|
NFC-WI
NFC-WI is NFC wired interface having 2 wires SIGIN (signal-in) and SIGOUT (signal-out). It is also called S2C (SignalIn/SignalOut Connection) interface. In 2006, ECMA standardized the NFC wired interface with specification ECMA-373 (ECMA,2006). It has three modes of operation: off, wired and virtual mode. In off mode, there is no communication with the SE. In wired mode, the SE is visible to the internal NFC controller. In virtual mode, the SE is visible to external RF readers. These modes are naturally mutually exclusive. See also * Single Wire Protocol * Near field communication Near-field communication (NFC) is a set of communication protocols that enables communication between two electronic devices over a distance of 4 cm (1 in) or less. NFC offers a low-speed connection through a simple setup that can be u ... References Mobile phone standards {{telecom-stub ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single Wire Protocol
The Single Wire Protocol (SWP) is a specification for a single-wire connection between the SIM card and a near field communication (NFC) chip in a cell phone. It was under final review by the European Telecommunications Standards Institute (ETSI). SWP is an interface between contactless frontend (CLF) and universal integrated circuit card (UICC/SIM card chip). It is a contact-based protocol that is used for contactless communication. C6 pin of UICC is connected to CLF for SWP support. It is a bit-oriented full duplex protocol i.e. at the same time transmission as well as reception is possible. CLF acts as a master and UICC as a slave. CLF provides the UICC with energy, a transmission clock, data, and a signal for bus management. The data to be transmitted are represented by the binary states of voltage and current on the single wire. See also * 1-Wire 1-Wire is a device communications bus system designed by Dallas Semiconductor Corp. that provides low-speed (16.3 kbit/s) data, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Near Field Communication
Near-field communication (NFC) is a set of communication protocols that enables communication between two electronic devices over a distance of 4 cm (1 in) or less. NFC offers a low-speed connection through a simple setup that can be used to bootstrap more-capable wireless connections. Like other "proximity card" technologies, NFC is based on inductive coupling between two so-called antennas present on NFC-enabled devices—for example a smartphone and a printer—communicating in one or both directions, using a frequency of 13.56 MHz in the globally available unlicensed radio frequency ISM band using the ISO/IEC 18000-3 air interface standard at data rates ranging from 106 to 424 kbit/s. The standards were provided by the NFC Forum. The forum was responsible for promoting the technology and setting standards and certifies device compliance. Secure communications are available by applying encryption algorithms as is done for credit cards and if they fit the crite ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Interface (computing)
In computing, an interface is a shared boundary across which two or more separate components of a computer system exchange information. The exchange can be between software, computer hardware, peripheral devices, humans, and combinations of these. Some computer hardware devices, such as a touchscreen, can both send and receive data through the interface, while others such as a mouse or microphone may only provide an interface to send data to a given system. Hardware interfaces Hardware interfaces exist in many components, such as the various buses, storage devices, other I/O devices, etc. A hardware interface is described by the mechanical, electrical, and logical signals at the interface and the protocol for sequencing them (sometimes called signaling). See also: A standard interface, such as SCSI, decouples the design and introduction of computing hardware, such as I/O devices, from the design and introduction of other components of a computing system, thereby allowin ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ecma International
Ecma International () is a nonprofit standards organization for information and communication systems. It acquired its current name in 1994, when the European Computer Manufacturers Association (ECMA) changed its name to reflect the organization's global reach and activities. As a consequence, the name is no longer considered an acronym and no longer uses full capitalization. The organization was founded in 1961 to standardize computer systems in Europe. Membership is open to large and small companies worldwide that produce, market, or develop computer or communication systems, and have interest and experience in the areas addressed by the group's technical bodies. It is located in Geneva. Aims Ecma aims to develop standards and technical reports to facilitate and standardize the use of information communication technology and consumer electronics; encourage the correct use of standards by influencing the environment in which they are applied; and publish these standards a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
