|
Tachometer
A tachometer (revolution-counter, tach, rev-counter, RPM gauge) is an instrument measuring the rotation speed of a shaft or disk, as in a motor or other machine. The device usually displays the revolutions per minute (RPM) on a calibrated analogue dial, but digital displays are increasingly common. The word comes from Greek ''τάχος'' (''táchos'' "speed") and ''μέτρον'' (''métron'' "measure"). Essentially the words tachometer and speedometer have identical meaning: a device that measures speed. It is by arbitrary convention that in the automotive world one is used for engine revolutions and the other for vehicle speed. In formal engineering nomenclature, more precise terms are used to distinguish the two. History The first tachometer was described by an Donkin in a paper to the Royal Society of Arts in 1810 for which he was awarded the Gold medal of the society. This consisted of a bowl of mercury constructed in such a way that centrifugal force caused the level ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Rev Limiter
A rev limiter is a device fitted in modern vehicles that have internal combustion engines. They are intended to protect an engine by restricting its maximum rotational speed, measured in revolutions per minute (RPM). Rev limiters are pre-set by the engine manufacturer. There are also aftermarket units where a separate controller is installed using a custom RPM setting. A limiter prevents a vehicle's engine from being pushed beyond the manufacturer's limit known as the redline (literally the red line marked on the tachometer). At some point beyond the redline, engine damage may occur. Operation Limiters usually work by shutting off a component necessary for the combustion processes to occur. Compression-ignition engines use mechanical governors or limiters to shut off electronic fuel injectors. A spark-ignition engine may also shut off fuel or stop the spark ignition and some just reduce the engine's power by changing the spark timing. In the case of an automatic transmission ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Redline
Redline refers to the maximum engine speed at which an internal combustion engine or traction motor and its components are designed to operate without causing damage to the components themselves or other parts of the engine. The redline of an engine depends on various factors such as stroke, mass of the components, displacement, composition of components, and balance of components. The word is also used as a verb, meaning to ride or drive an automotive vehicle above the redline. The actual term ''redline'' comes from the red bars that are displayed on tachometers in cars starting at the rpm that denotes the redline for the specific engine. Operating an engine in this area is known as ''redlining''. Straying into this area usually does not mean instant engine failure, but may increase the chances of damaging the engine. Variation of redline The acceleration, or rate of change in piston velocity, is the limiting factor. The piston acceleration is directly proportional to the magn ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Tachograph
A tachograph is a device fitted to a vehicle that automatically records its speed and distance, together with the driver's activity selected from a choice of modes. The drive mode is activated automatically when the vehicle is in motion, and modern tachograph heads usually default to the other work mode upon coming to rest. The rest and availability modes can be manually selected by the driver whilst stationary. A tachograph system comprises a sender unit mounted to the vehicle gearbox, the tachograph head and a recording medium. Tachograph heads are of either analogue or digital types. All relevant vehicles manufactured in the EU since 1 May 2006 must be fitted with digital tachograph heads. The recording medium for analogue heads are wax coated paper discs, and for digital heads there are two recording mediums: internal memory (which can be read out with one of a variety of download devices into a so-called .ddd file) and digital driver cards containing a microchip with f ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Diedrich Uhlhorn
Diedrich Uhlhorn (3 June 1764 – 1837) was a German engineer, mechanic and inventor. Life Uhlhorn was an engineer, mechanic and inventor, who invented in 1817 the first mechanical tachometer. Between 1817 and 1830 he was inventor of the Presse Monétaire (level coin press known as Uhlhorn Press) which bears his name. He was married. Awards * Order of the Red Eagle Literature * Volker Benard-Wagenhoff, Konrad Schneider: ''Dieser unerschöpfliche, seltene Mann – Diedrich Uhlhorn und die moderne Münztechnik''. Grevenbroich 2009 * Otto Albert Bormann: Dietrich Uhlhorn (1764–1837). In: Rheinisch-Westfälische Wirtschaftsbiographien, Band I. Aschendorff, Münster 1931, pages 177-195. * Egbert Ritter von Hoyer: Uhlhorn, Diedrich. in: Allgemeine Deutsche Biographie (ADB). Band 39, Duncker & Humblot, Leipzig 1895, pages 166–168. See also *List of German inventors and discoverers ---- __NOTOC__ This is a list of German inventors and discoverers. The following ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Opto-isolator
An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical Signal, signals between two isolated circuits by using light. Opto-isolators prevent high voltages from affecting the system receiving the signal.Lee et al., p. 2. Commercially available opto-isolators withstand input-to-output voltages up to 10 Volt, kVHasse, p. 145. and voltage transients with speeds up to 25 kV/microsecond, μs.Joffe and Kai-Sang Lock, p. 279. A common type of opto-isolator consists of an Light emitting diode, LED and a phototransistor in the same opaque package. Other types of source-sensor combinations include LED-photodiode, LED-thyristor#photothyristors, LASCR, and lamp (electrical component), lamp-photoresistor pairs. Usually opto-isolators transfer digital (on-off) signals, but some techniques allow them to be used with analog signals. History The value of optically coupling a solid state light emitter to a semi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Revolutions Per Minute
Revolutions per minute (abbreviated rpm, RPM, rev/min, r/min, or with the notation min−1) is a unit of rotational speed or rotational frequency for rotating machines. Standards ISO 80000-3:2019 defines a unit of rotation as the dimensionless unit equal to 1, which it refers to as a revolution, but does not define the revolution as a unit. It defines a unit of rotational frequency equal to s−1. The superseded standard ISO 80000-3:2006 did however state with reference to the unit name 'one', symbol '1', that "The special name revolution, symbol r, for this unit is widely used in specifications on rotating machines." The International System of Units (SI) does not recognize rpm as a unit, and defines the unit of frequency, Hz, as equal to s−1. :\begin 1~&\text &&=& 60~&\text \\ \frac~&\text &&=& 1~&\text \end A corresponding but distinct quantity for describing rotation is angular velocity, for which the SI unit is the ra ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Diesel Engine
The diesel engine, named after Rudolf Diesel, is an internal combustion engine in which ignition of the fuel is caused by the elevated temperature of the air in the cylinder due to mechanical compression; thus, the diesel engine is a so-called compression-ignition engine (CI engine). This contrasts with engines using spark plug-ignition of the air-fuel mixture, such as a petrol engine (gasoline engine) or a gas engine (using a gaseous fuel like natural gas or liquefied petroleum gas). Diesel engines work by compressing only air, or air plus residual combustion gases from the exhaust (known as exhaust gas recirculation (EGR)). Air is inducted into the chamber during the intake stroke, and compressed during the compression stroke. This increases the air temperature inside the cylinder to such a high degree that atomised diesel fuel injected into the combustion chamber ignites. With the fuel being injected into the air just before combustion, the dispersion of the fuel is une ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Loop Detector
An induction or inductive loop is an electromagnetic In physics, electromagnetism is an interaction that occurs between particles with electric charge. It is the second-strongest of the four fundamental interactions, after the strong force, and it is the dominant force in the interactions of a ... communication or detection system which uses a moving magnet or an alternating current to Electromagnetic induction#Faraday's law, induce an electric current in a nearby wire. Induction loops are used for transmission and reception of communication signals, or for detection of metal objects in metal detectors or vehicle presence indicators. A common modern use for induction loops is to provide hearing assistance to hearing-aid users. Applications Vehicle detection Vehicle detection loops, called ''inductive-loop traffic detectors'', can detect vehicles passing or arriving at a certain point, for instance approaching a traffic light or in motorway traffic. An insulated, elec ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Engine Control Unit
An engine control unit (ECU), also commonly called an engine control module (ECM), is a type of electronic control unit that controls a series of actuators on an internal combustion engine to ensure optimal engine performance. It does this by reading values from a multitude of sensors within the engine bay, interpreting the data using multidimensional performance maps (called lookup tables), and adjusting the engine actuators. Before ECUs, air–fuel mixture, ignition timing, and idle speed were mechanically set and dynamically controlled by mechanical and pneumatic means. If the ECU has control over the fuel lines, then it is referred to as an electronic engine management system (EEMS). The fuel injection system has the major role of controlling the engine's fuel supply. The whole mechanism of the EEMS is controlled by a stack of sensors and actuators. Workings Control of air–fuel ratio Most modern engines use some type of fuel injection to deliver fuel to the cylinders. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Engine Management System
An engine control unit (ECU), also commonly called an engine control module (ECM), is a type of electronic control unit that controls a series of actuators on an internal combustion engine to ensure optimal engine performance. It does this by reading values from a multitude of sensors within the engine bay, interpreting the data using multidimensional performance maps (called lookup tables), and adjusting the engine actuators. Before ECUs, air–fuel mixture, ignition timing, and idle speed were mechanically set and dynamically controlled by mechanical and pneumatic means. If the ECU has control over the fuel lines, then it is referred to as an electronic engine management system (EEMS). The fuel injection system has the major role of controlling the engine's fuel supply. The whole mechanism of the EEMS is controlled by a stack of sensors and actuators. Workings Control of air–fuel ratio Most modern engines use some type of fuel injection to deliver fuel to the cylinders. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Camshaft
A camshaft is a shaft that contains a row of pointed cams, in order to convert rotational motion to reciprocating motion. Camshafts are used in piston engines (to operate the intake and exhaust valves), mechanically controlled ignition systems and early electric motor speed controllers. Camshafts in piston engines are usually made from steel or cast iron, and the shape of the cams greatly affects the engine's characteristics. History Trip hammers are one of the early uses of a form of cam to convert rotating motion, e.g. from a waterwheel, into the reciprocating motion of a hammer used in forging or to pound grain. Evidence for these exists back to the Han Dynasty in China, and they were widespread by the medieval period. The camshaft was described in 1206 by engineer Al-Jazari. He employed it as part of his automata, water-raising machines, and water clocks such as the castle clock. Once the rotative version of the steam engine was developed in the late 18th century, the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Alternator (auto)
An alternator is a type of electric generator used in modern automobiles to charge the battery and to power the electrical system when its engine is running. Until the 1960s, automobiles used DC dynamo generators with commutators. As silicon-diode rectifiers became widely available and affordable, the alternator gradually replaced the dynamo. This was encouraged by the increasing electrical power required for cars in this period, with increasing loads from larger headlamps, electric wipers, heated rear windows, and other accessories. History The modern type of vehicle alternators were first used in military applications during World War II, to power radio equipment on specialist vehicles. After the war, other vehicles with high electrical demands — such as ambulances and radio taxis — could also be fitted with optional alternators. Alternators were first introduced as standard equipment on a production car by the Chrysler Corporation on the Valiant in 1960, several years a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
