The BMW R51/3 was BMW's second post-

World War II World War II or the Second World War, often abbreviated as WWII or WW2, was a world war that lasted from 1939 to 1945. It involved the vast majority of the world's countries—including all of the great powers—forming two opposin ...

500 cc

motorcycle A motorcycle (motorbike, bike, or trike (if three-wheeled)) is a two or three-wheeled motor vehicle steered by a handlebar. Motorcycle design varies greatly to suit a range of different purposes: long-distance travel, commuting, cruising ...

, following the briefly produced R51/2. It featured a

flat-twin engine A flat-twin engine is a two-cylinder internal combustion engine with the cylinders on opposite sides of the crankshaft. The most common type of flat-twin engine is the boxer-twin engine, where both pistons move inwards and outwards at the same ti ...

and exposed

drive shaft A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power (physics), power and torque and rotation, usually ...

. In 1951, the R51/3 succeeded and modernized the 1950 R51/2, which was essentially a pre-war design that was produced after the war. The 600 cc R67, R67/2, and R67/3 series and the more sporting R68 model also followed the R51/2.

History

Following World War II, Germany was precluded from producing motorcycles of any sort by the Allies. When the ban was lifted, in Allied-controlled Western Germany, BMW had to start from scratch. There were no plans, blueprints, or schematic drawings. Company engineers had to use surviving pre-war motorcycles to create new plans. In 1948, it introduced the 250 cc R24, which was essentially a pre-war R23, complete with rigid rear end. When larger machines were permitted, BMW introduced its R51/2 in 1950, a model that was in production for only one year and that was essentially a pre-war BMW produced after the war. The R51/3 was then introduced in 1951 for a production run of four years. The 600 cc R67, sister model to the R51/3 and almost identical visually, was also introduced in 1951, but it went through two revisions. The more powerful R67/2 came out one year later and was replaced in 1955 by the R67/3, which was in production through the 1956 model year. In 1952, BMW introduced the 600 cc R68, which produced , had a compression ratio of 8.0:1.

Technical data

References

External links

{{DEFAULTSORT:BMW R51 3 R51 3 Motorcycles powered by flat engines Shaft drive motorcycles Motorcycles introduced in the 1950s

History

Technical data

See also

References

External links