|
Drooped Leading Edge
A leading-edge cuff is a fixed aerodynamic wing device employed on fixed-wing aircraft to improve the stall and spin characteristics. Cuffs may be either factory-designed or an after-market add-on modification.Crane, Dale: ''Dictionary of Aeronautical Terms, third edition'', page 144. Aviation Supplies & Academics, 1997. A leading-edge cuff is a wing leading-edge modification, usually a lightly drooped outboard leading-edge extension. In most cases of outboard leading-edge modification, the wing cuff starts about 50–70% half-span and spans the outer leading edge of the wing. The main goal is to produce a more gradual and gentler stall onset, without any spin departure tendency, particularly where the original wing has a sharp/asymmetric stall behaviour with a passive, non-moving, low-cost device that would have a minimal impact on performance. A further benefit is to lowering stall speed, with lower approach speeds and shorter landing distances. They may also, depending on ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Vortilon
Vortilons are fixed aerodynamic devices on aircraft wings used to improve handling at low speeds. The vortilon was invented by aerodynamicists working at Douglas Aircraft who had previously developed the engine pylons for the Douglas DC-8. The original pylons which wrapped around the leading edge of the wing had to be cut back to reduce excessive cruise drag. Wind tunnel testing of the next Douglas commercial aircraft, the Douglas DC-9 which had no under-wing engines, showed a cutback engine pylon would be beneficial to wing lift and upwash at the tail at the low speed stall. The pylon was reduced in size and became the vortilon (VORTex-generating-pYLON). Vortilons consist of one or more flat plates attached to the underside of the wing near its leading edge, aligned with the flight direction. When the speed is reduced and the aircraft approaches stall, the local flow at the leading edge is diverted outwards; this spanwise component of velocity around the vortilon creates a vorte ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Leading-edge Slat
Slats are aerodynamic surfaces on the leading edge of the wing of a fixed-wing aircraft which, when deployed, allow the wing to operate at a higher angle of attack. A higher coefficient of lift is produced as a result of angle of attack and speed, so by deploying slats an aircraft can fly at slower speeds, or take off and land in shorter distances. They are used during takeoff and landing or while performing low speed maneuvers which may take the aircraft close to a stall, they are retracted in normal flight to minimize drag. Slats are one high-lift device used on high speed turbojet aircraft, trailing edge flap systems running along the trailing edge of the wing are common on all aircraft. Types Types include: ;Automatic: The spring-loaded slat lies flush with the wing leading edge, held in place by the force of the air acting on them. As the aircraft slows down, the aerodynamic force is reduced and the springs extend the slats. Sometimes referred to as Handley-Page sla ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Leading-edge Droop Flap
The leading-edge droop flap is a device on the leading edge of aircraft wings designed to improve airflow at high pitch angles (high angle of attack). The droop flap is similar to the leading-edge slat and the Krueger flap, but with the difference that the entire leading edge section rotates downwards, whereas the slat and Krueger flap are panels which move away from the wing leading edge when it is deployed.Norris & Wagner (2005), pp.67-68 Location A leading-edge droop flap comprises the rounded front part of a wing, in movable form. The Airbus A380 has droop flaps between the fuselage and each inboard engine, at the leading edge of the thickest part of each wing. Early variants of the Hawker Siddeley Trident had two droop flaps on the outboard of each wing and a Krueger flap on the section closest to the fuselage. [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Wing Fence
Wing fences, also known as boundary layer fences and potential fences are fixed aerodynamic devices attached to aircraft wings. Often seen on swept-wing aircraft, wing fences are flat plates fixed to the upper surfaces parallel to the wing chord and in line with the free stream airflow, typically wrapping around the leading edge. By obstructing span-wise airflow along the wing, they prevent the entire wing from stalling at once, as opposed to wingtip devices, which increase aerodynamic efficiency by seeking to recover wing vortex energy. As a swept-wing aircraft slows toward the stall speed of the wing, the angle of the leading edge forces some of the airflow sidewise, toward the wing tip. This process is progressive: airflow near the middle of the wing is affected not only by the leading edge angle, but also the spanwise airflow from the wing root. At the wing tip the airflow can end up being almost all spanwise, as opposed to front-to-back over the wing, meaning that the ef ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
STOL Kits
A short takeoff and landing (STOL) aircraft is a conventional fixed-wing aircraft that has short runway requirements for takeoff and landing. Many STOL-designed aircraft also feature various arrangements for use on airstrips with harsh conditions (such as high altitude or ice). STOL aircraft, including those used in scheduled passenger airline operations, have also been operated from STOLport airfields which feature short runways. Design considerations Many fixed-wing STOL aircraft are bush planes, though some, like the de Havilland Canada Dash-7, are designed for use on prepared airstrips; likewise, many STOL aircraft are taildraggers, though there are exceptions like the PAC P-750 XSTOL, the Quest Kodiak, the de Havilland Canada DHC-6 Twin Otter and the Peterson 260SE. Autogyros also have STOL capability, needing a short ground roll to get airborne, but capable of a near-zero ground roll when landing. Runway length requirement is a function of the square of the minimum fl ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Type Certificate
A type certificate signifies the airworthiness of a particular category of aircraft, according to its manufacturing design (''type design''). It confirms that the aircraft of a new type intended for serial production, is in compliance with applicable airworthiness requirements established by the national air law. For up to three seats, primary category aircraft, certification costs around US$1m, US$25m for a general aviation aircraft and hundreds of millions of dollars for a commercial aircraft; certification delays can cost millions of dollars and can decide a program's profitability. Authority A type certificate (TC) is issued to signify the airworthiness of the approved design or "type" of an aircraft to be manufactured. The TC is issued by a regulatory authority, and once issued, the design cannot be changed unless at least part of the process for certification is repeated to cover the changes. The TC reflects a determination made by a regulatory authority that the type desig ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Federal Aviation Administration
The Federal Aviation Administration (FAA) is the largest transportation agency of the U.S. government and regulates all aspects of civil aviation in the country as well as over surrounding international waters. Its powers include air traffic management, certification of personnel and aircraft, setting standards for airports, and protection of U.S. assets during the launch or re-entry of commercial space vehicles. Powers over neighboring international waters were delegated to the FAA by authority of the International Civil Aviation Organization. Created in , the FAA replaced the former Civil Aeronautics Administration (CAA) and later became an agency within the U.S. Department of Transportation. Major functions The FAA's roles include: *Regulating U.S. commercial space transportation *Regulating air navigation facilities' geometric and flight inspection standards *Encouraging and developing civil aeronautics, including new aviation technology *Issuing, suspending, or revoking ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Columbia 350
__NOTOC__ Year 350 ( CCCL) was a common year starting on Monday (link will display the full calendar) of the Julian calendar. At the time, it was known as the Year of the Consulship of Sergius and Nigrinianus (or, less frequently, year 1103 '' Ab urbe condita''). The denomination 350 for this year has been used since the early medieval period, when the Anno Domini calendar era became the prevalent method in Europe for naming years. Events By place Roman Empire * January 18 – Western Roman Emperor Constans I makes himself extremely unpopular; one of his generals, Magnentius, is proclaimed emperor at Augustodunum in the Diocese of Galliae, with the support of the army on the Rhine frontier. * January – Constans I flees towards Spain, where he is subsequently assassinated at '' Castrum Helenae''. Magnentius rules the Western Roman Empire and is far more tolerant towards Christians and Paganism, Pagans alike. * March 1 – Vetranio is asked by Constantina, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cirrus SR20
The Cirrus SR20 is an American piston-engined, four- or five-seat composite material, composite monoplane built since 1999 by Cirrus Aircraft of Duluth, Minnesota. The aircraft is the company's earliest type certificate, type-certified model, earning certification in 1998. It was the first production general aviation (GA) aircraft equipped with a Cirrus Airframe Parachute System, parachute to lower the airplane safely to the ground after a loss of control, structural failure, or midair collision. The SR series was also the first mass-manufactured light aircraft with all-composite construction and glass cockpit, flat-panel avionics. The SR20 was developed into the Cirrus SR22, which was introduced in 2001 and is the list of most-produced aircraft, most-produced GA aircraft of the 21st century. Design and development The SR20 mock-up was unveiled in 1994. The aircraft first flew on 21 March 1995 and Federal Aviation Administration, FAA certification was achieved on 23 October 19 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Smith Trainer
Smith may refer to: People * Metalsmith, or simply smith, a craftsman fashioning tools or works of art out of various metals * Smith (given name) * Smith (surname), a family name originating in England, Scotland and Ireland ** List of people with surname Smith * Smith (artist) (born 1985), French visual artist Arts and entertainment * Smith (band), an American rock band 1969–1971 * ''Smith'' (EP), by Tokyo Police Club, 2007 * ''Smith'' (play), a 1909 play by W. Somerset Maugham * ''Smith'' (1917 film), a British silent film based on the play * ''Smith'' (1939 film), a short film * ''Smith!'', a 1969 Disney Western film * ''Smith'' (TV series), a 2006 American drama * ''Smith'', a 1932 novel by Warwick Deeping * ''Smith'', a 1967 novel by Leon Garfield and a 1970 TV adaptation Places North America * Smith, Indiana, U.S. * Smith, Kentucky, U.S. * Smith, Nevada, U.S. * Smith, South Carolina, U.S. * Smith Village, Oklahoma, U.S. * Smith Park (Middletown, Connecticut), ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Verilite Sunbird
__NOTOC__ The Verilite Model 100 Sunbird was a low-cost light aircraft developed in the United States in the 1980s.Taylor 1989, p. 947''Jane's All the World's Aircraft 1987–88'', p. 529Wrixon 1987, p. 28 It was developed by De Vore Aviation, a company that manufactures aircraft components, as a first foray into aircraft manufacturing. When initiated in 1983, the goal of the project was to create a two-seat light aircraft that could be sold for less than $US 20,000. Additionally, it was hoped that the Sunbird operating costs would be half that of a conventional two-seat aircraft."De Vore aims for spin-proof Sunbird" 1986, p. 18 Funding for the project became available in 1985, and the Verilite subsidiary was created to develop the concept. The design was unconventional: a high-wing, strut-braced monoplane with the single engine fitted in pusher configuration at the rear of the wing, and the empennage carried on an aluminum boom. The pilot and a single passenger sat side by side i ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
%2C_Netherlands_PP1119199051.jpg "Click for more on -> Cirrus SR20")