EC50

]
Half maximal effective concentration (EC₅₀) is a measure of the concentration of a drug, antibody or toxicant which induces a Stimulus%E2%80%93response_model, response halfway between the baseline and maximum after a specified exposure time. More simply, EC₅₀ can be defined as the ''concentration required to obtain a 50% ..effect'' and may be also written as sub>50. It is commonly used as a measure of a drug's potency, although the use of EC₅₀ is preferred over that of 'potency', which has been criticised for its vagueness. EC₅₀ is a measure of concentration, expressed in molar units (M), where 1 M is equivalent to 1  mol/ L.

The EC₅₀ of a ''graded'' dose response curve therefore represents the concentration of a compound where 50% of its maximal effect is observed.
The EC₅₀ of a ''quantal'' dose response curve represents the concentration of a compound where 50% of the population exhibit a response, after a specified exposure duration.

For clarification, a graded dose response curve shows the graded effect of the drug (y axis) over the dose of the drug (x axis) in one or an average of subjects. A quantal dose response curve shows the percentage of subjects where a response is noted in an all-or-none manner (y axis) over the dose of the drug (x axis).

For competition binding assays and functional antagonist assays IC₅₀ is the most common summary measure of the dose-response curve. For agonist/stimulator assays the most common summary measure is the EC₅₀.

The EC₅₀ is also related to IC₅₀ which is a measure of a compound's inhibition (50% inhibition).

Calculation of EC₅₀

Biological responses to ligand concentrations typically follow a sigmoidal function. The inflection point at which the increase in response with increasing ligand concentration begins to slow is the EC₅₀, which can be mathematically determined by derivation of the best-fit line. While relying on a graph for estimation is more convenient, this typical method yields less accurate results and less precise.Assay Operations for SAR Support
NIH Chemical Genomics Center

The response or effect, E, is dependent on both the binding of the drug and the drug-bound receptor. The agonist that binds to the receptor and initiates the response is usually abbreviated A or D. At low agonist concentrations, the response, E is immeasurably low but at higher E becomes measurable. E increases with until at sufficiently high when E plateaus towards an asymptotic maximum attainable response, E_max. The at which E is 50% of E_max is termed the half maximal effective concentration and is abbreviated EC₅₀, or rarely sub>50. The term "potency" refers to the EC₅₀ value. The lower the EC₅₀, the less the concentration of a drug is required to produce 50% of maximum effect and the higher the potency. The EC₁₀ and EC₉₀ concentrations to induce 10% and 90% maximal responses are defined similarly.

There is a wide range of EC₅₀ values of drugs; they are typically anywhere from nM to mM. Hence, it is often more practical to refer to the logarithmically transformed pEC₅₀ values instead of EC₅₀, where

$\ce = -\log_ (\ce)$.

Relation to affinity and efficacy

A drug's potency is dependent on the drug's Dissociation constant#Protein-ligand binding, affinity and efficacy.

Affinity

Affinity describes how well a drug can bind to a receptor. Faster or stronger binding is represented by a higher affinity, or equivalently a lower dissociation constant. The EC₅₀ should not be confused with the affinity constant, K_d. While the former reflects the drug concentration needed for a level of tissue response, the latter reflects the drug concentration needed for an amount of receptor binding.

Efficacy

Efficacy is the relationship between receptor occupancy and the ability to initiate a response at the molecular, cellular, tissue or system level.

Relation to the Hill Equation

The EC₅₀ relates to the Hill equation, which is a function of the agonist concentration,

:$E = \frac$

where E is the observed response or effect above baseline, and nH, the Hill coefficient reflects the slope of the curve.EC50 equation

The EC₅₀ represents the point of inflection of the Hill equation, beyond which increases of have less impact on E. In dose response curves, the logarithm of is often taken, turning the Hill equation into a sigmoidal logistic function. In this case, the EC₅₀ represents the rising section of the sigmoid curve.

Limitations

The effects of a stressor or drug generally depend on the exposure time. Therefore, the EC₅₀ (and similar statistics) will be a function of exposure time. The exact shape of this time function will depend upon the stressor (e.g., the specific toxicant), its mechanism of action, the organism exposed, etc. This time dependency hampers the comparison of potency or toxicity between compounds and between different organisms.

A drug will not have a single value of EC₅₀ due to different tissues having different sensitivities to the drug (in part due to tissue specific receptor expression). Furthermore, EC₅₀ is dependent on many factors including species, tissue and cell type and genetics.

See also

* Measures of pollutant concentration
* Certain safety factor
* LD₅₀ (median lethal dose)
* Therapeutic index

References

External links

Determination of IC₅₀ values

Concentration indicators
Pharmacodynamics
Toxicology

{{pharmacology