|
Answerphone (Banx
An answering machine, answerphone or message machine, also known as telephone messaging machine (or TAM) in the UK and some Commonwealth countries, ansaphone or ansafone (from a trade name), or telephone answering device (TAD), was used for answering telephones and recording callers' messages. If a phone rings a number of times predetermined by the phone's owner, and nobody is present to answer the incoming call, the answering machine will activate and play either a generic announcement or the voice of the person being called announcing that nobody is able to come to the phone at the moment. Following the announcement is a beeping tone which prompts the caller to record a message after the tone concludes. Unlike voicemail, which can be a centralized or networked system that covers, and mostly extends, similar functions, an answering machine is set up in the user's premises alongside—or incorporated within—the user's land-line telephone. Unlike operator messaging, the cal ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Magnetic Tape
Magnetic tape is a medium for magnetic storage made of a thin, magnetizable coating on a long, narrow strip of plastic film. It was developed in Germany in 1928, based on the earlier magnetic wire recording from Denmark. Devices that use magnetic tape could with relative ease record and playback audio, visual, and binary computer data. Magnetic tape revolutionized sound recording and reproduction and broadcasting. It allowed radio, which had always been broadcast live, to be recorded for later or repeated airing. Since the early 1950s, magnetic tape has been used with computers to store large quantities of data and is still used for backup purposes. Magnetic tape begins to degrade after 10–20 years and therefore is not an ideal medium for long-term archival storage. Durability While good for short-term use, magnetic tape is highly prone to disintegration. Depending on the environment, this process may begin after 10–20 years. Over time, magnetic tape made in the 197 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse Dialling
Pulse dialing is a signaling technology in telecommunications in which a direct current local loop circuit is interrupted according to a defined coding system for each signal transmitted, usually a digit. This lends the method the often used name loop disconnect dialing. In the most common variant of pulse dialing, decadic dialing, each of the ten Arabic numerals are encoded in a sequence of up to ten pulses. The most common version decodes the digits 1 through 9, as one to nine pulses, respectively, and the digit 0 as ten pulses. Historically, the most common device to produce such pulse trains is the rotary dial of the telephone, lending the technology another name, rotary dialing. The pulse repetition rate was historically determined based on the response time needed for electromechanical switching systems to operate reliably. Most telephone systems used the nominal rate of ten pulses per second, but operator dialing within and between central offices often used pulse rates u ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Dual-tone Multi-frequency Signaling
Dual-tone multi-frequency signaling (DTMF) is a telecommunication signaling system using the voice-frequency band over telephone lines between telephone equipment and other communications devices and switching centers. DTMF was first developed in the Bell System in the United States, and became known under the trademark Touch-Tone for use in push-button telephones supplied to telephone customers, starting in 1963. DTMF is standardized as ITU-T Recommendation Q.23. It is also known in the UK as ''MF4''. The Touch-Tone system using a telephone keypad gradually replaced the use of rotary dial and has become the industry standard for landline and mobile service. Other multi-frequency systems are used for internal signaling within the telephone network. Multifrequency signaling Before the development of DTMF, telephone numbers were dialed by users with a loop-disconnect (LD) signaling, more commonly known as pulse dialing (dial pulse, DP) in the United States. It functions by int ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Microcassette
The Microcassette (often written generically as microcassette) is an audio storage medium, introduced by Olympus in 1969. It has the same width of magnetic tape as the Compact Cassette but in a cassette roughly one quarter the size. By using thinner tape and half or a quarter the tape speed, microcassettes can offer comparable recording time to the compact cassette but in a smaller package. History Microcassettes have mostly been used for recording voice. In particular, they are commonly used in dictation machines and answering machines. Microcassettes have also been used in computer data storage and to record music. For the latter purpose, devices for recording in stereo were produced in 1982 and, for higher fidelity, microcassettes using Type IV ("metal", i.e. coated with pure metal particles rather than oxide) tape were sold. This was an attempt by Olympus to cash in on the burgeoning Walkman market; one model, the Olympus SR-11, had a built-in radio and offered a stereo ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
On-hook
In telephony, on-hook and off-hook are two states of a communication circuit. On subscriber telephones the states are produced by placing the handset onto or off the hookswitch. Placing the circuit into the off-hook state is also called ''seizing the line''. ''Off-hook'' originally referred to the condition that prevailed when telephones had a separate earpiece (''receiver''), which hung from its switchhook until the user initiated a telephone call by removing it. When off hook the weight of the receiver no longer depresses the spring-loaded switchhook, thereby connecting the instrument to the telephone line. Off-hook The term off-hook has the following meanings: * The condition that exists when a telephone or other user instrument is in use, i.e., during dialing or communicating. * A general description of one of two possible signaling states at an interface between telecommunications systems, such as tone or no tone and ground connection versus battery connection. Note that if ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ringback Tone
Ringing tone (audible ringing, also ringback tone) is a signaling tone in telecommunication that is heard by the originator of a telephone call while the destination terminal is alerting the receiving party. The tone is typically a repeated cadence similar to a traditional power ringing signal (''ringtone''), but is usually not played synchronously. Various telecommunication groups, such as the Bell System and the General Post Office (GPO) developed standards, in part taken over by the European Telecommunications Standards Institute (ETSI) and other standards bodies. With modern cell phone and smartphone technology ringing tone can be customized and even used for advertising. Purpose and description When a telephone user initiates a telephone call, typically by dialing or selecting a telephone number on a telephone, the progress or status of the call attempt is indicated to the user audibly by a several types of call progress tones. For example, during the period of routing the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Terminal Equipment
In telecommunication, the term terminal equipment has the following meanings: * Communications equipment at either end of a communications link, used to permit the stations involved to accomplish the mission for which the link was established. * In radio-relay systems, equipment used at points where data are inserted or derived, as distinct from equipment used only to relay a reconstituted signal. * Telephone and telegraph switchboards and other centrally located equipment at which communications circuits are terminated. See also * Customer-premises equipment * Data terminal equipment Data terminal equipment (DTE) is an end instrument that converts user information into signals or reconverts received signals. These can also be called tail circuits. A DTE device communicates with the data circuit-terminating equipment (DCE) ..., an end instrument that converts user information into signals for transmission or reconverts the received signals into user information References ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Off-hook
In telephony, on-hook and off-hook are two states of a communication circuit. On subscriber telephones the states are produced by placing the handset onto or off the hookswitch. Placing the circuit into the off-hook state is also called ''seizing the line''. ''Off-hook'' originally referred to the condition that prevailed when telephones had a separate earpiece (''receiver''), which hung from its switchhook until the user initiated a telephone call by removing it. When off hook the weight of the receiver no longer depresses the spring-loaded switchhook, thereby connecting the instrument to the telephone line. Off-hook The term off-hook has the following meanings: * The condition that exists when a telephone or other user instrument is in use, i.e., during dialing or communicating. * A general description of one of two possible signaling states at an interface between telecommunications systems, such as tone or no tone and ground connection versus battery connection. Note that if ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Call Screening
Call screening is the process of evaluating the characteristics of a telephone call before deciding how or whether to answer it. Some methods may include: * listening to the message being recorded on an answering machine or voice mail. * checking a caller ID display to see who or where the call is from. * checking the time or date which a call or message was received. * prescreening callers to a request line at a radio station or call-in talk show before they are allowed on the air In addition, in the US and Canada, Call Screen is the name of a calling feature A vertical service code (VSC) is a sequence of digits and the signals star (*) and number sign (#) dialed on a telephone keypad or rotary dial to enable or disable certain telephone service features. Some vertical service codes require dialing of ... offered by the telephone companies that allows a customer to establish a list of numbers; anyone calling the customer from those numbers will receive an automatic message ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
