|
Ethernet Over SDH
Ethernet Over SDH (EoS or EoSDH) or Ethernet over SONET refers to a set of protocols which allow Ethernet traffic to be carried over synchronous digital hierarchy networks in an efficient and flexible way. The same functions are available using SONET. Ethernet frames which are to be sent on the SDH link are sent through an "encapsulation" block (typically Generic Framing Procedure or GFP) to create a synchronous stream of data from the asynchronous Ethernet packets. The synchronous stream of encapsulated data is then passed through a mapping block which typically uses virtual concatenation (VCAT) to route the stream of bits over one or more SDH paths. As this is byte interleaved, it provides a better level of security compared to other mechanisms for Ethernet transport. After traversing SDH paths, the traffic is processed in the reverse fashion: virtual concatenation path processing to recreate the original synchronous byte stream, followed by decapsulation to converting the synch ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ethernet
Ethernet () is a family of wired computer networking technologies commonly used in local area networks (LAN), metropolitan area networks (MAN) and wide area networks (WAN). It was commercially introduced in 1980 and first standardized in 1983 as IEEE 802.3. Ethernet has since been refined to support higher bit rates, a greater number of nodes, and longer link distances, but retains much backward compatibility. Over time, Ethernet has largely replaced competing wired LAN technologies such as Token Ring, FDDI and ARCNET. The original 10BASE5 Ethernet uses coaxial cable as a shared medium, while the newer Ethernet variants use twisted pair and fiber optic links in conjunction with switches. Over the course of its history, Ethernet data transfer rates have been increased from the original to the latest , with rates up to under development. The Ethernet standards include several wiring and signaling variants of the OSI physical layer. Systems communicating over Ethernet ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Synchronous Digital Hierarchy
Synchronous optical networking (SONET) and synchronous digital hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates data can also be transferred via an electrical interface. The method was developed to replace the plesiochronous digital hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without the problems of synchronization. SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications (e.g., DS1, DS3) from a variety of different sources, but they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant that each ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Generic Framing Procedure
{{Unreferenced, date=December 2009 Generic Framing Procedure (GFP) is a multiplexing technique defined by ITU-T G.7041. This allows mapping of variable length, higher-layer client signals over a circuit switched transport network like OTN, SDH/SONET or PDH. The client signals can be protocol data unit (PDU) oriented (like IP/ PPP or Ethernet Media Access Control) or can be block-code oriented (like Fibre Channel). There are two modes of GFP: Generic Framing Procedure - Framed (GFP-F) and Generic Framing Procedure - Transparent (GFP-T): * GFP-F maps each client frame into a single GFP frame. GFP-F is used where the client signal is framed or packetized by the client protocol. * GFP-T, on the other hand, allows mapping of multiple 8B/10B block-coded client data streams into an efficient 64B/65B block code for transport within a GFP frame. GFP utilizes a length/ HEC-based frame delineation mechanism that is more robust than that used by High-Level Data Link Control (HDLC), which ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Virtual Concatenation
Virtual concatenation (VCAT) is an inverse multiplexing technique creating a large capacity payload container distributed over multiple smaller capacity TDM signals. These signals may be transported or routed independently. Virtual concatenation has been defined for SONET/SDH, OTN and PDH path signals. Alternate SONET/SDH concatenation techniques are contiguous concatenation and arbitrary concatenation. Variable bit data streaming Virtual concatenation is considered the primary enhancement to voice optimized SONET/SDH, in order to support the transport of variable bit data streams. Other recent SONET/SDH enhancements include Link Capacity Adjustment Scheme (LCAS), and the Generic Framing Procedure (GFP). In conjunction with LCAS and GFP, Virtual Concatenation gives the advantage of splitting the required bandwidth equally among a set number of sub paths called Virtual Tributaries (VT). The Virtual Concatenation is specified in ITU-T Recommendations G.707 (2007) and G.783 (200 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
LCAS
Link Capacity Adjustment Scheme or LCAS is a method to dynamically increase or decrease the bandwidth of virtual concatenated containers. The LCAS protocol is specified in ITU-T The ITU Telecommunication Standardization Sector (ITU-T) is one of the three sectors (divisions or units) of the International Telecommunication Union (ITU). It is responsible for coordinating standards for telecommunications and Information Commu ... G.7042. It allows on-demand increase or decrease of the bandwidth of the virtual concatenated group in a ''hitless'' manner. This brings ''bandwidth-on-demand'' capability for data clients like Ethernet when mapped into TDM containers. LCAS is also able to temporarily remove failed members from the virtual concatenation group. A failed member will automatically cause a decrease of the bandwidth and after repair the bandwidth will increase again in a hitless fashion. Together with diverse routing this provides survivability of data traffic without requiring ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Packet Over SONET
Packet over SONET/SDH, abbreviated POS, is a communications protocol for transmitting packets in the form of the Point to Point Protocol (PPP) over SDH or SONET, which are both standard protocols for communicating digital information using lasers or light emitting diodes (LEDs) over optical fibre at high line rates. POS is defined by RFC 2615 as PPP over SONET/SDH. PPP is the Point to Point Protocol that was designed as a standard method of communicating over point-to-point links. Since SONET/SDH uses point-to-point circuits, PPP is well suited for use over these links. Scrambling is performed during insertion of the PPP packets into the SONET/SDH frame to solve various security attacks including denial-of-service attacks and the imitation of SONET/SDH alarms. This modification was justified as cost-effective because the scrambling algorithm was already used by the standard used to transport ATM cells over SONET/SDH. However, scrambling can optionally be disabled to allow a node ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Synchronous Optical Networking
Synchronous optical networking (SONET) and synchronous digital hierarchy (SDH) are standardized protocols that transfer multiple digital bit streams synchronously over optical fiber using lasers or highly coherent light from light-emitting diodes (LEDs). At low transmission rates data can also be transferred via an electrical interface. The method was developed to replace the plesiochronous digital hierarchy (PDH) system for transporting large amounts of telephone calls and data traffic over the same fiber without the problems of synchronization. SONET and SDH, which are essentially the same, were originally designed to transport circuit mode communications (e.g., DS1, DS3) from a variety of different sources, but they were primarily designed to support real-time, uncompressed, circuit-switched voice encoded in PCM format. The primary difficulty in doing this prior to SONET/SDH was that the synchronization sources of these various circuits were different. This meant that each ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
