|
SAF-TE
In computer storage, SAF-TE (abbreviated from SCSI Accessed Fault-Tolerant Enclosure) is an industry standard to interface an enclosure in-band to a (parallel) SCSI subsystem in order to gain access to information or control for various elements and parameters. These include temperature, fan status, slot status (populated/empty), door status, power supplies, alarms, and indicators (e.g. LEDs, LCDs).SAF-TE IR ''1.0 Introduction'' Practically, any given SAF-TE device will only support a subset of all possible sensors or controls.SAF-TE IR ''3.0 SAF-TE Interface'' Scope Many RAID controllers can utilize a SAF-TE "activated" backplane by detecting a swapped drive (after a defect) and automatically starting a rebuild. A passive subsystem usually requires a manual rescan and rebuild. A SAF-TE device (SEP) is represented as a SCSI processor device that is polled every few seconds by e.g. the RAID controller software. Due to the low overhead required, impact on bus performance is neg ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
SCSI Enclosure Services
SCSI Enclosure Services (SES) is a protocol for more modern SCSI enclosure products. An initiator can communicate with the enclosure using a specialized set of SCSI commands to access power, cooling, and other non-data characteristics. SES devices There are two major classes of SES devices: * Attached enclosure services devices allow SES communication through a logical unit within one SCSI disk drive located in the enclosure. The disk-drive then communicates with the enclosure by some other method, the only commonly used one being Enclosure Services Interface (ESI). In fault-tolerant enclosures, more than one disk-drive slot has ESI enabled to allow SES communications to continue even after the failure of any of the disk-drives. The definition of the ESI protocols is owned by an ANSI committee and defined in their specifications ANSI SFF-8067 and SFF-8045. * Standalone enclosure services enclosures have a separate SES processor which occupies its own address on the SCSI bus. ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
International Blinking Pattern Interpretation
The International Blinking Pattern Interpretation (IBPI) is an internal computer hardware standard. It defines two items: # How SGPIO is interpreted into states for drives or slots on a backplane. # How light emitting diodes (LEDs) on a backplane should represent these states. IBPI was defined by the SFF-8489 specification of the Small Form Factor Special Interest Group in 2011. SGPIO has been adopted across the storage industry, and has in large replaced proprietary protocols such as SCSI Enclosure Services (SES) and SAF-TE. ''States'' for drives or slots can be, for example, ''empty'', ''failed'', ''rebuilding'', etc. The ''state'' of a drive or slot is determined by the host bus adapter, and is typically transmitted to the backplane through SGPIO-signals on a cable. Typical system architecture In a typical system architecture, the host bus adapter (HBA) connects to a backplane through a 4× iPass cable. The SGPIO-signals run inside this cable. The backplane may then optionally ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Backplane
A backplane (or "backplane system") is a group of electrical connectors in parallel with each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus. It is used as a backbone to connect several printed circuit boards together to make up a complete computer system. Backplanes commonly use a printed circuit board, but wire-wrapped backplanes have also been used in minicomputers and high-reliability applications. A backplane is generally differentiated from a motherboard by the lack of on-board processing and storage elements. A backplane uses plug-in cards for storage and processing. Usage Early microcomputer systems like the Altair 8800 used a backplane for the processor and expansion cards. Backplanes are normally used in preference to cables because of their greater reliability. In a cabled system, the cables need to be flexed every time that a card is added or removed from the system; this flexing even ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Disk Enclosure
A disk enclosure is a specialized casing designed to hold and power disk drives while providing a mechanism to allow them to communicate to one or more separate computers. Drive enclosures provide power to the drives therein and convert the data sent across their native data bus into a format usable by an external connection on the computer to which it is connected. In some cases, the conversion is as trivial as carrying a signal between different connector types. In others, it is complicated enough to require a separate embedded system to retransmit data over connector and signal of a different standard. Factory-assembled external hard disk drives, external DVD-ROM drives, and others consist of a storage device in a disk enclosure. Benefits Key benefits to using external disk enclosures include: *Adding additional storage space and media types to small form factor and laptop computers, as well as sealed embedded systems such as digital video recorders and video game con ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Computer Data Storage
Computer data storage is a technology consisting of computer components and Data storage, recording media that are used to retain digital data (computing), data. It is a core function and fundamental component of computers. The central processing unit (CPU) of a computer is what manipulates data by performing computations. In practice, almost all computers use a memory hierarchy, storage hierarchy, which puts fast but expensive and small storage options close to the CPU and slower but less expensive and larger options further away. Generally, the fast volatile technologies (which lose data when off power) are referred to as "memory", while slower persistent technologies are referred to as "storage". Even the first computer designs, Charles Babbage's Analytical Engine and Percy Ludgate's Analytical Machine, clearly distinguished between processing and memory (Babbage stored numbers as rotations of gears, while Ludgate stored numbers as displacements of rods in shuttles). Thi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Computer Data Storage
Computer data storage is a technology consisting of computer components and Data storage, recording media that are used to retain digital data (computing), data. It is a core function and fundamental component of computers. The central processing unit (CPU) of a computer is what manipulates data by performing computations. In practice, almost all computers use a memory hierarchy, storage hierarchy, which puts fast but expensive and small storage options close to the CPU and slower but less expensive and larger options further away. Generally, the fast volatile technologies (which lose data when off power) are referred to as "memory", while slower persistent technologies are referred to as "storage". Even the first computer designs, Charles Babbage's Analytical Engine and Percy Ludgate's Analytical Machine, clearly distinguished between processing and memory (Babbage stored numbers as rotations of gears, while Ludgate stored numbers as displacements of rods in shuttles). Thi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
SGPIO
Serial general purpose input/output (SGPIO) is a four-signal (or four-wire) bus used between a host bus adapter (HBA) and a backplane. Of the four signals, three are driven by the HBA and one by the backplane. Typically, the HBA is a storage controller located inside a server, desktop, rack or workstation computer that interfaces with hard disk drives or solid state drives to store and retrieve data. It is considered an extension of the general-purpose input/output (GPIO) concept. The SGPIO specification is maintained by the Small Form Factor Committee in the SFF-8485 standard. The International Blinking Pattern Interpretation indicates how SGPIO signals are interpreted into blinking light-emitting diodes (LEDs) on disk arrays and storage back-planes. History SGPIO was developed as an engineering collaboration between American Megatrends Inc, at the time makers of back-planes, and LSI-Logic in 2004. SGPIO was later published by the SFF committee as specificatioSFF-8485 Host ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Out-of-band Signaling
In telecommunication, signaling is the use of signals for controlling communications. This may constitute an information exchange concerning the establishment and control of a telecommunication circuit and the management of the network. Classification Signaling systems may be classified based on several principal characteristics. In-band and out-of-band signaling In the public switched telephone network (PSTN), in-band signaling is the exchange of call control information within the same physical channel, or within the same frequency band, that the telephone call itself is using. An example is dual-tone multi-frequency signaling (DTMF), which is used on most telephone lines to customer premises. Out-of-band signaling is telecommunication signaling on a dedicated channel separate from that used for the telephone call. Out-of-band signaling has been used since Signaling System No. 6 (SS6) was introduced in the 1970s, and also in Signalling System No. 7 (SS7) in 1980 which became ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
SCSI Command
In SCSI computer storage, computers and storage devices use a client-server model of communication. The computer is a client which requests the storage device to perform a service, e.g., to read or write data. The SCSI command architecture was originally defined for parallel SCSI buses but has been carried forward with minimal change for use with Fibre Channel, iSCSI, Serial Attached SCSI, and other transport layers. In the SCSI protocol, the initiator An initiator can refer to: * A person who instigates something. * Modulated neutron initiator, a neutron source used in some nuclear weapons ** Initiator, an Explosive booster ** Initiator, the first Nuclear chain reaction * Pyrotechnic initiato ... sends a SCSI command information unit to the target device. Data information units may then be transferred between the computer and device. Finally, the device sends a response information unit to the computer. SCSI commands are sent in a command descriptor block (CDB), which ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Intel
Intel Corporation is an American multinational corporation and technology company headquartered in Santa Clara, California. It is the world's largest semiconductor chip manufacturer by revenue, and is one of the developers of the x86 series of instruction sets, the instruction sets found in most personal computers (PCs). Incorporated in Delaware, Intel ranked No. 45 in the 2020 ''Fortune'' 500 list of the largest United States corporations by total revenue for nearly a decade, from 2007 to 2016 fiscal years. Intel supplies microprocessors for computer system manufacturers such as Acer, Lenovo, HP, and Dell. Intel also manufactures motherboard chipsets, network interface controllers and integrated circuits, flash memory, graphics chips, embedded processors and other devices related to communications and computing. Intel (''int''egrated and ''el''ectronics) was founded on July 18, 1968, by semiconductor pioneers Gordon Moore (of Moore's law) and Robert Noyce ( ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Seagate Technology
Seagate Technology Holdings plc is an American data storage company. It was incorporated in 1978 as Shugart Technology and commenced business in 1979. Since 2010, the company has been incorporated in Dublin, Ireland, with operational headquarters in Fremont, California, United States. Seagate developed the first 5.25-inch hard disk drive (HDD), the 5-megabyte ST-506, in 1980. They were a major supplier in the microcomputer market during the 1980s, especially after the introduction of the IBM XT in 1983. Much of their growth has come through their acquisition of competitors. In 1989, Seagate acquired Control Data Corporation's Imprimis division, the makers of CDC's HDD products. Seagate acquired Conner Peripherals in 1996, Maxtor in 2006, and Samsung's HDD business in 2011. Today, Seagate, along with its competitor Western Digital, dominates the HDD market. History Founding as Shugart Technology Seagate Technology (then called Shugart Technology) was incorporated on No ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
