Iron Monohydride

Iron(I) hydride, systematically named iron hydride and poly(hydridoiron) is a solid inorganic compound with the chemical formula (also written or FeH). It is both thermodynamically and kinetically unstable toward decomposition at ambient temperature, and as such, little is known about its bulk properties.

Iron(I) hydride is the simplest polymeric iron hydride. Due to its instability, it has no practical industrial uses. However, in metallurgical chemistry, iron(I) hydride is fundamental to certain forms of iron-hydrogen alloys.

Nomenclature

The systematic name ''iron hydride'', a valid IUPAC name, is constructed according to the compositional nomenclature. However, as the name is compositional in nature, it does not distinguish between compounds of the same stoichiometry, such as molecular species, which exhibit distinct chemical properties. The systematic names ''poly(hydridoiron)'' and ''poly errane(1)', also valid IUPAC names, are constructed according to the additive and electron-deficient substitutive nomenclatures, respectively. They do distinguish the titular compound from the others.

Hydridoiron

Hydridoiron, also systematically named ferrane(1), is a related compound with the chemical formula FeH (also written eH. It is also unstable at ambient temperature with the additional propensity to autopolymerize, and so cannot be concentrated.

Hydridoiron is the simplest molecular iron hydride. In addition, it may be considered to be the iron(I) hydride monomer. It has been detected in isolation only in extreme environments, like trapped in frozen noble gases, in the atmosphere of cool stars, or as a gas at temperatures above the boiling point of iron. It is assumed to have three dangling valence bonds, and is therefore a free radical; its formula may be written FeH^3• to emphasize this fact.

At very low temperatures (below 10 K), FeH may form a complex with molecular hydrogen FeH·H₂.

Hydridoiron was first detected in the laboratory by B. Kleman and L. Åkerlind in the 1950s.

Properties

Radicality and acidity

A single electron of another atomic or molecular species can join with the iron centre in hydridoiron by substitution:
: eH+ RR → eHR+ ·R
Because of this capture of a single electron, hydridoiron has radical character. Hydridoiron is a strong radical.

An electron pair of a Lewis base can join with the iron centre by adduction:
: eH+ :L → eHLBecause of this capture of an adducted electron pair, hydridoiron has Lewis-acidic character. It should be expected that iron(I) hydride has significantly diminished radical properties, but has similar acid properties, however reaction rates and equilibrium constants are different.

Structure

In iron(I) hydride, the atoms form a network, individual atoms being interconnected by covalent bonds. Since it is a polymeric solid, a monocrystalline sample is not expected to undergo state transitions, such as melting and dissolution, as this would require the rearrangement of molecular bonds and consequently, change its chemical identity. Colloidal crystalline samples, wherein intermolecular forces are relevant, are expected to undergo state transitions.

Iron(I) hydride adopts a double hexagonal close-packed crystalline structure with the P6₃/mmc space group, also referred to as epsilon-prime iron hydride in the context of the iron-hydrogen system. It is predicted to exhibit polymorphism, transitioning at some temperature below to a face-centred crystalline structure with the Fmm space group.

Electromagnetic properties

FeH is predicted to have a quartet and a sextet ground states.

The FeH molecule has at least four low energy electronic states caused by the non bonding electron taking up positions in different orbitals: X⁴Δ, a⁶Δ b⁶Π, and c⁶Σ⁺. Higher energy states are termed B⁴Σ⁻, C⁴Φ, D⁴Σ⁺, E⁴Π, and F⁴Δ. Even higher levels are labelled G⁴Π and H⁴Δ from the quartet system, and d⁶Σ⁻, e⁶Π, f⁶Δ, and g⁶Φ. In the quartet states the inner quantum number J takes on values 1/2, 3/2, 5/2, and 7/2.

FeH has an important absorption band (called the Wing-Ford band) in the near infrared with a band edge at 989.652 nm and a maximum absorption at 991 nm. It also has lines in the blue at 470 to 502.5 nm and in green from 520 to 540 nm.

The small isotope shift of the deuterated FeD compared to FeH at this wavelength shows that the band is due to a (0,0) transition from the ground state, namely F⁴Δ—X⁴Δ.

Various other bands exists in each part of the spectrum due to different vibrational transitions. The (1,0) band, also due to F⁴Δ—X⁴Δ transitions, is around 869.0 nm and the (2,0) band around 781.8 nm.

Within each band there are a great number of lines. These are due to transition between different rotational states. The lines are grouped into subbands ⁴Δ_7/2—⁴Δ_7/2 (strongest) and ⁴Δ_5/2—⁴Δ_5/2, ⁴Δ_3/2—⁴Δ_3/2 and ⁴Δ_1/2—⁴Δ_1/2. The numbers like 7/2 are values for Ω the spin component. Each of these has two branches P and R, and some have a Q branch. Within each there is what is called Λ splitting that results in a lower energy lines (designated "a") and higher energy lines (called "b"). For each of these there is a series of spectral lines dependent on J, the rotational quantum number, starting from 3.5 and going up in steps of 1. How high J gets depends on the temperature. In addition there are 12 satellite branches ⁴Δ_7/2—⁴Δ_5/2, ⁴Δ_5/2—⁴Δ_3/2, ⁴Δ_3/2—⁴Δ_1/2, ⁴Δ_5/2—⁴Δ_7/2, ⁴Δ_3/2—⁴Δ_5/2 and ⁴Δ_1/2—⁴Δ_3/2 with P and R branches.

Some lines are magnetically sensitive, such as 994.813 and 995.825 nm. They are broadened by the Zeeman effect yet others in the same band are insensitive to magnetic fields like 994.911 and 995.677 nm. There are 222 lines in the (0-0) band spectrum.

Occurrence in outer space

Iron hydride is one of the few molecules found in the Sun. Lines for FeH in the blue-green part of the solar spectrum were reported in 1972, including many absorption lines in 1972. Also sunspot umbras show up the Wing-Ford band prominently.

Bands for FeH (and other hydrides of transition metals and alkaline earths) show up prominently in the emission spectra for M dwarfs and L dwarfs, the hottest kind of brown dwarf. For cooler T dwarfs, the bands for FeH do not appear, probably due to liquid iron clouds blocking the view of the atmosphere, and removing it from the gas phase of the atmosphere. For even cooler brown dwarfs (<1350 K), signals for FeH reappear, which is explained by the clouds having gaps.

The explanation for the kind of stars that the FeH Wing-Ford band appears in, is that the temperature is around 3000 K and pressure is sufficient to have a large number of FeH molecules formed. Once the temperature reaches 4000 K as in a K dwarf the line is weaker due to more of the molecules being dissociated. In M giant red giants the gas pressure is too low for FeH to form.

Elliptical and lenticular galaxies also have an observable Wing-Ford band, due to a large amount of their light coming from M dwarfs.

Production

Kleman and Åkerlind first produced FeH in the laboratory by heating iron to 2600 K in a King-type furnace under a thin hydrogen atmosphere.

Molecular FeH can also be obtained (together with FeH₂ and other species) by vaporizing iron in an argon-hydrogen atmosphere and freezing the gas on a solid surface at about 10 K (-263 °C). The compound can be detected by infrared spectroscopy, and about half of it disappears when the sample is briefly warmed to 30 K. A variant technique uses pure hydrogen atmosphere condensed at 4 K.

This procedure also generates molecules that were thought to be FeH₃ (ferric hydride) but were later assigned to an association of FeH and molecular hydrogen H₂.

Molecular FeH has been produced by the decay of ⁵⁷Co embedded in solid hydrogen. Mössbauer spectroscopy revealed an isomer shift of 0.59 mm/s compared with metallic iron and quadrupole splitting of 2.4 mm/s. FeH can also be produced by the interaction of Iron pentacarbonyl vapour and atomic hydrogen in a microwave discharge.

See also

* Chromium hydride
* Magnesium monohydride
* Calcium monohydride

References

Extra reading

FeH Bibliography
from ExoMol

{{Hydrides by group

Iron compounds
Metal hydrides