hardtop

A hardtop is a rigid form of automobile roof, which for modern cars is typically constructed from metal. A hardtop roof can be either fixed (i.e. not removable), detachable for separate storing or retractable within the vehicle itself.

The '' pillarless hardtop'' (often referred to as simply "hardtop") is a body style of cars without a B-pillar, which are often styled to give the appearance of a convertible design.

Pillarless hardtops

The pillarless hardtop (abbreviated as "hardtop") is a post-World War II car body designed with no center or B-pillar styled to resemble a convertible. If window frames are present, they are designed to retract with the glass when lowered. This creates an impression of uninterrupted glass along the side of the car. Although having a rigid metal roof, the stylists sometimes make the "hardtop" cars appear to be like a convertible with its top up. Even the smaller automakers like Packard introduced two door hardtops in 1952 "as a response to America's newly discovered fondness for sportier looking cars that resembled a convertible, but had the comfort and convenience of a two-door sedan."

Some hardtop models took the convertible look even further, simulating a convertible-top framework in the interior headliner and shaping the roof to resemble a raised canvas top. By the late-1960s such designs could be highlighted with an optional vinyl covering over the steel roof.

A pillarless hardtop is inherently less rigid than a pillared body, requiring extra underbody strength to prevent shake. Production hardtops commonly share the frame or reinforced body structure of the contemporary convertible model, which is reinforced to compensate for the lack of a fixed roof. The hardtop design received criticism that its roof structure may not provide adequate protection in the event of a rollover crash. However, subsequent research reported that rates of serious or
fatal injury in hardtop models (both 2 and 4-door versions), as well as four-door station wagons, were significantly lower than sedans while the rates of any degree of injury for those same body styles were also significantly lower. A 1980 study for evaluation of rollover test devices reported a greater degree of roof crush was associated with hardtop body styles, but the occurrence of severe passenger injury was not more frequent than in the other car body styles.

The hardtop body style began to disappear along with convertibles in the mid-1970s, partly out of a concern that U.S. federal safety regulations would be difficult for pillarless models to pass. The ascendancy of monocoque construction also made the pillarless design less practical. Some models adopted modified roof styling, placing the B-pillars behind tinted side window glass and painting or molding the outer side of each pillar in black to make them less visible, creating a hardtop look without actually omitting the pillar. Some mid- to late-1970s models continued their previous two-door hardtop bodies, but with fixed rear windows or a variety of vinyl roof and opera window treatments.

By the end of the 1990s, almost all hardtop designs were discontinued as structural integrity standards continued to increase.

Hardtops were typically more expensive than regular sedan models when new. They are more collectible than standard models of the same vehicle, which have a B-pillar.

Origins

Early automobiles had no roof or sides, but by 1900 several cars were offered with fabric roofs and primitive folding tops. However, cars with fully closed bodies (i.e. with a rigid roof and sides) grew in popularity and soon became the norm.

In 1915–1918, the first pillarless hardtop cars were produced, then called "convertible cars" (or "touring sedans" or "Springfields"). The Springfield design featured folding upper frames on the doors and the rear glass frames are removable and stored under or behind the seats. In the late teens, Cadillac offered a sedan with removable "B" pillars.

Another form of early pillarless hardtop is the "California top", originating in Los Angeles and most popular from 1917 to 1927. These were designed to replace the folding roofs of touring cars, in order to enclose the sides of the car for better weather protection. One objective of these aftermarket tops was to bring the cost of the closed car nearer to the prices of corresponding open cars. Automobile dealers were encouraged to equip an open car with a California top to demonstrate that they were "cool and clean in summer, and warm and dry in winter." The hard tops were frequently equipped with celluloid windows that retracted like a roller blind for open sided motoring offering a low-cost compromise between an open and closed car.

United States

There were a variety of hardtop-like body styles dating back to 1916. Chrysler Corporation built seven pillarless Town and Country hardtop coupes as concept vehicles in 1946, and even included the body style in its advertising that year called the Town and Country Custom Club Coupe. In 1951, Plymouth offered the Cranbrook Belvedere as a low priced hardtop two-door until 1953.John Gunnell, Standard Catalog of American Cars 1946-1975, Revised 4th Edition

Mass-production of hardtops began with General Motors, which launched two-door, pillarless hardtops in 1949 as the Buick Roadmaster Riviera, Oldsmobile 98 Holiday, and Cadillac Coupe de Ville. They were purportedly inspired by the wife of a Buick executive who always drove convertibles, but never lowered the top.

The Kaiser-Frazer 1949 Virginian was an early example of a four-door hardtop albeit with a removable thin, chrome- and-glass 'B' pillar held on by five screws. The car was designed to have a convertible look and padded nylon or cotton was applied over the roof contributing to the soft-top appearance.

Two-door hardtops became popular with consumers in the 1950s while the two-door sedan body design fell out of favor among buyers.

In 1955, General Motors introduced the first four-door hardtops. Following the pattern established by the two-door variants, GM utilized the same special sub-designations for the pillarless four-door body types within all their brands in North America. The term de Ville was used for Cadillac, Riviera was used for Buick, Holiday was used for Oldsmobile, Catalina was used for Pontiac, and Bel Air was used for Chevrolet.

Other manufacturers also designated special names for their pillarless models. Ford called them Victoria, Chrysler used Newport and their luxury division Imperial used the name Southampton, Packard named them Mayfair, and Hudson's were Hollywoods. Nash used the Country Club moniker while pillarless Studebakers were Starliners, a name that was later used by Ford for its Galaxie hardtop.

By 1956 every major U.S. automaker offered two- and four-door hardtops in a particular model lineup. General Motors restyled their new models and now offered four-door hardtops from every division and in nearly every series except the lowest priced lines. Chrysler also offered two- and four-door hardtops for every brand, from Imperial, Chrysler, DeSoto, Dodge and Plymouth.

In 1956, the first four-door hardtop station wagons were introduced to the Rambler line by American Motors Corporation. The following year, the Mercury Commuter hardtop wagons became available in both two- and four-door body styles. Chrysler built four-door hardtop station wagons all the way through 1964, in both the Chrysler and Dodge 880 lines.

Throughout the 1960s the two-door pillarless hardtop was by far the most popular body style in most lines where such a model was offered. Even on family-type vehicles like the Chevrolet Impala, the two-door hardtop regularly outsold four-door sedans. Some car lines (such as the 1957-64 Cadillac and 1965–69 Corvair) only offered pillarless models with no sedans at all. So prevalent were true hardtops that ''Popular Mechanics'' had to describe that the new full-sized 1967 Oldsmobile Delmont models also included ''a "pillar" sedan''.

The U.S. industry's last pillarless two-door and four-door hardtops were in the 1978 Chrysler Newport and New Yorker lines. Since then, no U.S. manufacturer has offered a true hardtop in regular production.

Japan

In July 1965 Toyota introduced Japan's first 2-door hardtop coupe, and August 1967 they installed the 1,587 cc DOHC 9R engine in the Toyota 1600GT. This followed with several manufacturers offering the popular bodystyle as a luxury car appearance. During the 1970s, Toyota produced the Toyota Crown in a pillarless two-door hardtop version. Nissan followed suit with the Nissan Cedric and Nissan Gloria in 4-door sedan and 2-door hardtop body styles, with the latter "rendered as a premium quality personal car." Subaru introduced a new compact coupe as a genuine two-door hardtop with the Subaru Leone in 1971. The pillarless hardtop models were more expensive and luxurious than the sedan versions.

In the 1980s, Toyota continued the design with the Mark II, Nissan with its Laurel, and Mazda marketing its Luce.

Europe

Various European manufacturers have produced hardtops without B-pillars (usually coupes), however, they are rarely marketed as pillarless hardtops. Examples include the current Bentley Continental GT, the 2008 Bentley Brooklands, the 2001-2003 Renault Avantime, the Rolls-Royce Wraith, and the 2012-current Ford B-Max. The 1958-1964 Facel Vega Excellence is one of few four-door hardtops produced in Europe.

German pillarless hardtops included cars from the Taunus brand which was a subbrand of Ford. Namely the Ford Taunus P5 and Ford P7 including both P7A and P7B versions. They had regular coupe versions with B pillars but the Hardtop Taunus models had no B pillar and when all the windows were rolled down, you got an open-air feel inside the car.

British pillarless hardtops included the Sunbeam Rapier and the Ford Consul Capri (355) which, unlike American models, sold fewer cars than their regular center pillar saloon versions.

A New Mini two-door sedan has been marketed as a hardtop in the United States, although it does have a B-pillar, which is disguised by being painted black.

Detachable hardtops

A detachable hardtop is a rigid, removable roof panel that is often stored in a car's trunk/boot.

Retractable hardtops

A retractable hardtop (also known as coupé convertible or coupé cabriolet) is a type of convertible that forgoes a folding textile roof in favor of an automatically operated, multi-part, self-storing roof where the rigid roof sections are opaque, translucent, or independently operable.

References

{{Automobile configuration

Car body styles
Automotive accessories
Automotive body parts
Automotive technologies