050-horsepower diesel engine, giving it a power-to-weight ratio of 15.4 hp/tonne, a ratio superior to most contemporary medium tanks. Its armour was not only immune to the Jagdtiger's 12.8 cm PaK 44 but was even proof to its own 130 mm. Due to unknown reasons, most likely because of the considerable issues arising from its mass (bridges, rail transport - no Soviet/Russian tank accepted into service afterwards exceeded 55 t), the tank never reached the production lines. The 130 mm S-70 was a conversion of a naval gun, firing a ~
armor piercing Armour-piercing ammunition (AP) is a type of projectile designed to penetrate either body armour or vehicle armour. From the 1860s to 1950s, a major application of armour-piercing projectiles was to defeat the thick armour carried on many warsh ...
round ~ The loading mechanism for the gun was an assisted loading mechanism with a conveyor belt system. It held six ready rounds that would then have to be refilled. The rounds came in two parts: shell and propellant. The IS-7 had a massive number of machine guns (eight) and probably would have lost five of them if it had entered production, according to Nicholas Moran. Despite being an excellent break-through vehicle, the IS-7 was heavy, expensive and overspecialized; the T-10 being better suited for longer battles and protracted warfare alongside being easier and cheaper to transport. Work on the IS-7 ceased in 18 February 1949 The tracks were specially made for the IS-7, while those used in the IS series models were rather similar. The track was the first Soviet track to use rubber bushings with single pins, retained in place by bolts. The IS-7 has a total of seven road wheels attached to road wheel arms on torsion bars, limited by
volute spring A volute spring, also known as a conical spring, is a compression spring in the form of a cone (somewhat like the classical volute decorative architectural ornament). Under compression, the coils slide past each other, thus enabling the spring to ...
bump stops, and hydraulic shock absorbers. The rear allowed for external fuel tanks to be carried.


Variants

* Object 261 – Self-propelled gun variant of the IS-7 with a 152mm gun at the rear. Only a wooden mockup was produced. * Object 262 – Self-propelled gun variant with a 152mm gun at the front. * Object 263 – Tank destroyer variant of the IS-7. A 130mm S-70A gun is mounted in a rear, semi-enclosed fighting compartment.


See also

*
IS tank family The IS tanks (russian: ИС) were a series of heavy tanks developed as a successor to the KV-series by the Soviet Union during World War II. The IS acronym is the anglicized initialism of Joseph Stalin (, '). The heavy tanks were designed as a ...
*
KV-1 The Kliment Voroshilov (KV) tanks are a series of Soviet heavy tanks named after the Soviet defence commissar and politician Kliment Voroshilov who operated with the Red Army during World War II. The KV tanks were known for their heavy armour pro ...
heavy tank * T-10 heavy tank *
ISU-152 The ISU-152 (russian: Самоходная установка на базе танка ИС с орудием калибра 152мм, ИСУ-152, Samokhodnaya Ustanovka na baze tanka IS s orudiyem kalibra 152mm, meaning " IS tank based self-prope ...
assault gun *
ISU-122 The ISU-122 (acronym of'' Istrebitelnaja - or Iosif Stalin-based - Samokhodnaya Ustanovka 122'') was a Soviet assault gun used during World War II, mostly in the anti-tank role. History and purpose A prototype of the ISU-122 (in Russian ИС ...
assault gun *
List of Soviet tanks Below is a list of tanks and other armoured fighting vehicles of the Russian empire, Soviet Union, the Russian Federation, and Ukraine. Imperial Russia, World War I Armored tractors *Gulkevich's armored tractor *F. Blinov armored tractor *Wa ...
* German E-100 super heavy tank designed in late World War II


References

{{Reflist


Surviving vehicles

*
Kubinka Tank Museum The Kubinka Tank Museum (Центральный музей бронетанкового вооружения и техники - Tsentral'nyy Muzey Bronetankovogo Vooruzheniya I Tekhniki -Central Museum of Armored Arms and Technology) is a larg ...
, Russia


External links


Part 1
an
Part 2
of "Inside the Chieftain's Hatch: IS-7" video reviews Heavy tanks of the Soviet Union