HOME
*





One-way Delay
End-to-end delay or one-way delay (OWD) refers to the time taken for a Packet (information technology), packet to be transmitted across a computer network, network from source to destination. It is a common term in IP network monitoring, and differs from Round-trip delay time, round-trip time (RTT) in that only path in the one direction from source to destination is measured. Measurement The Ping (networking utility), ping utility measures the RTT, that is, the time to go and come back to a host. Half the RTT is often used as an approximation of OWD but this assumes that the forward and back paths are the same in terms of congestion, number of hops, or quality of service (QoS). This is not always a good assumption. To avoid such problems, the OWD may be measured directly. Direct OWDs may be measured between two points ''A'' and ''B'' of an IP network through the use of synchronized clocks; ''A'' records a timestamp on the packet and sends it to ''B'', which notes the receiving time ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


Packet (information Technology)
In telecommunications and computer networking, a network packet is a formatted unit of data carried by a packet-switched network. A packet consists of control information and user data; the latter is also known as the ''payload''. Control information provides data for delivering the payload (e.g., source and destination network addresses, error detection codes, or sequencing information). Typically, control information is found in packet headers and trailers. In packet switching, the bandwidth of the transmission medium is shared between multiple communication sessions, in contrast to circuit switching, in which circuits are preallocated for the duration of one session and data is typically transmitted as a continuous bit stream. Terminology In the seven-layer OSI model of computer networking, ''packet'' strictly refers to a protocol data unit at layer 3, the network layer. A data unit at layer 2, the data link layer, is a ''frame''. In layer 4, the transport layer, the data u ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


Probability Mass Function
In probability and statistics, a probability mass function is a function that gives the probability that a discrete random variable is exactly equal to some value. Sometimes it is also known as the discrete density function. The probability mass function is often the primary means of defining a discrete probability distribution, and such functions exist for either scalar or multivariate random variables whose domain is discrete. A probability mass function differs from a probability density function (PDF) in that the latter is associated with continuous rather than discrete random variables. A PDF must be integrated over an interval to yield a probability. The value of the random variable having the largest probability mass is called the mode. Formal definition Probability mass function is the probability distribution of a discrete random variable, and provides the possible values and their associated probabilities. It is the function p: \R \to ,1/math> defined by for -\inf ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


Network Delay
Network delay is a design and performance characteristic of a telecommunications network. It specifies the latency for a bit of data to travel across the network from one communication endpoint to another. It is typically measured in multiples or fractions of a second. Delay may differ slightly, depending on the location of the specific pair of communicating endpoints. Engineers usually report both the maximum and average delay, and they divide the delay into several parts: * Processing delay time it takes a router to process the packet header * Queuing delay time the packet spends in routing queues * Transmission delay time it takes to push the packet's bits onto the link * Propagation delay time for a signal to propagate through the media A certain minimum level of delay is experienced by signals due to the time it takes to transmit a packet serially through a link. This delay is extended by more variable levels of delay due to network congestion. IP network delays can range ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Age Of Information
The Information Age (also known as the Computer Age, Digital Age, Silicon Age, or New Media Age) is a historical period that began in the mid-20th century. It is characterized by a rapid shift from traditional industries, as established during the Industrial Revolution, to an economy centered on information technology. The onset of the Information Age has been linked to the development of the transistor in 1947, the optical amplifier in 1957, and Unix time, which began on January 1, 1970 and serves as the basis for Coordinated Universal Time and the Network Time Protocol. These technological advances have had a significant impact on the way information is processed and transmitted. According to the United Nations Public Administration Network, the Information Age was formed by capitalizing on computer microminiaturization advances, which led to modernized information systems and internet communications as the driving force of social evolution. Overview of early developments ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  




Queuing Delay
In telecommunication and computer engineering, the queuing delay or queueing delay is the time a job waits in a queue until it can be executed. It is a key component of network delay. In a switched network, queuing delay is the time between the completion of signaling by the call originator and the arrival of a ringing signal at the call receiver. Queuing delay may be caused by delays at the originating switch, intermediate switches, or the call receiver servicing switch. In a data network, queuing delay is the sum of the delays between the request for service and the establishment of a circuit to the called data terminal equipment (DTE). In a packet-switched network, queuing delay is the sum of the delays encountered by a packet between the time of insertion into the network and the time of delivery to the address. Router processing This term is most often used in reference to routers. When packets arrive at a router, they have to be processed and transmitted. A router can only ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Processing Delay
Processing is a free graphical library and integrated development environment (IDE) built for the electronic arts, new media art, and visual design communities with the purpose of teaching non-programmers the fundamentals of computer programming in a visual context. Processing uses the Java language, with additional simplifications such as additional classes and aliased mathematical functions and operations. It also provides a graphical user interface for simplifying the compilation and execution stage. The Processing language and IDE have been the precursor to other projects including Arduino and Wiring. History The project was initiated in 2001 by Casey Reas and Ben Fry, both formerly of the Aesthetics and Computation Group at the MIT Media Lab. In 2012, they started the Processing Foundation along with Daniel Shiffman, who joined as a third project lead. Johanna Hedva joined the Foundation in 2014 as Director of Advocacy. Originally, Processing had used the domain proce55 ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Propagation Delay
Propagation delay is the time duration taken for a signal to reach its destination. It can relate to networking, electronics or physics. ''Hold time'' is the minimum interval required for the logic level to remain on the input after triggering edge of the clock pulse. Networking In computer networks, propagation delay is the amount of time it takes for the head of the signal to travel from the sender to the receiver. It can be computed as the ratio between the link length and the propagation speed over the specific medium. Propagation delay is equal to ''d / s'' where ''d'' is the distance and ''s'' is the wave propagation speed. In wireless communication, ''s''=''c'', i.e. the speed of light. In copper wire, the speed ''s'' generally ranges from .59c to .77c. This delay is the major obstacle in the development of high-speed computers and is called the interconnect bottleneck in IC systems. Electronics In electronics, digital circuits and digital electronics, the propagati ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


Transmission Delay
In a network based on packet switching, transmission delay (or store-and-forward delay, also known as packetization delay) is the amount of time required to push all the packet's bits into the wire. In other words, this is the delay caused by the data-rate of the link. Transmission delay is a function of the packet's length and has nothing to do with the distance between the two nodes. This delay is proportional to the packet's length in bits, It is given by the following formula: :D_T = N/R seconds where :D_T is the transmission delay in seconds :''N'' is the number of bits, and :''R'' is the rate of transmission (say in bits per second) Most packet switched networks use store-and-forward transmission at the input of the link. A switch using store-and-forward transmission will receive (save) the entire packet to the buffer and check it for CRC errors or other problems before sending the first bit of the packet into the outbound link. Thus, store-and-forward packet switches int ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Minimum-Pairs Protocol
The minimum-pairs (or MP) is an active measurement protocol to estimate in real-time the smaller of the forward and reverse one-way network delays (OWDs). It is designed to work in hostile environments, where a set of three network nodes can estimate an upper-bound OWD between themselves and a fourth untrusted node. All four nodes must cooperate, though honest cooperation from the fourth node is not required. The objective is to conduct such estimates without involving the untrusted nodes in clock synchronization, and in a manner more accurate than simply half the round-trip time (RTT). The MP protocol can be used in delay-sensitive applications (such as placing content delivery network replicas) or for secure Internet geolocation. Methodology The MP protocol requires the three trusted network nodes to synchronize their clocks, and securely have access to their public keys, which could be achieved through a closed public key infrastructure (PKI) system. The untrusted node need ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

Computer Network
A computer network is a set of computers sharing resources located on or provided by network nodes. The computers use common communication protocols over digital interconnections to communicate with each other. These interconnections are made up of telecommunication network technologies, based on physically wired, optical, and wireless radio-frequency methods that may be arranged in a variety of network topologies. The nodes of a computer network can include personal computers, servers, networking hardware, or other specialised or general-purpose hosts. They are identified by network addresses, and may have hostnames. Hostnames serve as memorable labels for the nodes, rarely changed after initial assignment. Network addresses serve for locating and identifying the nodes by communication protocols such as the Internet Protocol. Computer networks may be classified by many criteria, including the transmission medium used to carry signals, bandwidth, communications pro ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


Packet Loss
Packet loss occurs when one or more packets of data travelling across a computer network fail to reach their destination. Packet loss is either caused by errors in data transmission, typically across wireless networks, or network congestion.Kurose, J.F. & Ross, K.W. (2010). ''Computer Networking: A Top-Down Approach''. New York: Addison-Wesley. Packet loss is measured as a percentage of packets lost with respect to packets sent. The Transmission Control Protocol (TCP) detects packet loss and performs retransmissions to ensure reliable messaging. Packet loss in a TCP connection is also used to avoid congestion and thus produces an intentionally reduced throughput for the connection. In real-time applications like streaming media or online games, packet loss can affect a user's quality of experience (QoE). Causes The Internet Protocol (IP) is designed according to the end-to-end principle as a best-effort delivery service, with the intention of keeping the logic routers mus ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]  


picture info

IP Network
The Internet protocol suite, commonly known as TCP/IP, is a framework for organizing the set of communication protocols used in the Internet and similar computer networks according to functional criteria. The foundational protocols in the suite are the Transmission Control Protocol (TCP), the User Datagram Protocol (UDP), and the Internet Protocol (IP). In the development of this networking model, early versions of it were known as the Department of Defense (DoD) model because the research and development were funded by the United States Department of Defense through DARPA. The Internet protocol suite provides End-to-end principle, end-to-end data communication specifying how data should be packetized, addressed, transmitted, routing, routed, and received. This functionality is organized into four abstraction layers, which classify all related protocols according to each protocol's scope of networking. An implementation of the layers for a particular application forms a protoco ...
[...More Info...]      
[...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]