Agitator (device)
An agitator is a device or mechanism to put something into motion by shaking or stirring. There are several types of agitation machines, including washing machine agitators (which rotate back and forth) and magnetic agitators (which contain a magnetic bar rotating in a magnetic field). Agitators can come in many sizes and varieties, depending on the application. In general, agitators usually consist of an impeller and a shaft. An impeller is a rotor located within a tube or conduit attached to the shaft. It helps enhance the pressure in order for the flow of a fluid be done. Modern industrial agitators incorporate process control to maintain better control over the mixing process. Washing machine agitator In a top load washing machine the agitator projects from the bottom of the wash basket and creates the wash action by rotating back and forth, rolling garments from the top of the load, down to the bottom, then back up again. There are several types of agitators with the m ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Machine
A machine is a physical system using Power (physics), power to apply Force, forces and control Motion, movement to perform an action. The term is commonly applied to artificial devices, such as those employing engines or motors, but also to natural biological macromolecules, such as molecular machines. Machines can be driven by Animal power, animals and Human power, people, by natural forces such as Wind power, wind and Water power, water, and by Chemical energy, chemical, Thermal energy, thermal, or electricity, electrical power, and include a system of mechanism (engineering), mechanisms that shape the actuator input to achieve a specific application of output forces and movement. They can also include computers and sensors that monitor performance and plan movement, often called mechanical systems. Renaissance natural philosophers identified six simple machines which were the elementary devices that put a load into motion, and calculated the ratio of output force to input fo ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Electromagnet
An electromagnet is a type of magnet in which the magnetic field is produced by an electric current. Electromagnets usually consist of wire wound into a coil. A current through the wire creates a magnetic field which is concentrated in the hole in the center of the coil. The magnetic field disappears when the current is turned off. The wire turns are often wound around a magnetic core made from a ferromagnetic or ferrimagnetic material such as iron; the magnetic core concentrates the magnetic flux and makes a more powerful magnet. The main advantage of an electromagnet over a permanent magnet is that the magnetic field can be quickly changed by controlling the amount of electric current in the winding. However, unlike a permanent magnet that needs no power, an electromagnet requires a continuous supply of current to maintain the magnetic field. Electromagnets are widely used as components of other electrical devices, such as motors, generators, electromechanical so ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Mechanical Engineering
Mechanical engineering is the study of physical machines that may involve force and movement. It is an engineering branch that combines engineering physics and mathematics principles with materials science, to design, analyze, manufacture, and maintain mechanical systems. It is one of the oldest and broadest of the engineering branches. Mechanical engineering requires an understanding of core areas including mechanics, dynamics, thermodynamics, materials science, structural analysis, and electricity. In addition to these core principles, mechanical engineers use tools such as computer-aided design (CAD), computer-aided manufacturing (CAM), and product lifecycle management to design and analyze manufacturing plants, industrial equipment and machinery, heating and cooling systems, transport systems, aircraft, watercraft, robotics, medical devices, weapons, and others. Mechanical engineering emerged as a field during the Industrial Revolution in Europe in the 18 ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Mixing Paddle
A mixing paddle is a shaped device, typically mounted on a shaft, which can be inserted on the shaft end into a motorised drive, for the purpose of mixing liquids, solids or both. Paddle mixers may also be used for kneading. Whilst mounted in fixed blending equipment, the paddle may also be referred to as an agitator. Purpose Mixing paddles are used for mixing ingredients in cooking and for mixing construction products, such as pastes, slurries or paints. They are also used for dispersing solids within liquids (for example, some polymers may be delivered in solid form, but will dissolve in liquids). Examples *Professional grout mixing paddle *Paint mixing paddle *Mudwhip (mostly used for drywall mud) Gallery File:Grout_mixing_paddle_001.png, Grout mixing paddle. File:Grout_mixing_paddle_002.png, Grout mixing paddle, standing. File:Mudwhip_001.png, Mudwhip – typically used for drywall mud. File:Mudwhip_002.png, Mudwhip, standing. File:Agitated vessel.svg, Mixing vessel with ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Mixing (other)
Mix, mixes or mixing may refer to: Persons & places * Mix (surname) ** Tom Mix (1880-1940), American film star * nickname of Mix Diskerud (born Mikkel, 1990), Norwegian-American soccer player * Mix camp, an informal settlement in Namibia * Mix, Louisiana, an unincorporated community * Mix Run, Pennsylvania, village Audio * Audio mixing (recorded music), the process of combining and balancing multiple sound sources * DJ mix, a sequence of musical tracks mixed to appear as one continuous track * ''Mix'' (magazine), a periodical for the professional recording and sound production technology industry Music * ''Mixes'' (Kylie Minogue album), the 1998 remix album by Australian singer-songwriter Kylie Minogue * ''Mix'' (Stellar album), the 1999 debut studio album by New Zealand pop rock band Stellar * ''Mixes'' (Transvision Vamp album), 1992 * ''Mixes'', an album by C418 * Mixtape, a compilation of songs or tracks * Remix, a variation of a song * Mix, short way to refer to Mix ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Tedder (machine)
A tedder (also called hay tedder) is a machine used in haymaking. It is used after cutting and before windrowing, and uses moving forks to aerate or "wuffle" the hay and thus speed drying before baling or rolling. The use of a tedder allows the hay to dry ("cure") better, which prevents mildew or fermentation. History The tedder came into use in the second half of the nineteenth century. While Charles Wendel claims in his ''Encyclopedia of American farm implements & antiques'' that the machine wasn't introduced to the United States until the 1880s, there are enough indications that the tedder was in use in the 1860s—''The New York Times'' reports on its efficacy in 1868, and in that same year the Annual Report of the Commissioner of Agriculture in Maine comments on the American-made Hubbard's hay tedder, which had been on the market since 1863; according to the Maine report, in 1859 the machine was "an implement lately imported from England." The action of the tedder is des ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Impeller
An impeller or impellor is a rotor used to increase the pressure and flow of a fluid. It is the opposite of a turbine, which extracts energy from, and reduces the pressure of, a flowing fluid. In pumps An impeller is a rotating component of a centrifugal pump that accelerates fluid outward from the center of rotation, thus transferring energy from the motor that drives the pump to the fluid being pumped. The velocity achieved by the impeller transfers into pressure when the outward movement of the fluid is confined by the pump casing. An impeller is usually a short cylinder with an open inlet (called an eye) to accept incoming fluid, vanes to push the fluid radially, and a splined, keyed, or threaded bore to accept a drive shaft. It can be cheaper to cast an impeller and its spindle as one piece, rather than separately. This combination is sometimes referred to simply as the "rotor." Types Open impellers An open impeller has a hub with attached vanes and is moun ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Platelets
Platelets, also called thrombocytes (from Greek θρόμβος, "clot" and κύτος, "cell"), are a component of blood whose function (along with the coagulation factors) is to react to bleeding from blood vessel injury by clumping, thereby initiating a blood clot. Platelets have no cell nucleus; they are fragments of cytoplasm that are derived from the megakaryocytes of the bone marrow or lung, which then enter the circulation. Platelets are found only in mammals, whereas in other vertebrates (e.g. birds, amphibians), thrombocytes circulate as intact mononuclear cells. One major function of platelets is to contribute to hemostasis: the process of stopping bleeding at the site of interrupted endothelium. They gather at the site and, unless the interruption is physically too large, they plug the hole. First, platelets attach to substances outside the interrupted endothelium: ''adhesion''. Second, they change shape, turn on receptors and secrete chemical messengers: ''ac ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Rotating Magnetic Field
A rotating magnetic field is the resultant magnetic field produced by a system of coils symmetrically placed and supplied with polyphase currents. A rotating magnetic field can be produced by a poly-phase (two or more phases) current or by a single phase current provided that, in the latter case, two field windings are supplied and are so designed that the two resulting magnetic fields generated thereby are out of phase. Rotating magnetic fields are often utilized for electromechanical applications, such as induction motors, electric generators and induction regulators. History In 1824, the French physicist François Arago formulated the existence of rotating magnetic fields using a rotating copper disk and a needle, termed “ Arago's rotations.” English experimenters Charles Babbage and John Herschel found they could induce rotation in Arago's copper disk by spinning a horseshoe magnet under it, with English scientist Michael Faraday later attributing the effect to electrom ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Magnet
A magnet is a material or object that produces a magnetic field. This magnetic field is invisible but is responsible for the most notable property of a magnet: a force that pulls on other ferromagnetic materials, such as iron, steel, nickel, cobalt, etc. and attracts or repels other magnets. A permanent magnet is an object made from a material that is magnetized and creates its own persistent magnetic field. An everyday example is a refrigerator magnet used to hold notes on a refrigerator door. Materials that can be magnetized, which are also the ones that are strongly attracted to a magnet, are called ferromagnetic (or ferrimagnetic). These include the elements iron, nickel and cobalt and their alloys, some alloys of rare-earth metals, and some naturally occurring minerals such as lodestone. Although ferromagnetic (and ferrimagnetic) materials are the only ones attracted to a magnet strongly enough to be commonly considered magnetic, all other substances respond ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Mechanism (engineering)
In engineering, a mechanism is a device that transforms input forces and movement into a desired set of output forces and movement. Mechanisms generally consist of moving components which may include: * Gears and gear trains; * Belts and chain drives; * Cams and followers; * Linkages; * Friction devices, such as brakes or clutches; * Structural components such as a frame, fasteners, bearings, springs, or lubricants; * Various machine elements, such as splines, pins, or keys. The German scientist Franz Reuleaux defines ''machine'' as "a combination of resistant bodies so arranged that by their means the mechanical forces of nature can be compelled to do work accompanied by certain determinate motion". In this context, his use of ''machine'' is generally interpreted to mean ''mechanism''. The combination of force and movement defines power, and a mechanism manages power to achieve a desired set of forces and movement. A mechanism is usually a piece of a larger process, k ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Kenmore Appliances
Kenmore is an American brand of household appliances sold by Sears, The brand is owned by Transformco, an affiliate of ESL Investments. As of 2017, Kenmore products are produced by manufacturers including Whirlpool, Samsung, LG, Electrolux, Panasonic, Cleva North America, and Daewoo Electronics. Today, the majority of the brand's portfolio is sold at Sears, Kmart, and Amazon. In 2019, the brand's grills and vacuum cleaners were offered at Lowe's, The Home Depot and Target. History The brand first appeared on a four-drawer drop feed sewing machine sold from 1913 to 1919. The first Kenmore washing machine was introduced in 1927. The first Kenmore vacuum cleaners were introduced in 1932. In 1976, Sears expanded the Kenmore name to its line of refrigerators, freezers, air conditioners, and dehumidifiers, which were previously branded as Coldspot. In 2016, the Kenmore brand was expanded into consumer electronics with the launch of Kenmore-branded high definition (Kenmore HD ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |