HOME

TheInfoList



OR:

The British Rail Class 23 were a class of ten
Bo-Bo B-B and Bo-Bo are the Association of American Railroads (AAR) and British classifications of wheel arrangement for railway locomotives with four axles in two individual bogies. They are equivalent to the B′B′ and Bo′Bo′ classifications in ...
diesel-electric locomotive A diesel locomotive is a type of railway locomotive in which the prime mover (locomotive), prime mover is a diesel engine. Several types of diesel locomotives have been developed, differing mainly in the means by which mechanical power is conv ...
s built by the
English Electric Company N.º UIC: 9094 110 1449-3 (Takargo Rail) The English Electric Company Limited (EE) was a British industrial manufacturer formed after the Armistice of 11 November 1918, armistice of World War I by amalgamating five businesses which, during th ...
(EE) in 1959. The power unit used was a
Napier Deltic The Napier Deltic engine is a British opposed-piston valveless, supercharged uniflow scavenged, two-stroke diesel engine used in marine and locomotive applications, designed and produced by D. Napier & Son. Unusually, the cylinders were disp ...
T9-29 9-cylinder engine of driving an EE generator, which powered the four traction motors. They were numbered from D5900 to D5909. The T9-29 diesel engine was a single, half-sized version of those used in the more powerful
British Rail Class 55 The British Rail Class 55, also known as a Deltic, or English Electric type 5, is a class of diesel locomotive built in 1961 and 1962 by English Electric for British Railways. They were designed for the high-speed express passenger services on t ...
'Deltic' locomotives, and the overall design and external appearance of the Class 23 was also similar to the Class 55, but much shorter, leading to their nickname of ''Baby Deltics''.


Introduction and service history

On initial completion, the first locomotives were found to weigh over the specification weight of . A programme of lightening was begun: some of this involved cutting circular
lightening holes Lightening holes are holes in structural components of machines and buildings used by a variety of engineering disciplines to make structures lighter. The edges of the hole may be flanged to increase the rigidity and strength of the component. ...
into the bogie frames, and replacing steel
buffer beam A headstock of a rail vehicle is a transverse structural member located at the extreme end of the vehicle's underframe. The headstock supports the coupling at that end of the vehicle, and may also support buffers, in which case it may also be k ...
s or roof panels with aluminium. Much of the over-weight was due to ancillary components, particularly the train-heating steam generators, being supplied over weight. To avoid waste, these components were replaced by lighter versions from other makers, but the heavier originals were then used in the Class 20 and Class 40 locomotives. The lightened locomotives eventually met British Rail's approval, but only after a painstaking weighing that involved specifying the amount of sand in the sandboxes and other precise details. Webb, The Deltic Locomotives of British Rail, p14 After acceptance trials at
Doncaster Doncaster (, ) is a city in South Yorkshire, England. Named after the River Don, it is the administrative centre of the larger City of Doncaster. It is the second largest settlement in South Yorkshire after Sheffield. Doncaster is situated in ...
, they entered service between April and June 1959. They were based at
Hornsey Hornsey is a district of north London, England in the London Borough of Haringey The London Borough of Haringey (pronounced , same as Harringay) is a London borough in North London, classified by some definitions as part of Inner Lo ...
, although at weekends were usually located at Hitchin engine shed. It had been
British Rail British Railways (BR), which from 1965 traded as British Rail, was a state-owned company that operated most of the overground rail transport in Great Britain from 1948 to 1997. It was formed from the nationalisation of the Big Four British rai ...
's original intention to work the locos across
London London is the capital and largest city of England and the United Kingdom, with a population of just under 9 million. It stands on the River Thames in south-east England at the head of a estuary down to the North Sea, and has been a majo ...
on the
Widened Lines The Widened Lines (also known as the City Widened Lines; formerly known as the Moorgate Line) is a double-track railway line forming part of the Thameslink route between St Pancras and within Central London. For most of their life the Widene ...
but the locomotives were found to be too heavy. The first of the class was held at
Vulcan Foundry The Vulcan Foundry Limited was an English locomotive builder sited at Newton-le-Willows, Lancashire (now Merseyside). History The Vulcan Foundry opened in 1832, as Charles Tayleur and Company to produce girders for bridges, switches, crossi ...
whilst EE tried to reduce the weight but this could not be completed to a satisfactory standard.


Operation

The locomotives were put to work on King's Cross outer suburban duties such as the Cambridge Buffet Express as well as services from Kings Cross to
Moorgate Moorgate was one of the City of London's northern gates in its defensive wall, the last to be built. The gate took its name from the Moorfields, an area of marshy land that lay immediately north of the wall. The gate was demolished in 1762, b ...
sub-surface platforms via the 'widened lines' (more recently, part of
Thameslink Thameslink is a 24-hour main-line route in the British railway system, running from , , , and via central London to Sutton, , , Rainham, , , , and . The network opened as a through service in 1988, with severe overcrowding by 1998, carrying m ...
). The locomotives were later banned from Moorgate because of excessive exhaust smoke in the tunnels. Other services entrusted to the class were race specials run from King's Cross to race meetings at Newmarket.


Technical, design and reliability problems

Initial problems with the locomotives were minor and varied, although a problem with cracking in the cylinder liner around the injector hole required the engine to be changed. By November 1959, seven engines had been changed and this reduced availability first raised comparisons with the better reliability of the
British Rail Class 24 The British Railways Class 24 diesel locomotives, also known as the Sulzer Type 2, were built from 1958 to 1961. One hundred and fifty-one were built at Derby, Crewe and Darlington, the first twenty of them as part of the British Railways 1955 M ...
Type 2. The Type 2s were averaging 30–40,000 miles per failure, the Baby Deltic less than a quarter of this. Although they suffered problems with the cylinder liners that were not dissimilar to those of the Class 55 Deltics, most of the Class 23's early problems were a variety of failures with the engine ancillaries. The auxiliary gearbox used to drive the compressor and cooling fans was a particular problem, suffering from vibration in its geartrain and a resonant whirling in the long drive shaft to it at particular rpm. Many engines seized because this shaft driving the auxiliaries snapped and then whipped round, rupturing coolant hoses and causing overheating. By October 1960 the emphasis of failures had shifted from the ancillaries to the engine itself. Locomotive mileages had only reached 40–60,000 miles each, including stoppages, whilst in this 18 months there had been 44 engine changes across only 10 locomotives. Despite a generous availability of spare engines, four of the ten locomotives were out of service at the time. Four main engine problems had been identified: * Fractured cylinder liners from the injector hole, caused by assembly stresses * Fractured cylinder liners from the injector hole, caused by electrolytic corrosion. * Turbocharger bearing failures, caused by exhaust gases leaking through the labyrinth seals. * Seized pistons, due to poor cooling caused by chemical erosion from incorrect lubricants. In July 1961 BR suggested replacing the Napier engine with an English Electric 8SVT V8. This would however have added eight tons in extra weight, and so was rejected. EE also pointed out that the locomotives were now highly reliable in general, except when a major failure required the considerable downtime for an engine change. By around 1963 all the locomotives had gradually been moved to Stratford Depot as they failed and were added to the line in store, pending a decision on their future. By this time the locos were based at the new diesel maintenance depot at Finsbury Park.


Modification

It was decided by BR and EE to carry out a programme to refurbish the class and modify the engines with new parts designed by the engine manufacturer. The locos also had modifications to their nose ends, losing the gangway doors and headcode discs in favour of a central roller blind headcode box. The livery also changed to two tone green with grey roof similar to that of the
British Rail Class 55 The British Rail Class 55, also known as a Deltic, or English Electric type 5, is a class of diesel locomotive built in 1961 and 1962 by English Electric for British Railways. They were designed for the high-speed express passenger services on t ...
s so they looked every bit a 'Baby Deltic'. The locomotives gradually returned to traffic and became very reliable in traffic except for continuing coolant system problems. The allocation of all ten locomotives in October 1967 was
Finsbury Park Finsbury Park is a public park in the London neighbourhood of Harringay. It is in the area formerly covered by the historic parish of Hornsey, succeeded by the Municipal Borough of Hornsey. It was one of the first of the great London parks ...
.


Withdrawal

By the late 1960s BR had drawn up a "National Traction Plan", whose aim was to rationalise the number and types of diesel locomotives in traffic (and thus reduce operating costs). The 'Baby Deltics' were an obvious target, being only a ten-strong class, and still beset with operational problems. The locos were withdrawn between 1968 and 1971. The last two locos in traffic on revenue-earning service were D5905 and D5909. Several of the class received full yellow ends whilst still in two-tone green. These were D5900/3/4/8; D5908 also carried the new double-arrow BR symbol. D5909 was the only locomotive to receive the full "rail blue" livery. D5901 was transferred to the departmental fleet of the
Railway Technical Centre The Railway Technical Centre (RTC) in London Road, Derby, England, was the technical headquarters of the British Railways Board, and was built in the early 1960s. British Rail described it as the largest railway research complex in the world. T ...
in 1969. It worked test trains to and from the RTC until 1975, when it was replaced by a Class 24. The loco was cut up in 1977, still carrying two-tone green livery with a grey roof and small yellow warning panel.


Preservation

The only major component of a Baby Deltic to survive (apart from
works plate A builder's plate is usually a metal plate that is attached to railway locomotives and rolling stock, bogies, construction equipment, trucks, automobiles, large household appliances, bridges, ships and more. It gives such information as the name of ...
s) is Napier T9-29 engine No. 388 along with its main and auxiliary generators. It had been stored at Stratford TMD being retained as a spare for D5901 whilst it continued in service at the RTC. After D5901 was finally withdrawn the decision was taken to transfer the engine to the
National Railway Museum The National Railway Museum is a museum in York forming part of the Science Museum Group. The museum tells the story of rail transport in Britain and its impact on society. It is the home of the national collection of historically significant r ...
in York. In 2001 the engine was purchased by the Baby Deltic Project and restored to operational condition in 2008. The Baby Deltic Project purchased Class 37 No. 37372, into which the engine was temporarily fitted whilst undergoing running tests. A photograph of the engine being started has been published in ''Rail Express'' magazine, and videos of the event are available online. The T9-29 engine is currently in store at
Barrow Hill Roundhouse Barrow Hill Roundhouse, until 1948 known as Staveley Engine Shed, is a former Midland Railway roundhouse in Barrow Hill, near Staveley and Chesterfield, Derbyshire (), now serving as a railway heritage centre. History Staveley Roundhouse was ...
near Chesterfield (and not on public display) whilst the Baby Deltic Project completes modification work to the locomotive. On 5 September 2010, the Baby Deltic Project announced its plans to create a new member of the class. This is being achieved by way of shortening 37372's body in three places and mounting it on Class 20 bogies. The locomotive can be viewed in the Barrow Hill Roundhouse near Chesterfield where it is currently undergoing the transformation from 37372 into D5910. A book about the restoration of the sole-remaining 'Baby' Deltic engine has been published by The Baby Deltic Project Baby Deltic Project and is available through their website.


Models

The Class 23 "Baby Deltic" is being made as a kit and ready-to-run in OO gauge by Silver Fox Models. Between 1960 and 1965 the Class 23 was available in 000 (approximately N-gauge) gauge as part of the Lone Star "Treble-O-Lectric" range of diecast models in both powered and unpowered versions. Heljan offers ready to run OO models of the Class 23, both in original and rebuilt forms.


References


Sources

* * Ian Allan ABC of British Railways Locomotives, summer 1966 edition


Online sources

* Brief class history and images ''therailwaycentre.com''


Further reading

* * *


External links

* Contains photos of the restoration of the engine {{British Rail Locomotives 23 Napier Deltic Bo-Bo locomotives English Electric locomotives Vulcan Foundry locomotives Railway locomotives introduced in 1959 Scrapped locomotives Standard gauge locomotives of Great Britain Diesel-electric locomotives of Great Britain