|
Burst Switching
In a packet switched network, burst switching is a capability in which each network switch extracts routing instructions from an incoming packet header to establish and maintain the appropriate switch connection for the duration of the packet, following which the connection is automatically released. In concept, burst switching is similar to connectionless mode transmission, but differs in that burst switching implies an intent to establish the switch connection in near real time so that only minimum buffering is required at the node switch. A variant of burst switching used in optical networks is optical burst switching. References *Source: from Federal Standard 1037C Federal Standard 1037C, titled Telecommunications: Glossary of Telecommunication Terms, is a United States Federal Standard issued by the General Services Administration pursuant to the Federal Property and Administrative Services Act of 1949, a .... {{compu-network-stub Computer networks ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Packet Switched
In telecommunications, packet switching is a method of grouping data into '' packets'' that are transmitted over a digital network. Packets are made of a header and a payload. Data in the header is used by networking hardware to direct the packet to its destination, where the payload is extracted and used by an operating system, application software, or higher layer protocols. Packet switching is the primary basis for data communications in computer networks worldwide. In the early 1960s, American computer scientist Paul Baran developed the concept that he called "distributed adaptive message block switching", with the goal of providing a fault-tolerant, efficient routing method for telecommunication messages as part of a research program at the RAND Corporation, funded by the United States Department of Defense. His ideas contradicted then-established principles of pre-allocation of network bandwidth, exemplified by the development of telecommunications in the Bell System. The ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Computer Network
A computer network is a set of computers sharing resources located on or provided by network nodes. The computers use common communication protocols over digital interconnections to communicate with each other. These interconnections are made up of telecommunication network technologies, based on physically wired, optical, and wireless radio-frequency methods that may be arranged in a variety of network topologies. The nodes of a computer network can include personal computers, servers, networking hardware, or other specialised or general-purpose hosts. They are identified by network addresses, and may have hostnames. Hostnames serve as memorable labels for the nodes, rarely changed after initial assignment. Network addresses serve for locating and identifying the nodes by communication protocols such as the Internet Protocol. Computer networks may be classified by many criteria, including the transmission medium used to carry signals, bandwidth, communications pro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Switch
A network switch (also called switching hub, bridging hub, and, by the IEEE, MAC bridge) is networking hardware that connects devices on a computer network by using packet switching to receive and forward data to the destination device. A network switch is a multiport network bridge that uses MAC addresses to forward data at the data link layer (layer 2) of the OSI model. Some switches can also forward data at the network layer (layer 3) by additionally incorporating routing functionality. Such switches are commonly known as layer-3 switches or multilayer switches. Switches for Ethernet are the most common form of network switch. The first MAC Bridge was invented in 1983 by Mark Kempf, an engineer in the Networking Advanced Development group of Digital Equipment Corporation. The first 2 port Bridge product (LANBridge 100) was introduced by that company shortly after. The company subsequently produced multi-port switches for both Ethernet and FDDI such as GigaSwitch. Digital ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Routing
Routing is the process of selecting a path for traffic in a network or between or across multiple networks. Broadly, routing is performed in many types of networks, including circuit-switched networks, such as the public switched telephone network (PSTN), and computer networks, such as the Internet. In packet switching networks, routing is the higher-level decision making that directs network packets from their source toward their destination through intermediate network nodes by specific packet forwarding mechanisms. Packet forwarding is the transit of network packets from one network interface to another. Intermediate nodes are typically network hardware devices such as routers, gateways, firewalls, or switches. General-purpose computers also forward packets and perform routing, although they have no specially optimized hardware for the task. The routing process usually directs forwarding on the basis of routing tables. Routing tables maintain a record of the routes to ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Packet (information Technology)
In telecommunications and computer networking, a network packet is a formatted unit of data carried by a packet-switched network. A packet consists of control information and user data; the latter is also known as the ''payload''. Control information provides data for delivering the payload (e.g., source and destination network addresses, error detection codes, or sequencing information). Typically, control information is found in packet headers and trailers. In packet switching, the bandwidth of the transmission medium is shared between multiple communication sessions, in contrast to circuit switching, in which circuits are preallocated for the duration of one session and data is typically transmitted as a continuous bit stream. Terminology In the seven-layer OSI model of computer networking, ''packet'' strictly refers to a protocol data unit at layer 3, the network layer. A data unit at layer 2, the data link layer, is a ''frame''. In layer 4, the transport layer, the data u ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Header (computing)
In information technology, header refers to supplemental data placed at the beginning of a block of data being stored or transmitted. In data transmission, the data following the header is sometimes called the ''payload'' or '' body''. It is vital that header composition follows a clear and unambiguous specification or format, to allow for parsing. Examples * E-mail header: The text (body) is preceded by header lines indicating sender, recipient, subject, sending time stamp, receiving time stamps of all intermediate and the final mail transfer agents, and much more. * Similar headers are used in Usenet (NNTP) messages, and HTTP headers. * In a data packet sent via the Internet, the data (payload) are preceded by header information such as the sender's and the recipient's IP addresses, the protocol governing the format of the payload and several other formats. The header's format is specified in the Internet Protocol. * In data packets sent by wireless communication, and in sectors ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Telecommunication Connection
A telecommunication circuit is a path in a telecommunications network used to transmit information. Circuits have evolved over time from generally being built on physical connections between individual hardware cables, as in an analog phone switch, to virtual circuits established over packet switching networks. Definitions A telecommunication circuit may be defined as follows: * The complete path between two terminals over which one-way or two-way communications may be provided. * An electronic path between two or more points, capable of providing a single or multiple communication channels. * An electronic closed-loop path among two or more points used for signal transfer. In operational terms, a telecommunication circuit may be capable of transmitting information in only one direction (''simplex'' circuit), or it may be bi-directional (''duplex'' circuit). Bi-directional circuits may support half- duplex operation, when only one end of the channel transmits at any one time, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Connectionless Mode Transmission
Connectionless communication, often referred to as CL-mode communication,Information Processing Systems - Open Systems Interconnection, "Transport Service Definition - Addendum 1: Connectionless-mode Transmission", International Organization for Standardization, International Standard 8072/AD 6, December 1986. is a data transmission method used in packet switching networks in which each data unit is individually addressed and routed based on information carried in each unit, rather than in the setup information of a prearranged, fixed data channel as in connection-oriented communication. Attributes Under connectionless communication between two network end points, a message can be sent from one end point to another without prior arrangement. The device at one end of the communication transmits data addressed to the other, without first ensuring that the recipient is available and ready to receive the data. Some protocols allow for error correction by requesting retransmission. In ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Near Real Time
Real-time computing (RTC) is the computer science term for hardware and software systems subject to a "real-time constraint", for example from event to system response. Real-time programs must guarantee response within specified time constraints, often referred to as "deadlines". Ben-Ari, Mordechai; "Principles of Concurrent and Distributed Programming", ch. 16, Prentice Hall, 1990, , page 164 Real-time responses are often understood to be in the order of milliseconds, and sometimes microseconds. A system not specified as operating in real time cannot usually ''guarantee'' a response within any timeframe, although ''typical'' or ''expected'' response times may be given. Real-time processing ''fails'' if not completed within a specified deadline relative to an event; deadlines must always be met, regardless of system load. A real-time system has been described as one which "controls an environment by receiving data, processing them, and returning the results sufficiently quic ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Node (networking)
In telecommunications networks, a node (, ‘knot’) is either a redistribution point or a communication endpoint. The definition of a node depends on the network and protocol layer referred to. A physical network node is an electronic device that is attached to a network, and is capable of creating, receiving, or transmitting information over a communication channel. A passive distribution point such as a distribution frame or patch panel is consequently not a node. Computer networks In data communication, a physical network node may either be data communication equipment (DCE) such as a modem, hub, bridge or switch; or data terminal equipment (DTE) such as a digital telephone handset, a printer or a host computer. If the network in question is a local area network (LAN) or wide area network (WAN), every LAN or WAN node that participates on the data link layer must have a network address, typically one for each network interface controller it possesses. Examples are compu ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Optical Telecommunication
Optical communication, also known as optical telecommunication, is communication at a distance using light to carry information. It can be performed visually or by using electronic devices. The earliest basic forms of optical communication date back several millennia, while the earliest electrical device created to do so was the photophone, invented in 1880. An optical communication system uses a transmitter, which encodes a message into an optical signal, a channel, which carries the signal to its destination, and a receiver, which reproduces the message from the received optical signal. When electronic equipment is not employed the 'receiver' is a person visually observing and interpreting a signal, which may be either simple (such as the presence of a beacon fire) or complex (such as lights using color codes or flashed in a Morse code sequence). Modern communication relies on optical networking systems using optical fiber, optical amplifiers, lasers, switches, routers, and ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Optical Burst Switching
Optical burst switching (OBS) is an optical networking technique that allows dynamic sub-wavelength switching of data. OBS is viewed as a compromise between the yet unfeasible full optical packet switching (OPS) and the mostly static optical circuit switching (OCS). It differs from these paradigms because OBS control information is sent separately in a reserved optical channel and in advance of the data payload. These control signals can then be processed electronically to allow the timely setup of an optical light path to transport the soon-to-arrive payload. This is known as delayed reservation. Purpose The purpose of optical burst switching (OBS) is to dynamically provision sub-wavelength granularity by optimally combining electronics and optics. OBS considers sets of packets with similar properties called bursts. Therefore, OBS granularity is finer than optical circuit switching (OCS). OBS provides more bandwidth flexibility than wavelength routing but requires faster switching a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
