Network attached storage

Network-attached storage (NAS) is a file-level (as opposed to block-level storage) computer data storage server connected to a computer network providing data access to a heterogeneous group of clients. The term "NAS" can refer to both the technology and systems involved, or a specialized device built for such functionality (as unlike tangentially related technologies such as local area networks, a NAS device is often a singular unit).

A NAS device is optimised for serving files either by its hardware, software, or configuration. It is often manufactured as a computer appliance a purpose-built specialized computer. NAS systems are networked appliances that contain one or more storage drives, often arranged into logical, redundant storage containers or RAID. Network-attached storage typically provide access to files using network file sharing protocols such as NFS, SMB, or AFP. From the mid-1990s, NAS devices began gaining popularity as a convenient method of sharing files among multiple computers, as well as to remove the responsibility of file serving from other servers on the network; by doing so, a NAS can provide faster data access, easier administration, and simpler configuration as opposed to using general-purpose server to serve files.

Accompanying a NAS are purpose-built hard disk drives, which are functionally similar to non-NAS drives but may have different firmware, vibration tolerance, or power dissipation to make them more suitable for use in RAID arrays, a technology often used in NAS implementations. For example, some NAS versions of drives support a command extension to allow extended error recovery to be disabled. In a non-RAID application, it may be important for a disk drive to go to great lengths to successfully read a problematic storage block, even if it takes several seconds. In an appropriately configured RAID array, a single bad block on a single drive can be recovered completely via the redundancy encoded across the RAID set. If a drive spends several seconds executing extensive retries it might cause the RAID controller to flag the drive as "down" whereas if it simply replied promptly that the block of data had a checksum error, the RAID controller would use the redundant data on the other drives to correct the error and continue without any problem. Such a "NAS" SATA hard disk drive can be used as an internal PC hard drive, without any problems or adjustments needed, as it simply supports additional options and may possibly be built to a higher quality standard (particularly if accompanied by a higher quoted MTBF figure and higher price) than a regular consumer drive.

Description

A NAS unit is a computer connected to a network that provides only file-based data storage services to other devices on the network. Although it may technically be possible to run other software on a NAS unit, it is usually not designed to be a general-purpose server. For example, NAS units usually do not have a keyboard or display, and are controlled and configured over the network, often using a browser.

A full-featured operating system is not needed on a NAS device, so often a stripped-down operating system is used. For example, TrueNAS or XigmaNAS, both open source NAS solutions designed for commodity PC hardware, are implemented as a stripped-down version of FreeBSD.

NAS systems contain one or more hard disk drives, often arranged into logical, redundant storage containers or RAID.

NAS uses file-based protocols such as NFS (popular on UNIX systems), SMB (Server Message Block) (used with Microsoft Windows systems), AFP (used with Apple Macintosh computers), or NCP (used with OES and Novell NetWare). NAS units rarely limit clients to a single protocol.

Comparing with DAS

The key difference between direct-attached storage (DAS) and NAS is that DAS is simply an extension to an existing server and is not necessarily networked. As the name suggests, DAS typically is connected via a USB or Thunderbolt enabled cable. NAS is designed as an easy and self-contained solution for sharing files over the network.

Both DAS and NAS can potentially increase availability of data by using RAID or clustering.

When both are served over the network, NAS could have better performance than DAS, because the NAS device can be tuned precisely for file serving which is less likely to happen on a server responsible for other processing. Both NAS and DAS can have various amount of cache memory, which greatly affects performance. When comparing use of NAS with use of local (non-networked) DAS, the performance of NAS depends mainly on the speed of and congestion on the network. With the introduction of new WiFi standards (like WiFi6), networking speeds and dramatically increase to allow better performance when using a NAS.

NAS is generally not as customizable in terms of hardware (CPU, memory, storage components) or low level software (extensions, plug-ins, additional protocols) but most NAS solutions will include the option to install a wide array of software applications to allow better configuration of the system or to include other capabilities outside of storage (like video surveillance, virtualization, media, etc). DAS typically is focused solely on data storage but capabilities can be available based on specific vendor options.

Comparing with SAN

NAS provides both storage and a file system. This is often contrasted with SAN (storage area network), which provides only block-based storage and leaves file system concerns on the "client" side. SAN protocols include Fibre Channel, iSCSI, ATA over Ethernet (AoE) and HyperSCSI.

One way to loosely conceptualize the difference between a NAS and a SAN is that NAS appears to the client OS (operating system) as a file server (the client can map network drives to shares on that server) whereas a disk available through a SAN still appears to the client OS as a disk, visible in disk and volume management utilities (along with client's local disks), and available to be formatted with a file system and mounted.

Despite their differences, SAN and NAS are not mutually exclusive and may be combined as a SAN-NAS hybrid, offering both file-level protocols (NAS) and block-level protocols (SAN) from the same system. An example of this is Openfiler, a free software product running on Linux-based systems. A shared disk file system can also be run on top of a SAN to provide filesystem services.

History

In the early 1980s, the "Newcastle Connection" by Brian Randell and his colleagues at Newcastle University demonstrated and developed remote file access across a set of UNIX machines. Novell's NetWare server operating system and NCP protocol was released in 1983. Following the Newcastle Connection, Sun Microsystems' 1984 release of NFS allowed network servers to share their storage space with networked clients. 3Com and Microsoft would develop the LAN Manager software and protocol to further this new market. 3Com's 3Server and 3+Share software was the first purpose-built server (including proprietary hardware, software, and multiple disks) for open systems servers.

Inspired by the success of file servers from Novell, IBM, and Sun, several firms developed dedicated file servers. While 3Com was among the first firms to build a dedicated NAS for desktop operating systems, Auspex Systems was one of the first to develop a dedicated NFS server for use in the UNIX market. A group of Auspex engineers split away in the early 1990s to create the integrated NetApp FAS, which supported both the Windows SMB and the UNIX NFS protocols and had superior scalability and ease of deployment. This started the market for proprietary