|
Bandwidth Management
Bandwidth management is the process of measuring and controlling the communications (traffic, packets) on a network link, to avoid filling the link to capacity or overfilling the link,https://www.internetsociety.org/wp-content/uploads/2017/08/BWroundtable_report-1.0.pdf Internet Society on Bandwidth Management which would result in network congestion and poor performance of the network. Bandwidth is described by bit rate and measured in units of bits per second (bit/s) or bytes per second (B/s). Bandwidth management mechanisms and techniques Bandwidth management mechanisms may be used to further engineer performance and includes: * Traffic shaping ( rate limiting): ** Token bucket **Leaky bucket ** TCP rate control - artificially adjusting TCP window size as well as controlling the rate of ACKs being returned to the sender * Scheduling algorithms: ** Weighted fair queuing (WFQ) ** Class based weighted fair queuing ** Weighted round robin (WRR) ** Deficit weighted round ro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Congestion
Network congestion in data networking and queueing theory is the reduced quality of service that occurs when a network node or link is carrying more data than it can handle. Typical effects include queueing delay, packet loss or the blocking of new connections. A consequence of congestion is that an incremental increase in offered load leads either only to a small increase or even a decrease in network throughput. Network protocols that use aggressive retransmissions to compensate for packet loss due to congestion can increase congestion, even after the initial load has been reduced to a level that would not normally have induced network congestion. Such networks exhibit two stable states under the same level of load. The stable state with low throughput is known as congestive collapse. Networks use congestion control and congestion avoidance techniques to try to avoid collapse. These include: exponential backoff in protocols such as CSMA/CA in 802.11 and the similar CSMA/CD ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Congestion Avoidance
Network congestion in data networking and queueing theory is the reduced quality of service that occurs when a network node or link is carrying more data than it can handle. Typical effects include queueing delay, packet loss or the blocking of new connections. A consequence of congestion is that an incremental increase in offered load leads either only to a small increase or even a decrease in network throughput. Network protocols that use aggressive retransmissions to compensate for packet loss due to congestion can increase congestion, even after the initial load has been reduced to a level that would not normally have induced network congestion. Such networks exhibit two stable states under the same level of load. The stable state with low throughput is known as congestive collapse. Networks use congestion control and congestion avoidance techniques to try to avoid collapse. These include: exponential backoff in protocols such as CSMA/CA in 802.11 and the similar CSMA/CD ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Quality Of Service
Quality of service (QoS) is the description or measurement of the overall performance of a service, such as a telephony or computer network, or a cloud computing service, particularly the performance seen by the users of the network. To quantitatively measure quality of service, several related aspects of the network service are often considered, such as packet loss, bit rate, throughput, transmission delay, availability, jitter, etc. In the field of computer networking and other packet-switched telecommunication networks, quality of service refers to traffic prioritization and resource reservation control mechanisms rather than the achieved service quality. Quality of service is the ability to provide different priorities to different applications, users, or data flows, or to guarantee a certain level of performance to a data flow. Quality of service is particularly important for the transport of traffic with special requirements. In particular, developers have introduced Vo ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Congestion
Network congestion in data networking and queueing theory is the reduced quality of service that occurs when a network node or link is carrying more data than it can handle. Typical effects include queueing delay, packet loss or the blocking of new connections. A consequence of congestion is that an incremental increase in offered load leads either only to a small increase or even a decrease in network throughput. Network protocols that use aggressive retransmissions to compensate for packet loss due to congestion can increase congestion, even after the initial load has been reduced to a level that would not normally have induced network congestion. Such networks exhibit two stable states under the same level of load. The stable state with low throughput is known as congestive collapse. Networks use congestion control and congestion avoidance techniques to try to avoid collapse. These include: exponential backoff in protocols such as CSMA/CA in 802.11 and the similar CSMA/CD ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Burstiness
In statistics, burstiness is the intermittent increases and decreases in activity or frequency of an event.Lambiotte, R. (2013.) "Burstiness and Spreading on Temporal Networks", University of Namur. One of measures of burstiness is the Fano factor—a ratio between the variance and mean of counts. Burstiness is observable in natural phenomena, such as natural disasters, or other phenomena, such as network/data/email network traffic or vehicular traffic. Burstiness is, in part, due to changes in the probability distribution of inter-event times. Distributions of bursty processes or events are characterised by heavy, or fat, tails. Burstiness of inter-contact time between nodes in a time-varying network can decidedly slow spreading processes over the network. This is of great interest for studying the spread of information and disease. Burstiness Score One relatively simple measure of burstiness is burstiness score. The burstiness score of a subset t of time period T relative t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Jitter
In electronics and telecommunications, jitter is the deviation from true periodicity of a presumably periodic signal, often in relation to a reference clock signal. In clock recovery applications it is called timing jitter. Jitter is a significant, and usually undesired, factor in the design of almost all communications links. Jitter can be quantified in the same terms as all time-varying signals, e.g., root mean square (RMS), or peak-to-peak displacement. Also, like other time-varying signals, jitter can be expressed in terms of spectral density. Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies jitter frequencies below 10 Hz as wander and frequencies at or above 10 Hz as jitter. Jitter may be caused by electromagnetic interference and crosstalk with carriers of other signals. Jit ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Latency (engineering)
Latency, from a general point of view, is a time delay between the cause and the effect of some physical change in the system being observed. Lag, as it is known in gaming circles, refers to the latency between the input to a simulation and the visual or auditory response, often occurring because of network delay in online games. Latency is physically a consequence of the limited velocity at which any physical interaction can propagate. The magnitude of this velocity is always less than or equal to the speed of light. Therefore, every physical system with any physical separation (distance) between cause and effect will experience some sort of latency, regardless of the nature of the stimulation at which it has been exposed to. The precise definition of latency depends on the system being observed or the nature of the simulation. In communications, the lower limit of latency is determined by the medium being used to transfer information. In reliable two-way communication s ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
TCP Congestion Control
Transmission Control Protocol (TCP) uses a network congestion-avoidance algorithm that includes various aspects of an additive increase/multiplicative decrease (AIMD) scheme, along with other schemes including slow start and congestion window (CWND), to achieve congestion avoidance. The TCP congestion-avoidance algorithm is the primary basis for congestion control in the Internet. Per the end-to-end principle, congestion control is largely a function of internet hosts, not the network itself. There are several variations and versions of the algorithm implemented in protocol stacks of operating systems of computers that connect to the Internet. To avoid congestive collapse, TCP uses multi-faceted congestion-control strategy. For each connection, TCP maintains a CWND, limiting the total number of unacknowledged packets that may be in transit end-to-end. This is somewhat analogous to TCP's sliding window used for flow control. Additive increase/multiplicative decrease The a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Transmission Control Protocol
The Transmission Control Protocol (TCP) is one of the main protocols of the Internet protocol suite. It originated in the initial network implementation in which it complemented the Internet Protocol (IP). Therefore, the entire suite is commonly referred to as TCP/IP. TCP provides reliable, ordered, and error-checked delivery of a stream of octets (bytes) between applications running on hosts communicating via an IP network. Major internet applications such as the World Wide Web, email, remote administration, and file transfer rely on TCP, which is part of the Transport Layer of the TCP/IP suite. SSL/TLS often runs on top of TCP. TCP is connection-oriented, and a connection between client and server is established before data can be sent. The server must be listening (passive open) for connection requests from clients before a connection is established. Three-way handshake (active open), retransmission, and error detection adds to reliability but lengthens latency. A ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Traffic Classification
Traffic classification is an automated process which categorises computer network traffic according to various parameters (for example, based on port number or protocol) into a number of ''traffic classes''. Each resulting traffic class can be treated differently in order to differentiate the service implied for the data generator or consumer. Typical uses Packets are classified to be differently processed by the network scheduler. Upon classifying a traffic flow using a particular protocol, a predetermined policy can be applied to it and other flows to either guarantee a certain quality (as with VoIP or media streaming service) or to provide best-effort delivery. This may be applied at the ingress point (the point at which traffic enters the network, typically an edge device) with a granularity that allows traffic management mechanisms to separate traffic into individual flows and queue, police and shape them differently.Ferguson P., Huston G., Quality of Service: Delivering Q ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Top-nodes Algorithm
The top-nodes algorithm is an algorithm for managing a resource reservation calendar. The algorithm has been first published in 2003, and has been improved in 2009. It is used when a resource is shared among many users (for example bandwidth in a telecommunication link, or disk capacity in a large data center). The algorithm allows users to: * check if an amount of resource is available during a specific period of time, * reserve an amount of resource for a specific period of time, * delete a previous reservation, * move the calendar forward (the calendar covers a defined duration, and it must be moved forward as time goes by). Principle The calendar is stored as a binary tree where leaves represent elementary time periods. Other nodes represent the period of time covered by all their descendants. The period of time covered by a reservation is represented by a set of "top-nodes". This set is the minimal set of nodes that exactly cover the reservation period of time. A node of ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Constraint-based Routing Label Distribution Protocol
Constraint-based Routing Label Distribution Protocol (CR-LDP) is a control protocol used in some computer networks. As of February 2003, the IETF MPLS working group deprecated CR-LDP and decided to focus purely on RSVP-TE. It is an extension of the Label Distribution Protocol (LDP), one of the protocols in the Multiprotocol Label Switching architecture. CR-LDP contains extensions for LDP to extend its capabilities such as setup paths beyond what is available for the routing protocol. For instance, a Label Switched Path can be set up based on explicit route constraints, quality of service constraints, and other constraints. Constraint-based routing (CR) is a mechanism used to meet traffic engineering requirements. These requirements are met by extending LDP for support of constraint-based routed label switched paths (CR-LSPs). Other uses for CR-LSPs include MPLS-based virtual private network A virtual private network (VPN) extends a private network across a public network ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
