|
Controller-area Network
A controller area network bus (CAN bus) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts. This broadcast-based, message-oriented protocol ensures data integrity and prioritization through a process called arbitration, allowing the highest priority device to continue transmitting if multiple devices attempt to send data simultaneously, while others back off. Its reliability is enhanced by differential signaling, which mitigates electrical noise. Common versions of the CAN protocol include CAN 2.0, CAN FD, and CAN XL which vary in their data rate capabilities and maximum data payload sizes. History Development of the CAN bus started in 1983 at Robert Bosch GmbH. The protocol was officially released in 1986 at the Society of ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Serial Communication
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication, where several bits are sent as a whole, on a link with several parallel channels. Serial communication is used for all long-haul communication and most computer networks, where the cost of cable and difficulty of synchronization make parallel communication impractical. Serial computer buses have become more common even at shorter distances, as improved signal integrity and transmission speeds in newer serial technologies have begun to outweigh the parallel bus's advantage of simplicity (no need for serializer and deserializer, or SerDes) and to outstrip its disadvantages (clock skew, interconnect density). The migration from PCI to PCI Express (PCIe) is an example. Modern high speed serial interfaces such as PCIe send data several bits at a time using m ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Philips
Koninklijke Philips N.V. (), simply branded Philips, is a Dutch multinational health technology company that was founded in Eindhoven in 1891. Since 1997, its world headquarters have been situated in Amsterdam, though the Benelux headquarters is still in Eindhoven. The company gained its royal honorary title in 1998. Philips was founded by Gerard Philips and his father Frederik, with their first products being light bulbs. Through the 20th century, it grew into one of the world's largest electronics conglomerates, with global market dominance in products ranging from kitchen appliances and electric shavers to light bulbs, televisions, cassettes, and compact discs (both of which were invented by Philips). At one point, it played a dominant role in the entertainment industry (through PolyGram). However, intense competition from primarily East Asian competitors throughout the 1990s and 2000s led to a period of downsizing, including the divestment of its lighting and c ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Anti-lock Braking System
An anti-lock braking system (ABS) is a Automotive safety, safety anti-Skid (automobile), skid Brake, braking system used on aircraft and on land motor vehicle, vehicles, such as cars, motorcycles, trucks, and buses. ABS operates by preventing the wheels from locking up during braking, thereby maintaining Traction (mechanics), tractive contact with the road surface and allowing the driver to maintain more control over the vehicle. ABS is an automated system that uses the principles of threshold braking and cadence braking, techniques which were once practiced by skillful drivers before ABS was widespread. ABS operates at a much faster rate and more effectively than most drivers could manage. Although ABS generally offers improved vehicle control and decreases stopping distances on dry and some slippery surfaces, on loose gravel or snow-covered surfaces ABS may significantly increase braking distance, while still improving steering control. Since ABS was introduced in production v ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Airbag
An airbag is a vehicle occupant-restraint system using a bag designed to inflate in milliseconds during a collision and then deflate afterwards. It consists of an airbag cushion, a flexible fabric bag, an inflation module, and an impact sensor. The purpose of the airbag is to provide a vehicle occupant with soft cushioning and restraint during a collision. It can reduce injuries between the flailing occupant and the vehicle's interior. The airbag provides an energy-absorbing surface between the vehicle's occupants and a steering wheel, instrument panel, body pillar, headliner, and windshield. Modern vehicles may contain up to ten airbag modules in various configurations, including driver, passenger, side-curtain, seat-mounted, door-mounted, B- and C-pillar mounted side-impact, knee bolster, inflatable seat belt, and pedestrian airbag modules. During a crash, the vehicle's crash sensors provide crucial information to the airbag electronic controller unit (ECU), including colli ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Transmission (mechanics)
A transmission (also called a gearbox) is a mechanical device invented by Louis Renault (industrialist), Louis Renault (who founded Renault, Renault) which uses a gear set—two or more gears working together—to change the speed, direction of rotation, or torque multiplication/reduction in a machine. Transmissions can have a single fixed-gear ratio, multiple distinct gear ratios, or continuously variable ratios. Variable-ratio transmissions are used in all sorts of machinery, especially vehicles. Applications Early uses Early transmissions included the right-angle drives and other gearing in windmills, horse-powered devices, and steam engine, steam-powered devices. Applications of these devices included pumps, mill (grinding), mills and Hoist (device), hoists. Bicycles Bicycles traditionally have used hub gear or Derailleur gear transmissions, but there are other more recent design innovations. Automobiles Since the torque and Horsepower, power output of an interna ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Engine Control Unit
An engine control unit (ECU), also called an engine control module (ECM), is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems. The earliest ECUs (used by aircraft engines in the late 1930s) were mechanical-hydraulic units; however, most 21st-century ECUs operate using digital electronics. Functions The main functions of the ECU are typically: * Fuel injection system * Ignition system * Idle speed control (typically either via an idle air control valve or the electronic throttle system) * Variable valve timing and/or variable valve lift systems The sensors used by the ECU include: * accelerator pedal position sensor * camshaft position sensor * coolant temperature sensor * crankshaft position sensor * knock sensors * inlet manifold pressure sensor ( MAP sensor) * intake air temperature * intake air mass flow rate sensor ( MAF sensor) * oxygen (lambda) s ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Model Railway
Railway modelling (UK, Australia, New Zealand, and Ireland) or model railroading (US and Canada) is a hobby in which rail transport systems are Model building, modelled at a reduced Scale (ratio), scale. The scale models include locomotives, rolling stock, streetcars, rail tracks, tracks, Railway signal, signalling, Crane (machine), cranes, and landscapes including: countryside, roads, bridges, buildings, vehicles, harbors, urban landscape, model figures, lights, and features such as rivers, hills, tunnels, and canyons. The earliest model railways were the 'carpet railways' in the 1840s. The first documented model railway was the Railway of the Prince Imperial (French: Chemin de fer du Prince Impérial) built in 1859 by Emperor Napoleon III for his then 3-year-old son, also Louis-Napoléon, Prince Imperial, Napoleon, in the grounds of the Château de Saint-Cloud in Paris. It was powered by clockwork and ran in a figure-of-eight. Electric trains appeared around the start of t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pedelec
A Pedelec (from pedal electric cycle) or EPAC (''electronically power assisted cycle''), is a type of low-powered electric bicycle where the rider's pedalling is assisted by a small electric motor. However, unlike some other types of e-bikes, pedelecs are classified as conventional bicycles in many countries by road authorities rather than as a type of electric moped. Pedelecs have an electronic controller that cuts power to the motor when the rider is not pedalling or when a certain speed – usually or – is reached. Pedelecs are useful for people who ride in hilly areas or in strong headwinds. While a pedelec can be any type of bicycle, a pedelec European city bike, city bike is common. A conventional bicycle can be converted to a pedelec with the addition of the necessary parts, e.g., motor, battery, etc. Many jurisdictions #Legal status of pedelecs worldwide, classify pedelecs as bicycles as opposed to mopeds or motorcycles. More powerful e-bikes, such as the Electric b ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Model Year
The model year (sometimes abbreviated as MY) is a method of describing the version of a product which has been produced over multiple years. The model year may or may not be the same as the calendar year in which the product was manufactured. Automobiles United States and Canada Automobiles in the United States and Canada are identified and regulated by model year, whereas other markets use production date (month/year) to identify specific vehicles, and model codes in place of the "year" (model year) in the North American make-model-year identifier. In technical documents generated within the auto industry and its regulating agencies such as the U.S. National Highway Traffic Safety Administration and United States Environmental Protection Agency and Transport Canada and Environment Canada, the letters ''MY'' often precede the year (as in ''MY2019'' or ''MY93''). Even without this prefix, however, in the North American context it is usually the model year rather than the ve ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
On-board Diagnostics
On-board diagnostics (OBD) is a term referring to a vehicle's self-diagnostic and reporting capability. In the United States, this capability is a requirement to comply with United States vehicle emission standards, federal emissions standards to detect failures that may increase the vehicle tailpipe Air pollution, emissions to more than 150% of the standard to which it was originally certified. OBD systems give the vehicle owner or repair technician access to the status of the various vehicle sub-systems. The amount of diagnostic information available via OBD has varied widely since its introduction in the early 1980s versions of onboard vehicle computers. Early versions of OBD would simply illuminate a Tell-tale (automotive), tell-tale light if a problem was detected, but would not provide any information as to the nature of the problem. Modern OBD implementations use a standardized digital communications port to provide real-time data and Table of OBD-II Codes, diagnostic tro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Data Link Layer
The data link layer, or layer 2, is the second layer of the seven-layer OSI model of computer networking. This layer is the protocol layer that transfers data between nodes on a network segment across the physical layer. The data link layer provides the functional and procedural means to transfer data between network entities and may also provide the means to detect and possibly correct errors that can occur in the physical layer. The data link layer is concerned with local delivery of frames between nodes on the same level of the network. Data-link frames, as these protocol data units are called, do not cross the boundaries of a local area network. Inter-network routing and global addressing are higher-layer functions, allowing data-link protocols to focus on local delivery, addressing, and media arbitration. In this way, the data link layer is analogous to a neighborhood traffic cop; it endeavors to arbitrate between parties contending for access to a medium, without c ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
