|
AX.25
AX.25 (Amateur X.25) is a data link layer protocol originally derived from layer 2 of the X.25 protocol suite and designed for use by amateur radio operators. It is used extensively on amateur packet radio networks. AX.25 v2.0 and later occupies the data link layer, the second layer of the OSI model. It is responsible for establishing link-layer connections, transferring data encapsulated in frames between nodes, and detecting errors introduced by the communications channel. As AX.25 is a pre-OSI-model protocol, the original specification was not written to cleanly separate into OSI layers. This was rectified with version 2.0 (1984), which assumes compliance with OSI level 2. AX.25 v2.2 (1998) added improvements to improve efficiency, especially at higher data rates. Stations can automatically negotiate payload sizes larger than the previous limitation of 256 bytes. Extended sequence numbers (7 vs. 3 bits) allow a larger window size, the number of frames that can be sent befor ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
AMPRNet
The AMPRNet (AMateur Packet Radio Network) or Network 44 is used in amateur radio for packet radio and digital communications between computer networks managed by amateur radio operators. Like other amateur radio frequency allocations, an IP range of was provided in 1981 for Amateur Radio Digital Communications (a generic term) and self-administered by radio amateurs. In 2001, undocumented and dual-use of as an internet telescope began, recording the spread of the Code Red II worm in July 2001. In mid-2019, part of IPv4 range was sold off for conventional use, due to IPv4 address exhaustion. Amateur Radio Digital Communications (mode) Beginning on 1 May 1978, the Canadian authorities allowed radio amateurs on the 1.25-meter band (220 MHz) to use packet radio, and later in 1978 announced the "Amateur Digital Radio Operator's Certificate". Discussion on digital communication amateur radio modes, using the internet protocol suite and IPv4 addresses followed subsequent ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Packet Radio
In digital radio, packet radio is the application of packet switching techniques to digital radio communications. Packet radio uses a packet switching protocol as opposed to circuit switching or message switching protocols to transmit digital data via a radio communication link. Packet radio can be differentiated from other digital radio switching schemes by the following attributes: * Transmitted data is broken into packets, each of which contains a destination (and typically the source) address * A transmitted message may be broken into a sequence of packets before transmission, which are then re-assembled into the original message upon reception * Packets for multiple destinations can be transmitted on the same radio link in an asynchronous fashion * A packet may be addressed to all possible recipients rather than a specific one (broadcast) * A packet may be stored and subsequently forwarded towards its destination by a network node This is very similar to how packets of data ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Terminal Node Controller
A terminal node controller (TNC) is a device used by amateur radio operators to participate in AX.25 packet radio networks. It is similar in function to the Packet Assembler/Disassemblers used on X.25 networks, with the addition of a modem to convert baseband digital signals to audio tones. The first TNC, the VADCG board, was originally developed by Doug Lockhart, VE7APU, of Vancouver, British Columbia. Amateur Radio TNCs were first developed in 1978 in Canada by the Montreal Amateur Radio Club and the Vancouver Area Digital Communications group. These never gained much popularity because only a bare printed circuit board was made available and builders had to gather up a large number of components. In 1983, the Tucson Amateur Packet Radio (TAPR) association produced complete kits for their TNC-1 design. This was later available as the Heathkit HD-4040. A few years later, the improved TNC-2 became available, and it was licensed to commercial manufacturers such as MFJ. I ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Automatic Packet Reporting System
Automatic Packet Reporting System (APRS) is an amateur radio-based system for real time digital communications of information of immediate value in the local area. Data can include object Global Positioning System (GPS) coordinates, weather station telemetry, text messages, announcements, queries, and other telemetry. APRS data can be displayed on a map, which can show stations, objects, tracks of moving objects, weather stations, search and rescue data, and direction finding data. APRS data is typically transmitted on a single shared frequency (depending on country) to be repeated locally by area relay stations (digipeaters) for widespread local consumption. In addition, all such data are typically ingested into the APRS Internet System (APRS-IS) via an Internet-connected receiver (IGate) and distributed globally for ubiquitous and immediate access. Data shared via radio or Internet are collected by all users and can be combined with external map data to build a shared live v ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Amateur Radio
Amateur radio, also known as ham radio, is the use of the radio frequency spectrum for purposes of non-commercial exchange of messages, wireless experimentation, self-training, private recreation, radiosport, contesting, and emergency communications. The term "amateur" is used to specify "a duly authorised person interested in radioelectric practice with a purely personal aim and without pecuniary interest;" (either direct monetary or other similar reward) and to differentiate it from commercial broadcasting, public safety (such as police and fire), or professional two-way radio services (such as maritime, aviation, taxis, etc.). The amateur radio service (''amateur service'' and '' amateur-satellite service'') is established by the International Telecommunication Union (ITU) through the Radio Regulations. National governments regulate technical and operational characteristics of transmissions and issue individual station licenses with a unique identifying call sign, which mus ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bell 202 Modem
The Bell 202 modem was an early (1976) modem standard developed by the Bell System. It specifies audio frequency-shift keying (AFSK) to encode and transfer data at a rate of 1200 bits per second, half-duplex. It has separate sets of circuits for 1200 bps and 300 bps rates. These signalling protocols, also used in third-party modems, are referred to generically as ''Bell 202 modulation'', and any device employing it as ''Bell-202-compatible''. * Bell 202 AFSK uses a 1200 Hz tone for ''mark'' (typically a binary ''1'') and 2200 Hz for ''space'' (typically a binary ''0''). In North America, Bell 202 AFSK modulation is used to transmit Caller ID information over POTS lines in the public telephone network. It is also employed in some commercial settings. In addition, Bell 202 is the basis for the most commonly used physical layer for the HART Communication Protocol - a communication protocol widely used in the process industries. Surplus Bell 202 modems were used by ama ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Protocol (computing)
A communication protocol is a system of rules that allows two or more entities of a communications system to transmit information via any kind of variation of a physical quantity. The protocol defines the rules, syntax, semantics and synchronization of communication and possible error recovery methods. Protocols may be implemented by hardware, software, or a combination of both. Communicating systems use well-defined formats for exchanging various messages. Each message has an exact meaning intended to elicit a response from a range of possible responses pre-determined for that particular situation. The specified behavior is typically independent of how it is to be implemented. Communication protocols have to be agreed upon by the parties involved. To reach an agreement, a protocol may be developed into a technical standard. A programming language describes the same for computations, so there is a close analogy between protocols and programming languages: ''protocols are t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Layer
In the seven-layer OSI model of computer networking, the network layer is layer 3. The network layer is responsible for packet forwarding including routing through intermediate routers. Functions The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer. Functions of the network layer include: ; Connectionless communication : For example, IP is connectionless, in that a data packet can travel from a sender to a recipient without the recipient having to send an acknowledgement. Connection-oriented protocols exist at other, higher layers of the OSI model. ; Host addressing :Every host in the network must have a unique address that determines where it is. This address is normally assigned from a hierar ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Layer
In the seven-layer OSI model of computer networking, the network layer is layer 3. The network layer is responsible for packet forwarding including routing through intermediate routers. Functions The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer. Functions of the network layer include: ; Connectionless communication : For example, IP is connectionless, in that a data packet can travel from a sender to a recipient without the recipient having to send an acknowledgement. Connection-oriented protocols exist at other, higher layers of the OSI model. ; Host addressing :Every host in the network must have a unique address that determines where it is. This address is normally assigned from a hierar ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Packet (information Technology)
In telecommunications and computer networking, a network packet is a formatted unit of data carried by a packet-switched network. A packet consists of control information and user data; the latter is also known as the ''payload''. Control information provides data for delivering the payload (e.g., source and destination network addresses, error detection codes, or sequencing information). Typically, control information is found in packet headers and trailers. In packet switching, the bandwidth of the transmission medium is shared between multiple communication sessions, in contrast to circuit switching, in which circuits are preallocated for the duration of one session and data is typically transmitted as a continuous bit stream. Terminology In the seven-layer OSI model of computer networking, ''packet'' strictly refers to a protocol data unit at layer 3, the network layer. A data unit at layer 2, the data link layer, is a ''frame''. In layer 4, the transport layer, the data u ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
