log-periodic dipole array

A log-periodic antenna (LP), also known as a log-periodic array or log-periodic aerial, is a multi-element, directional antenna designed to operate over a wide band of frequencies. It was invented by John Dunlavy in 1952.

The most common form of log-periodic antenna is the log-periodic dipole array or LPDA, The LPDA consists of a number of half-wave dipole driven elements of gradually increasing length, each consisting of a pair of metal rods. The dipoles are mounted close together in a line, connected in parallel to the feedline with alternating phase. Electrically, it simulates a series of two- or three-element Yagi–Uda antennas connected together, each set tuned to a different frequency.

LPDA antennas look somewhat similar to Yagi antennas, in that they both consist of dipole rod elements mounted in a line along a support boom, but they work in very different ways. Adding elements to a Yagi increases its directionality, or gain, while adding elements to an LPDA increases its frequency response, or bandwidth.

One large application for LPDAs is in rooftop terrestrial television antennas, since they may require large bandwidth to cover various frequencies in the VHF and/or UHF bands. One widely used design for television reception combined a Yagi for UHF reception in front of a larger LPDA for VHF.

Basic concept

The LPDA normally consists of a series of half wave dipole "elements" each consisting of a pair of metal rods, positioned along a support boom lying along the antenna axis. The elements are spaced at intervals following a logarithmic function of the frequency, known as ''d'' or ''sigma''. The length of the successive elements and the spacing between them gradually decrease along the boom. The relationship between the lengths is a function known as ''tau''. ''Sigma'' and ''tau'' are the key design elements of the LPDA design. The radiation pattern of the antenna is unidirectional, with the main lobe along the axis of the boom, off the end with the shortest elements. Each dipole element is resonant at a wavelength approximately equal to twice its length. The bandwidth of the antenna, the frequency range over which it has near-maximum gain, is approximately between the resonant frequencies of the longest and shortest elements.

Every element in the LPDA antenna is a driven element, that is, connected electrically to the feedline. A parallel wire transmission line usually runs along the central boom, and each successive element is connected in ''opposite'' phase to it. The feedline can often be seen zig-zagging across the support boom holding the elements. Another common construction method is to use two parallel central support booms that also acts as the transmission line, mounting the dipoles on the alternate booms. Other forms of the log-periodic design replace the dipoles with the transmission line itself, forming the log-periodic zig-zag antenna. Many other forms using the transmission wire as the active element also exist.

The Yagi and the LPDA designs look very similar at first glance, as they both consist of a number of dipole elements mounted along a support boom. The Yagi, however, has only a single driven element connected to the transmission line, usually the second one from the back of the array, the remaining elements are parasitic. The Yagi antenna differs from the LPDA in having a very narrow bandwidth.

In general terms, at any given frequency the log-periodic design operates somewhat similar to a three-element Yagi antenna; the dipole element closest to resonant at the operating frequency acts as a driven element, with the two adjacent elements on either side as director and reflector to increase the gain, the shorter element in front acting as a director and the longer element behind as a reflector. However, the system is somewhat more complex than that, and all the elements contribute to some degree, so the gain for any given frequency is higher than a Yagi of the same dimensions as any one section of the log-periodic. However, a Yagi with the same number of elements as a log-periodic would have ''far'' higher gain, as all of those elements are improving the gain of a single driven element. In its use as a television antenna, it was common to combine a log-periodic design for VHF with a Yagi for UHF, with both halves being roughly equal in size. This resulted in much higher gain for UHF, typically on the order of 10 to 14 dB on the Yagi side and 6.5 dB for the log-periodic. But this extra gain was needed anyway in order to make up for a number of problems with UHF signals.

The log-periodic shape, according to the IEEE definition, does not align with broadband property for antennas. The broadband property of log-periodic antennas comes from its self-similarity. A planar log-periodic antenna can also be made self-complementary, such as logarithmic spiral antennas (which are not classified as log-periodic ''per se'' but among the frequency independent antennas that are also self-similar) or the log-periodic toothed design. Y. Mushiake found, for what he termed "the simplest self-complementary planar antenna," a driving point impedance of η₀/2=188.4 Ω at frequencies well within its bandwidth limits.Rumsey, V. H., ''Frequency independent antennas'', Academic Press, New York and London. 1966. . 55/ref>

History

John Dunlavy invented the log-periodic antenna in 1952 while working for the United States Air Force but was not credited with it due to its "Secret" classification. The University of Illinois at Urbana–Champaign had patented the Isbell and Mayes–Carrel antennas and licensed the design as a package exclusively to JFD Electronics in New York. Channel Master and Blonder Tongue Labs ignored the patents and produced a wide range of antennas based on that design. Lawsuits regarding the antenna patent, which the U.I. Foundation lost, evolved into the 1971 Blonder-Tongue Doctrine. This precedent governs patent litigation.

Short wave broadcast antennas

The log-periodic is commonly used as a transmitting antenna in high power shortwave broadcasting stations because its broad bandwidth allows a single antenna to transmit on frequencies in multiple bands. The log-periodic zig-zag design with up to 16 sections has been used. These large antennas are typically designed to cover 6 to 26 MHz but even larger ones have been built which operate as low as 2 MHz. Power ratings are available up to 500 kW. Instead of the elements being driven in parallel, attached to a central transmission line, the elements are driven in series, adjacent elements connected at the outer edges. The antenna shown here would have about 14 dBi gain. An antenna array consisting of two such antennas, one above the other and driven in phase has a gain of up to 17 dBi. Being log-periodic, the antenna's main characteristics (radiation pattern, gain, driving point impedance) are almost constant over its entire frequency range, with the match to a 300 Ω feed line achieving a standing wave ratio of better than 2:1 over that range.

References

Bibliography

* $ 15-5: ''The Log-Periodic Antenna'', p. 703-708.

Notes

See also

* Self-complementary antenna

External links

Antenna-Theory.com Log-Periodic Tooth Antenna PageBlonder-Tongue DoctrineLPDA Online Calculation


* ttps://www.allaboutcircuits.com/technical-articles/wi-fi-antennas-part-1-fundamentals/ All About Circuits - The Fundamentals of Wi-Fi Antennasbr>Electronics Point - Forum / Antenna Maker ProEE Power
{{Antenna Types

Radio frequency antenna types
Antennas (radio)