|
Futtock Shrouds
{{for, 1970 British television comedy, Futtocks End Futtock shrouds are rope, wire or chain links in the rigging of a traditional square rigged ship. They run from the outer edges of a top downwards and inwards to a point on the mast or lower shrouds, and carry the load of the shrouds that rise from the edge of the top. This prevents any tendency of the top itself to tilt relative to the mast. Climbing a ship's rigging In the most traditional ships, the futtock shrouds can be used to gain access to the tops. Sailors ascend ratlines on the ordinary shrouds until nearly at the top, then transfer to the futtock shrouds which will be reaching upwards and outwards above them. Using the futtock shrouds involves climbing the underside of an overhanging rope at about 45 degrees. Futtock shrouds may or may not have ratlines. As well as climbing the futtock shrouds, most ships also allowed access to the top through the " lubber's hole" at the tip of the ordinary ratlines. However, this ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Diagram Of Futtock Shrouds Beneath The Top Of A Square Rigged Ship
A diagram is a symbolic representation of information using visualization techniques. Diagrams have been used since prehistoric times on walls of caves, but became more prevalent during the Enlightenment. Sometimes, the technique uses a three-dimensional visualization which is then projected onto a two-dimensional surface. The word ''graph'' is sometimes used as a synonym for diagram. Overview The term "diagram" in its commonly used sense can have a general or specific meaning: * ''visual information device'' : Like the term " illustration", "diagram" is used as a collective term standing for the whole class of technical genres, including graphs, technical drawings and tables. * ''specific kind of visual display'' : This is the genre that shows qualitative data with shapes that are connected by lines, arrows, or other visual links. In science the term is used in both ways. For example, Anderson (1997) stated more generally: "diagrams are pictorial, yet abstract, representa ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Square Rigged
Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called ''yards'' and their tips, outside the lifts, are called the ''yardarms.'' A ship mainly rigged so is called a square-rigger. The square rig is aerodynamically the most efficient running rig (i.e., sailing downwind), and stayed popular on ocean-going sailing ships until the end of the Age of Sail. The last commercial sailing ships, windjammers, were usually square-rigged four-masted barques. History The oldest archaeological evidence of use of a square-rig on a vessel is an image on a clay disk from Mesopotamia from 5000 BC. Single sail square rigs were used by the ancient Egyptians, the Phoenicians, the Greeks, the Romans, and the Celts. Later the Scandinavians, the Germanic peoples, and the Slavs adopted the single square-rigged sail, with it be ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Top (sailing Ship)
The top on a traditional square rigged ship, is the platform at the upper end of each (lower) mast. This is not the masthead "crow's nest" of the popular imagination – above the mainmast (for example) is the main-topmast, main-topgallant-mast and main-royal-mast, so that the top is actually about 1/4 to 1/3 of the way up the mast as a whole. The main purpose of the top is to anchor the shrouds of the topmast that extends above it. Shrouds down to the side of the hull would be at too acute an angle from the mast, so crosstrees running sideways out from the mast to spread the topmasts shrouds. These crosstrees rests on two trestle trees running fore and aft, which themself are placed on top of the cheeks of hounds, bolted to the sides of the mast. Placing a few timbers onto the crosstrees produces a useful platform, the top. The futtock shrouds carry the load of the upper shrouds into the mast below. At the upper end of the topmast and topgallant, there is a similar situation r ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Mast (sailing)
The mast of a sailing vessel is a tall spar, or arrangement of spars, erected more or less vertically on the centre-line of a ship or boat. Its purposes include carrying sails, spars, and derricks, and giving necessary height to a navigation light, look-out position, signal yard, control position, radio aerial or signal lamp. Large ships have several masts, with the size and configuration depending on the style of ship. Nearly all sailing masts are guyed. Until the mid-19th century, all vessels' masts were made of wood formed from a single or several pieces of timber which typically consisted of the trunk of a conifer tree. From the 16th century, vessels were often built of a size requiring masts taller and thicker than could be made from single tree trunks. On these larger vessels, to achieve the required height, the masts were built from up to four sections (also called masts). From lowest to highest, these were called: lower, top, topgallant, and royal masts. Giving the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Shroud (sailing)
On a sailing boat, the shrouds are pieces of standing rigging which hold the mast up from side to side. There is frequently more than one shroud on each side of the boat. Usually a shroud will connect at the top of the mast, and additional shrouds might connect partway down the mast, depending on the design of the boat. Shrouds terminate at their bottom ends at the chain plates, which are tied into the hull. They are sometimes held outboard by channels, a ledge that keeps the shrouds clear of the gunwales.''The Lore of Ships,'' ed. by Bengt Kihlberg. Göteborg :Tre tryckare & New York: Holt, Rinehart & Winston, 1963. Shrouds are attached symmetrically on both the port and starboard sides. For those shrouds which attach high up the mast, a structure projecting from the mast must be used to increase the angle of the shroud at the attachment point, providing more support to the mast. On most sailing boats, such structures are called spreaders, and the shrouds they hold continue ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ratlines
Ratlines () are lengths of thin line tied between the shrouds of a sailing ship to form a ladder. Found on all square-rigged ships, whose crews must go aloft to stow the square sails, they also appear on larger fore-and-aft rigged vessels to aid in repairs aloft or conduct a lookout from above. Rat-boards Rat-boards are lower courses in a ratline, often made of slats of wood (battens) for support where the distance between shrouds is greatest. In some instances holes in these slats guide and organise low-tension lines between the deck and the rig. Knotting See also * Footrope Each yard on a square or gaff rigged sailing ship is equipped with a footrope for sailors to stand on while setting or stowing the sails. Formerly, the footrope was the rope sewn along the lower edge of a square sail, and the rope below the ya ... References {{Sail Types Sailing rigs and rigging ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Jacob's Ladder (nautical)
The term Jacob's ladder, used on a ship, applies to two kinds of rope ladders. The first is a flexible hanging ladder. It consists of vertical ropes or chains supporting horizontal, historically round and wooden, rungs. Today, flat runged flexible ladders are also called Jacob's ladders. The name is commonly used without the apostrophe (Jacobs ladder). They are used to allow access over the side of ships and as a result Pilot ladders are often incorrectly referred to as Jacob's ladders. A pilot ladder has specific regulations on step size, spacing and the use of spreaders. It is the use of spreaders in a pilot ladder that distinguishes it from a Jacob's ladder. Spreaders are long treads that extend well past the vertical ropes to stop the ladder from twisting about its long axis (possible when a ship rolls and the ladder is no longer in contact with the ship's side) with the person possibly becoming trapped between the ship's side and the ladder. When not being used, the ladd ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Catharpin
Catharpin is a nautical term, which is often pronounced ''cat-harping''. It describes one of the short ropes or iron clamps used to brace in the shrouds toward the masts so as to give a freer sweep to the yards. The expression has been borrowed to refer to short lashings which hold halyards away from the masts of sailing yachts by tying to adjacent shrouds so as to prevent noise and fraying by the wind. Example from ''Two Years Before the Mast'' by Richard Henry Dana: "All the hides, too, that came down in the boats were soaked with water, and unfit to put below, so that we were obliged to trice them up to dry, in the intervals of sunshine or wind, upon all parts of the vessel . . . The rail, fore and aft, the windlass, capstan, the sides of the ship, and every vacant place on deck, were covered with wet hides, on the least sign of an interval for drying. Our ship was nothing but a mass of hides, from the cat-harpins to the water's edge, and from the jib-boom-end to the taffrail ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
.jpg "Click for more on -> Mast (sailing)")
.jpg "Click for more on -> Ratlines")