Skye Treck Skyseeker
   HOME

TheInfoList



OR:

The Skye Treck Skyseeker is a Canadian
ultralight aircraft Ultralight aviation (called microlight aviation in some countries) is the flying of lightweight, 1- or 2-seat fixed-wing aircraft. Some countries differentiate between weight-shift control and conventional three-axis control aircraft with ailer ...
that was designed and produced by Skye Treck of
Manitoba Manitoba ( ) is a Provinces and territories of Canada, province of Canada at the Centre of Canada, longitudinal centre of the country. It is Canada's Population of Canada by province and territory, fifth-most populous province, with a population o ...
. The aircraft was supplied as a kit for amateur construction.Cliche, Andre: ''Ultralight Aircraft Shopper's Guide'' 8th Edition, page E-36. Cybair Limited Publishing, 2001.


Design and development

The aircraft was designed to comply with the US
FAR 103 Ultralight Vehicles Ultralight aircraft in the United States are much smaller and lighter than ultralight aircraft as defined by all other countries. In the United States, ultralights are described as "ultralight vehicles" and not as aircraft. They are not requ ...
rules, including the category's maximum empty weight of . The aircraft has a standard empty weight of . It features a cable-braced
high-wing A monoplane is a fixed-wing aircraft configuration with a single mainplane, in contrast to a biplane or other types of multiplanes, which have multiple planes. A monoplane has inherently the highest efficiency and lowest drag of any wing confi ...
, a single-seat, open cockpit,
conventional landing gear Conventional landing gear, or tailwheel-type landing gear, is an aircraft undercarriage consisting of two main wheels forward of the center of gravity and a small wheel or skid to support the tail.Crane, Dale: ''Dictionary of Aeronautical Term ...
and a single engine in
pusher configuration In an aircraft with a pusher configuration (as opposed to a tractor configuration), the propeller(s) are mounted behind their respective engine(s). Since a pusher propeller is mounted behind the engine, the drive shaft is in compression in nor ...
. The aircraft is made from bolted-together
aluminium Aluminium (aluminum in American and Canadian English) is a chemical element with the symbol Al and atomic number 13. Aluminium has a density lower than those of other common metals, at approximately one third that of steel. I ...
tubing, with the flying surfaces covered in
Dacron Polyethylene terephthalate (or poly(ethylene terephthalate), PET, PETE, or the obsolete PETP or PET-P), is the most common thermoplastic polymer resin of the polyester family and is used in fibres for clothing, containers for liquids and foods ...
sailcloth. Its single-surface span wing's cable bracing is supported by a single kingpost. The pilot is accommodated on an open seat, without a windshield. The
landing gear Landing gear is the undercarriage of an aircraft or spacecraft that is used for takeoff or landing. For aircraft it is generally needed for both. It was also formerly called ''alighting gear'' by some manufacturers, such as the Glenn L. Martin ...
features bungee suspension on all three wheels and the tail wheel is steerable. No brakes are fitted. The standard engine supplied was the single cylinder
two-stroke A two-stroke (or two-stroke cycle) engine is a type of internal combustion engine that completes a Thermodynamic power cycle, power cycle with two strokes (up and down movements) of the piston during one power cycle, this power cycle being comple ...
Rotax 277 The Rotax 277 is a , single-cylinder, two-stroke aircraft engine, that was built by BRP-Rotax GmbH & Co. KG of Austria for use in ultralight aircraft.Raisner, William: ''LEAF catlog'', pages 6-105. Leading Edge Airfoils, 1995. Development The ...
of and it is mounted on the wing trailing edge, with the propeller turning in between the tail boom tubes. The engine utilizes a 2:1 belt reduction drive with a
centrifugal clutch A centrifugal clutch is an automatic clutch that uses centrifugal force to operate. The output shaft is disengaged at low rotational speed and engages more as speed increases. It is often used in mopeds, underbones, lawn mowers, go-karts, chainsaws ...
to allow the propeller to stop when the engine is at idle. The Skyseeker sold in very large numbers in the 1980s in Canada.


Variants

;Skyseeker Mk I :Initial single seat version with hybrid weight-shift and aerodynamic controls. ;Skyseeker Mk II :Two seat version. ;Skyseeker Mk III :Improved single seat version with three-axis aerodynamic controls, with spoilers for roll control.


Aircraft on display

* British Columbia Aviation Museum


Specifications (Skyseeker Mk III)


References

{{reflist


External links


Photo of Skyseeker Mk III
1980s Canadian ultralight aircraft Homebuilt aircraft Single-engined pusher aircraft