Super Turbine 300
   HOME

TheInfoList



OR:

The Super Turbine 300 (abbreviated ST-300) was a two-speed
automatic transmission An automatic transmission (sometimes abbreviated to auto or AT) is a multi-speed transmission used in internal combustion engine-based motor vehicles that does not require any input from the driver to change forward gears under normal driving ...
built by
General Motors The General Motors Company (GM) is an American Multinational corporation, multinational Automotive industry, automotive manufacturing company headquartered in Detroit, Michigan, United States. It is the largest automaker in the United States and ...
. It was used in various
Buick Buick () is a division of the American automobile manufacturer General Motors (GM). Started by automotive pioneer David Dunbar Buick in 1899, it was among the first American marques of automobiles, and was the company that established General ...
,
Oldsmobile Oldsmobile or formally the Oldsmobile Division of General Motors was a brand of American automobiles, produced for most of its existence by General Motors. Originally established as "Olds Motor Vehicle Company" by Ransom E. Olds in 1897, it pro ...
, and
Pontiac Pontiac may refer to: *Pontiac (automobile), a car brand *Pontiac (Ottawa leader) ( – 1769), a Native American war chief Places and jurisdictions Canada *Pontiac, Quebec, a municipality ** Apostolic Vicariate of Pontiac, now the Roman Catholic D ...
models from 1964-1969. It was the same transmission marketed under different brand names by each division including ST-300 by Buick, Jetaway by Olds and simply Automatic by Pontiac.


Design

The ST300 had a three-element
torque converter A torque converter is a type of fluid coupling that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque converter connects the p ...
, a front and rear multiple-disc
clutch A clutch is a mechanical device that engages and disengages power transmission, especially from a drive shaft to a driven shaft. In the simplest application, clutches connect and disconnect two rotating shafts (drive shafts or line shafts). ...
pack, and a compound
planetary gearset An epicyclic gear train (also known as a planetary gearset) consists of two gears mounted so that the center of one gear revolves around the center of the other. A carrier connects the centers of the two gears and rotates the planet and sun gea ...
with a front band and a clutch pack for reverse and manual low gear. The unit was cooled with a small auxiliary oil cooler located beneath the engine
radiator Radiators are heat exchangers used to transfer thermal energy from one medium to another for the purpose of cooling and heating. The majority of radiators are constructed to function in cars, buildings, and electronics. A radiator is always ...
. It had a die cast
aluminum Aluminium (aluminum in American and Canadian English) is a chemical element with the symbol Al and atomic number 13. Aluminium has a density lower than those of other common metals, at approximately one third that of steel. It ha ...
case, and weighed . It was designed to start in low gear, providing a
gear ratio A gear train is a mechanical system formed by mounting gears on a frame so the teeth of the gears engage. Gear teeth are designed to ensure the Pitch circle diameter (gears), pitch circles of engaging gears roll on each other without slipping, pr ...
of 1.765:1 plus the additional low-speed multiplication of the torque converter. The shift pattern was Park-Reverse-Neutral-Drive-Low. In Drive at full throttle, it would upshift from low gear to high gear at . Under light throttle, depending on the final drive ratio, it might upshift at 10-15 mph. From 1964-1967, Buick and Oldsmobile versions of this transmission used a torque converter with a variable-pitch
stator The stator is the stationary part of a rotary system, found in electric generators, electric motors, sirens, mud motors or biological rotors. Energy flows through a stator to or from the rotating component of the system. In an electric m ...
called Switch-Pitch (by Buick) or Variable Vane (by Oldsmobile). The stator blades moved from high to low position by an electrical
solenoid upright=1.20, An illustration of a solenoid upright=1.20, Magnetic field created by a seven-loop solenoid (cross-sectional view) described using field lines A solenoid () is a type of electromagnet formed by a helix, helical coil of wire whose ...
and a stator
valve A valve is a device or natural object that regulates, directs or controls the flow of a fluid (gases, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways. Valves are technically fitting ...
, controlled by a switch on the
throttle A throttle is the mechanism by which fluid flow is managed by constriction or obstruction. An engine's power can be increased or decreased by the restriction of inlet gases (by the use of a throttle), but usually decreased. The term ''throttle' ...
linkage. At light to medium throttle, the stator blades were at 32°, providing a torque multiplication of 1.8:1 and a converter stall speed of approximately 1800 rpm. At ⅔ to full throttle, the blades switched to the 51° high position, giving torque multiplication of 2.45:1 and a stall speed of approximately 2300 rpm. The blades were also set to the high position at idle to limit creep when stopped in Drive. The variable-pitch stator was eliminated after 1967. This feature was not used on the Pontiac versions of this transmission.


History

The Super Turbine 300 (Jetaway) was introduced for the 1964
model year The model year (sometimes abbreviated "MY") is a method of describing the version of a product which has been produced over multiple years. The model year may or may not be the same as the calendar year in which the product was manufactured. ...
as a replacement for the earlier Buick Dual-path and Oldsmobile/Pontiac Roto Hydramatic transmissions. It was offered on GM A platform cars, namely the Buick Skylark, Oldsmobile Cutlass, Pontiac Tempest/Lemans/GTO through 1966, and was available on the full-sized Buick LeSabre, Oldsmobile 88, Oldsmobile Jetstar 88, and Delmont 88 as a less expensive alternative to the three-speed Turbo-Hydramatic. This transmission was only produced with the "BOP" bell housing and was never used on any Chevrolet or Chevrolet based engines. From 1967-1969, the Super Turbine 300 was also available on the sporty
Pontiac Firebird The Pontiac Firebird is an American automobile that was built and produced by Pontiac from the 1967 to 2002 model years. Designed as a pony car to compete with the Ford Mustang, it was introduced on February 23, 1967, five months after GM's ...
with the overhead cam inline six (230 and 250 cubic inches) or small V8 engines (326 and 350 cubic inches). Some of the rare later ST300's had a bell housing that was cast like a "multi-case", but some were never drilled from the factory for the Chevrolet pattern in the United States other than the two lowest bolt holes that are shared, and never installed on any Chevy engine from the factory in the United States. It conceivably could have been drilled for the Chevrolet but there was never a reason to do that as the Powerglide was a strong transmission. The Super Turbine 300 was discontinued entirely after the 1969 model year in favor of the TH400 and lighter TH350 Turbo-Hydramatic, the latter using the Super Turbine 300's tailhousing. Due to its two-speed with torque converter design, the Super Turbine 300 is often confused with Chevrolet's
Powerglide The Powerglide is a two-speed automatic transmission designed by General Motors. It was available primarily on Chevrolet from January 1950 through 1973, although some Pontiac models also used this automatic transmission after the fire at the Hyd ...
— which was also a two-speed torque converter transmission, but the ST 300 had a different design from the Chevy unit, which had been around since 1950. The low band was the same as the 1955 up PG along with the same style clutch plates. The internal operation of the ST300 automatic was similar to the 1962-1971 Powerglide and almost indistinguishable. Few parts were interchangeable. The ST300, used with V-8 engines had additional clutches in the clutch packs, so they could handle the extra power of the larger engines. One of the clutch drums and/or apply piston in the ST300 was often used to 'beef-up' a Powerglide for high performance/racing uses. Chevrolet 'beefed-up' the Powerglide by using a different planetary gear ratio.


Notes


External links

{{Powertrain Automatic transmission tradenames General Motors transmissions