86-DOS 0.42

Supported disk formats

Two logical format variants of the 86-DOS 12-bit FAT format existed—the original format with 16-byte directory entries and the later format (since 86-DOS 0.42) with 32-byte directory entries. Only the second one is logically compatible with the FAT12 format known since the release of MS-DOS and PC DOS. MS-DOS still cannot mount such volumes, as in absence of a BPB it falls back to retrieve the FAT ID in the FAT entry for cluster 0 to choose among hard-coded disk geometry profiles. In all formats of a volume formatted under MS-DOS that would otherwise be supported by both systems and typically also in all other formats, this ID is located in the first byte of logical sector 1—that is, the volume's second sector with physical cylinder-head-sector (CHS) address 0/0/2 or logical block addressing (LBA) address 1—since MS-DOS assumes a single reserved sector, the boot sector. Under 86-DOS, the reserved sectors area is significantly larger (whole tracks), and therefore the prototypical FAT ID 0xFE (and 0xFF) is located elsewhere on disk, making it impossible for MS-DOS to retrieve it, and even if it would, the hard-coded disk profile associated with it would not take this larger reserved sectors region under 86-DOS into account.