Shiremark Mill, also known as Kingsfold Mill or Capel Mill was a
listed Smock mill
The smock mill is a type of windmill that consists of a sloping, horizontally weatherboarded, thatched, or shingled tower, usually with six or eight sides. It is topped with a roof or cap that rotates to bring the sails into the wind. This type ...
at
Capel,
Surrey, England, which was burnt down in 1972.
History
Shiremark Mill was built in 1774, incorporating some material from a demolished
open trestle post mill
The post mill is the earliest type of European windmill. Its defining feature is that the whole body of the mill that houses the machinery is mounted on a single vertical post, around which it can be turned to bring the sails into the wind. All p ...
which had stood at Clark's Green (TQ 176 398, ). It was so named because it stood close to the border with
Sussex, and although often thought of as a Sussex mill, actually stood just within Surrey
by some .
[
The mill was offered for sale in 1777, described as "new-built" and in 1802 was acquired by the Stone family, who were to work it until 1919. In 1886, the mill was tailwinded and the cap and ]sails
A sail is a tensile structure—which is made from fabric or other membrane materials—that uses wind power to propel sailing craft, including sailing ships, sailboats, windsurfers, ice boats, and even sail-powered land vehicles. Sails may ...
were blown off. Messrs Grist and Steele, the Horsham
Horsham is a market town on the upper reaches of the River Arun on the fringe of the Weald in West Sussex, England. The town is south south-west of London, north-west of Brighton and north-east of the county town of Chichester. Nearby ...
millwright
A millwright is a craftsperson or skilled tradesperson who installs, dismantles, maintains, repairs, reassembles, and moves machinery in factories, power plants, and construction sites.
The term ''millwright'' (also known as ''industrial mecha ...
s replaced them that year. The mill worked by wind until 1919, when it was stopped on account of a defective curb.[
Shiremark Mill slowly became derelict, an inspection by ]Rex Wailes
Reginald "Rex" Wailes OBE, FSA, F I Mech E (6 March 1901 – 7 January 1986) was an English engineer and historian who published widely on aspects of engineering history and industrial archaeology, particularly on windmills and watermill ...
in 1933 resulted in an estimated repair cost of £100. The cap boarding was repaired but the mill was again left to deteriorate. In 1950, Capel Parish Council approached the Society for the Protection of Ancient Buildings
The Society for the Protection of Ancient Buildings (SPAB) (also known as Anti-Scrape) is an amenity society founded by William Morris, Philip Webb, and others in 1877 to oppose the destructive 'restoration' of ancient buildings occurring in ...
and the owner of the mill with a view to securing the mill's preservation. The mill had been listed as an antiquity by Surrey County Council
Surrey County Council is the county council administering certain services in the non-metropolitan county of Surrey in England. The council is composed of 81 elected councillors, and in all but one election since 1965 the Conservative Party h ...
by 1951. In 1952, a detailed inspection of the mill found that the sills and lower part of the cant posts were rotten. Thompson's, the Alford millwrights estimated that the mill would cose £2,500 to restore. The main beams of the first floor were supported by brick piers, but no other work was done.[ Although the mill had all four sails in 1928,] the sails fell off one by one, with the last falling in 1956.[ Photographs show that the cap was intact in August 1958, but by May 1966 the roof had gone, exposing the brake wheel to the weather.]
Description
Shiremark Mill was a three-storey smock mill on a single-storey base. There was no stage, earth having been thrown up against the base to form a mill mound. It last worked with four double Patent sails carried on a cast-iron
Cast iron is a class of iron–carbon alloys with a carbon content more than 2%. Its usefulness derives from its relatively low melting temperature. The alloy constituents affect its color when fractured: white cast iron has carbide impuriti ...
windshaft. The cap was winded by a hand wheel.[
]
Base
The single storey octagon
In geometry, an octagon (from the Greek ὀκτάγωνον ''oktágōnon'', "eight angles") is an eight-sided polygon or 8-gon.
A ''regular octagon'' has Schläfli symbol and can also be constructed as a quasiregular truncated square, t, wh ...
al brick base was from floor level to the top of the brickwork internally. Externally it was from ground level to the top of the brickwork, earth having been embanked against the base to allow the sails to be reached for reefing, the mill having originally been built with Common sails. The brickwork tapered in thickness, being thick at the top. It was across the flats.[ By 2006 the base was the only remaining part of the mill, although largely hidden by dense undergrowth.
]
Smock
The three-storey smock tower rested on oak sills of by in section. The eight oak cant posts were were square and long, and carried a circular oak curb of diameter at the top. There were two sets of square oak transoms at appropriate heights which carried the joists for the internal floors. Each of the twenty-four frames was infilled with a vertical oak post square and two diagonal struts in section. On the bottom floor of the smock there were two doors on opposite sides to enable access whatever direction the sails were facing.[
Internally, the bottom floor of the smock was at two levels, with a height difference. The main beams were long and square on centres. These formed the base of the Hurst Frame, a feature more commonly found in ]watermill
A watermill or water mill is a mill that uses hydropower. It is a structure that uses a water wheel or water turbine to drive a mechanical process such as milling (grinding), rolling, or hammering. Such processes are needed in the productio ...
s than windmills. Shiremark mill is the only recorded windmill with a hurst frame south of the River Thames
The River Thames ( ), known alternatively in parts as the River Isis, is a river that flows through southern England including London. At , it is the longest river entirely in England and the second-longest in the United Kingdom, after the ...
.[ A surviving windmill with a hurst frame is Chesterton Mill, ]Warwickshire
Warwickshire (; abbreviated Warks) is a county in the West Midlands region of England. The county town is Warwick, and the largest town is Nuneaton. The county is famous for being the birthplace of William Shakespeare at Stratford-upon-Avon an ...
.
Cap
The cap was by in plan, and in height above the curb. The mill was high from the ground floor to the cap ridge, thus from ground level to roof externally. The main cap frame consisted of two sheers, each square in section and , set apart. The main cross members were the breast beam, the sprattle beam and the tail beam, in order from head to tail. The cross members extended each side of the sheers to form a base for the nine pairs of roof rafters. There was no ridge board to the roof.[
The cap was winded by a hand wheel of diameter housed just inside the rear of the cap. The worm wheel that engaged with the cogs set into the top of the tower was latterly a cast-iron one, replacing an earlier wooden one. It was necessary to pull about a of chain to turn the mill through 180 degrees.][
]
Sails and windshaft
The mill was built with four Common sails. After it was tailwinded in 1886, a new cap, windshaft and four double Patent sails were fitted. The sails were wide and spanned . Each pair of sails was carried on a stock long and of by section at the canister, tapering to square at the tips. Each stock was strengthened by a pair of clamps, long and by in section.[
The cast-iron windshaft is long overall, with a canister at the outer end to carry the stocks. It was diameter at the neck bearing, square at the boss for the brake wheel and diameter at the tail, the tail bearing itself being diameter. The windshaft carried a diameter clasp arm Brake wheel, which had been converted from compass arm construction, the original windshaft having been of wood. The brake wheel had 75 cogs.][ The windshaft from Shiremark Mill was used in the restoration of Ripple Mill, Ringwould, ]Kent
Kent is a county in South East England and one of the home counties. It borders Greater London to the north-west, Surrey to the west and East Sussex to the south-west, and Essex to the north across the estuary of the River Thames; it faces ...
in 1994.
Machinery
The elm
Elms are deciduous and semi-deciduous trees comprising the flowering plant genus ''Ulmus'' in the plant family Ulmaceae. They are distributed over most of the Northern Hemisphere, inhabiting the temperate and tropical-montane regions of Nor ...
Upright Shaft was long It carried a cast-iron Wallower diameter Wallower, cast in halves and having 26 teeth. It replaced an earlier wooden wheel. The underside of the wallower had a friction ring which drove the sack hoist. At the foot of the Upright Shaft, a wooden clasp arm Great Spur Wheel of diameter with 70 cogs was carried. This drove the two pairs of millstones underdrift. The French Burr stones were driven by a stone nut with 20 cogs, and the Peak stones were driven by a stone nut with 18 cogs. Each pair of millstones was controlled by its own governor, missing at the time of the survey in 1952.[
]
Millers
*David Southow, 1774–1777
*John Stone, 1802–
*Thomas Stone
*G. Stone
*Eliza Stone
*John Chantler, 1875
*William Rapley, 1886
*George Stone, 1919
Reference: [
]
Culture and literature
Hilaire Belloc
Joseph Hilaire Pierre René Belloc (, ; 27 July 187016 July 1953) was a Franco-English writer and historian of the early twentieth century. Belloc was also an orator, poet, sailor, satirist, writer of letters, soldier, and political activist. ...
mentions Shiremark Mill in the preface to ''The Four Men''.
References
External links
Windmill World
webpage on Shiremark mill.
{{Surrey Windmills
Smock mills in England
Grinding mills in the United Kingdom
Windmills completed in 1774
Listed buildings in Surrey
Windmills in Surrey
Octagonal buildings in the United Kingdom
Buildings and structures demolished in 1972
Listed windmills in the United Kingdom