|
Watkins 23
The Watkins 23 is an American trailerable sailboat that was designed by Johannes "Jopie" Helsen, modified by Watkins Yachts and first built in 1973.Henkel, Steve: ''The Sailor's Book of Small Cruising Sailboats'', page 211. International Marine/McGraw-Hill, 2010. The Watkins 23 is an authorized development of the Helson 22, produced with permission of the designer. Production The design was built by Watkins Yachts in the United States from 1973 to 1980, with 400 examples completed, but it is now out of production. Design The Watkins 23 is a recreational keelboat, built predominantly of fiberglass, with wood trim. It has a masthead sloop rig, a spooned raked stem, a near-vertical transom, a transom-hung rudder controlled by a tiller and a fixed stub keel with a centerboard. It displaces and carries of ballast. The boat has a draft of with the centerboard extended and with it retracted, allowing ground transportation on a trailer. The boat is normally fitted with a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Johannes "Jopie" Helsen
Universal Marine was an American boat builder based in Saint Petersburg, Florida. The company specialized in the design and manufacture of fiberglass sailboats.Henkel, Steve: ''The Sailor's Book of Small Cruising Sailboats'', pages 45, 110 and 357. International Marine/McGraw-Hill, 2010. The company was founded by Johannes "Jopie" Helsen in 1960 as the Helsen Yacht Corporation. History The company was founded as a marina management business and later expanded into boat design and building as a side-business. The first design produced was the Helsen 22 in 1971, followed in 1974 by the Helsen 20. The swing keel Montego 19 and its fixed keel derivative, the Montego 20 were produced first in 1976. The final and largest boat built, the Montego 25, started production in 1980 and was produced until 1985, with 80 boats completed. In a 2010 review, Steve Henkel wrote about Helsen's Montego 25 design, "this one may have been his best effort ... properly sailed will give good performanc ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Masthead Sloop
A masthead rig on a sailing vessel consists of a forestay and backstay both attached at the top of the mast. The Bermuda rig can be split into two groups: the masthead rig and the fractional rig. The masthead rig has larger and more headsails, and a smaller mainsail, compared to the fractional rig. The major advantage a masthead sloop has over a fractional one, is that the jib is larger. Since the jib has no mast in front of it to cause turbulent airflow over it, it is considered much more efficient than the main, especially for sailing up wind. Also, since the fore stay is attached to the top of the mast, it pulls directly against the back stay. Tightening the back stay, then, increases the tension on the fore stay. This is useful because the jib needs considerable fore stay tension to set well. This need increases in direct proportion to the wind speed and jib size. Increasing the tension on the back stay does not tend to bend the mast, as it would on a fractional sloop. It put ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
List Of Sailing Boat Types
The following is a partial list of sailboat types and sailing classes, including keelboats, dinghies and multihull ( catamarans and trimarans). Olympic classes World Sailing Classes Historically known as the IYRU (International Yacht Racing Union), the organization evolved into the ISAF (International Sailing Federation) in 1996, and as of December 2015 is now World Sailing. Dinghies Keelboats & yachts Multihulls Boards Radio-controlled Former World Sailing-classes Dinghies Keelboats & yachts Multihulls Boards Other classes and sailboat types Dinghies Keelboats & yachts Multihulls See also * Classic dinghy classes * List of boat types * List of historical ship types * List of keelboat classes designed before 1970 * Olympic sailing classes * Small-craft sailing * Clansman 30 Notes References {{DEFAULTSORT:Sailing boat types Types * Boat types A boat is a watercraft of a large range of types and sizes, but general ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hull Speed
Hull speed or displacement speed is the speed at which the wavelength of a vessel's bow wave is equal to the waterline length of the vessel. As boat speed increases from rest, the wavelength of the bow wave increases, and usually its crest-to-trough dimension (height) increases as well. When hull speed is exceeded, a vessel in displacement mode will appear to be climbing up the back of its bow wave. From a technical perspective, at hull speed the bow and stern waves interfere constructively, creating relatively large waves, and thus a relatively large value of wave drag. Ship drag for a displacement hull increases smoothly with speed as hull speed is approached and exceeded, often with no noticeable inflection at hull speed. The concept of hull speed is not used in modern naval architecture, where considerations of speed/length ratio or Froude number are considered more helpful. Background As a ship moves in the water, it creates standing waves that oppose its movement. Thi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Performance Handicap Racing Fleet
Performance Handicap Racing Fleet (PHRF) is a handicapping system used for yacht racing in North America. It allows dissimilar classes of sailboats to be raced against each other. The aim is to cancel out the inherent advantages and disadvantages of each class of boats, so that results reflect crew skill rather than equipment superiority. PHRF is used mainly for larger sailboats (i.e., 7 meters and above). For dinghy racing, the Portsmouth yardstick handicapping system is more likely to be used. The handicap number assigned to a class of yachts is based on the yacht's speed relative to a theoretical yacht with a rating of 0. A yacht's handicap, or rating, is the number of seconds per mile traveled that the yacht in question should be behind the theoretical yacht. Most boats have a positive PHRF rating, but some very fast boats have a negative PHRF rating. If Boat A has a PHRF rating of 15 and Boat B has a rating of 30 and they compete on a 1 mile course, Boat A should finish a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Head (watercraft)
The head (pl. heads) is a ship's toilet. The name derives from sailing ships in which the toilet area for the regular sailors was placed at the head or bow of the ship. Design In sailing ships, the toilet was placed in the bow somewhat above the water line with vents or slots cut near the floor level allowing normal wave action to wash out the facility. Only the captain had a private toilet near his quarters, at the stern of the ship in the quarter gallery. The plans of 18th-century naval ships do not reveal the construction of toilet facilities when the ships were first built. The Journal of Aaron Thomas aboard HMS ''Lapwing'' in the Caribbean Sea in the 1790s records that a canvas tube was attached, presumably by the ship's sailmaker, to a superstructure beside the bowsprit near the figurehead, ending just above the normal waterline. In many modern boats, the heads look similar to seated flush toilets but use a system of valves and pumps that brings sea water into the to ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Galley (kitchen)
The galley is the compartment of a ship, train, or aircraft where food is cooked and prepared. It can also refer to a land-based kitchen on a naval base, or, from a kitchen design point of view, to a straight design of the kitchen layout. Ship's cooking area A galley is the cooking area aboard a vessel, usually laid out in an efficient typical style with longitudinal units and overhead cabinets. This makes the best use of the usually limited space aboard ships. It also caters for the rolling and heaving nature of ships, making them more resistant to the effects of the movement of the ship. For this reason galley stoves are often gimballed, so that the liquid in pans does not spill out. They are also commonly equipped with bars, preventing the cook from falling against the hot stove. A small cooking area on deck was called a caboose or ''camboose'', originating from the nl, kombuis, which is still in use today. In English it is a defunct term used only for a cooking area that is ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Quarter Berth
A berth is a bed or sleeping accommodation on vehicles. Space accommodations have contributed to certain common design elements of berths. Beds in boats or ships While beds on large ships are little different from those on shore, the lack of space on smaller yachts means that bunks must be fit in wherever possible. Some of these berths have specific names: ;V-berth: Frequently yachts have a bed in the extreme forward end of the hull (usually in a separate cabin called the forepeak). Because of the shape of the hull this bed is basically triangular, though most also have a triangular notch cut out of the middle of the aft end, splitting it partially into two separate beds and making it more of a V shape, hence the name. This notch can usually be filled in with a detachable board and cushion, creating something more like a double bed (though with drastically reduced space for the feet; 12" wide is typical). The term "V-berth" is not widely used in the UK, instead the cabin a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
"V"-berth
A berth is a bed or sleeping accommodation on vehicles. Space accommodations have contributed to certain common design elements of berths. Beds in boats or ships While beds on large ships are little different from those on shore, the lack of space on smaller yachts means that bunks must be fit in wherever possible. Some of these berths have specific names: ;V-berth: Frequently yachts have a bed in the extreme forward end of the hull (usually in a separate cabin called the forepeak). Because of the shape of the hull this bed is basically triangular, though most also have a triangular notch cut out of the middle of the aft end, splitting it partially into two separate beds and making it more of a V shape, hence the name. This notch can usually be filled in with a detachable board and cushion, creating something more like a double bed (though with drastically reduced space for the feet; 12" wide is typical). The term "V-berth" is not widely used in the UK, instead the cabin a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Outboard Motor
An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft. As well as providing propulsion, outboards provide steering control, as they are designed to pivot over their mountings and thus control the direction of thrust. The skeg also acts as a rudder when the engine is not running. Unlike inboard motors, outboard motors can be easily removed for storage or repairs. In order to eliminate the chances of hitting bottom with an outboard motor, the motor can be tilted up to an elevated position either electronically or manually. This helps when traveling through shallow waters where there may be debris that could potentially damage the motor as well as the propeller. If the electric motor required to move the pistons which raise or lower the engine is malfunctioni ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Boat Trailer
A boat trailer is designed to launch, retrieve, carry and sometimes store boats. Commercial boat trailers Commercial hydraulic boat trailers are used by marinas, boat yards, boat haulers, boat dealers and boat builders. Generally this type of trailer is not used for storage of the boat. Self-propelled Self-propelled boat movers are not strictly trailers, but hydraulically operated boat movers, with their own tractor unit. They share all of the features of hydraulic boat trailers. Non-commercial boat trailers This type of trailer is usually used by the boat owner/operator. The trailer is also used for storage. * Roll-on, also known as a "Roller style trailer", uses rubber and/or polyurethane rollers for ease of launching and loading a boat. * Glide-path, also known as a "Float-on style trailer", allows the boat to float onto the trailer; after the trailer has been partially submerged (usually of the trailer). Since its inception, it has become quite popular compared to th ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Keel
The keel is the bottom-most longitudinal structural element on a vessel. On some sailboats, it may have a hydrodynamic and counterbalancing purpose, as well. As the laying down of the keel is the initial step in the construction of a ship, in British and American shipbuilding traditions the construction is dated from this event. Etymology The word "keel" comes from Old English , Old Norse , = "ship" or "keel". It has the distinction of being regarded by some scholars as the first word in the English language recorded in writing, having been recorded by Gildas in his 6th century Latin work ''De Excidio et Conquestu Britanniae'', under the spelling ''cyulae'' (he was referring to the three ships that the Saxons first arrived in). is the Latin word for "keel" and is the origin of the term careen (to clean a keel and the hull in general, often by rolling the ship on its side). An example of this use is Careening Cove, a suburb of Sydney, Australia, where careening was carried out ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
.jpg "Click for more on -> Masthead Sloop")
_bunks.jpg "Click for more on ->")
