Frontogenesis
   HOME

TheInfoList



OR:

Frontogenesis is a meteorological process of tightening of horizontal temperature gradients to produce fronts. In the end, two types of fronts form:
cold front A cold front is the leading edge of a cooler mass of air at ground level that replaces a warmer mass of air and lies within a pronounced surface trough of low pressure. It often forms behind an extratropical cyclone (to the west in the Northern ...
s and
warm front A warm front is a density discontinuity located at the leading edge of a homogeneous warm air mass, and is typically located on the equator-facing edge of an isotherm gradient. Warm fronts lie within broader troughs of low pressure than cold f ...
s. A cold front is a narrow line where temperature decreases rapidly. A warm front is a narrow line of warmer temperatures and essentially where much of the precipitation occurs. Frontogenesis occurs as a result of a developing
baroclinic In fluid dynamics, the baroclinity (often called baroclinicity) of a stratified fluid is a measure of how misaligned the gradient of pressure is from the gradient of density in a fluid. In meteorology a baroclinic flow is one in which the densi ...
wave. According to Hoskins &
Bretherton Bretherton is a small village and civil parish in the Borough of Chorley, Lancashire, England, situated to the south west of Leyland and east of Tarleton. The population of the civil parish at the 2011 census was 669. Its name suggests pre-co ...
(1972, p. 11), there are eight mechanisms that influence temperature gradients: horizontal
deformation Deformation can refer to: * Deformation (engineering), changes in an object's shape or form due to the application of a force or forces. ** Deformation (physics), such changes considered and analyzed as displacements of continuum bodies. * Defor ...
, horizontal
shearing Sheep shearing is the process by which the woollen fleece of a sheep is cut off. The person who removes the sheep's wool is called a '' shearer''. Typically each adult sheep is shorn once each year (a sheep may be said to have been "shorn" or ...
, vertical deformation, differential vertical motion, latent heat release, surface friction, turbulence and mixing, and radiation. Semigeostrophic frontogenesis theory focuses on the role of horizontal deformation and shear.


Kinematics

Horizontal deformation in mid-latitude cyclones concentrates temperature gradients—cold air from the poles and warm air from the equator. Horizontal shear has two effects on an air parcel; it tends to rotate the parcel (think of placing a wheel at a point in space and as the wind blows, the wheel rotates) and deform the parcel through stretching and shrinking. In the end, this can also tighten temperature gradient, but most importantly, this rotates a concentrated temperature gradient for example, from the x-axis to the y direction. Within a mid-latitude cyclone, these two key features play an essential role in frontogenesis. On a typical mid-latitude cyclone, there are * At west side, northerly winds (N/H) or southerly winds (S/H) (associated with cold air) and * east of the cyclone, southerly winds (N/H) or northerly winds (S/H) (associated with warm air); resulting in horizontal shear deformation. In the end, this results to concentrate a cyclonic shear along a line of maximum shear (which in this case is the birth of a cold front). On the eastern side of a cyclone, horizontal deformation is seen which turns into confluence (a result of translation + deformation). Horizontal deformation at low levels is an important mechanism for the development of both cold and warm fronts (Holton, 2004).


Elements of Frontogenesis

The horizontal shear and horizontal deformation direct to concentrate the pole-equator temperature gradient over a large synoptic scale (1000 km). The
quasi-geostrophic equations While geostrophic motion refers to the wind that would result from an exact balance between the Coriolis force and horizontal pressure-gradient forces, quasi-geostrophic (QG) motion refers to flows where the Coriolis force and pressure gradient ...
fail in the dynamics of frontogenesis because this weather phenomenon is of smaller scale compared to the Rossby radius; so semigeostrophic theory is used. Generally,
Rossby number The Rossby number (Ro), named for Carl-Gustav Arvid Rossby, is a dimensionless number used in describing fluid flow. The Rossby number is the ratio of inertial force to Coriolis force, terms , \mathbf \cdot \nabla \mathbf, \sim U^2 / L and \Omeg ...
—ratio of inertial to coriolis terms—is used to formulate a condition of geostrophic flow. *Across the front, the Rossby number is on the order of udu/dx/fv = (10 m/s)^2/(1000 km)/(1e-4 s-1)/(1 m/s) = 1; this shows we cannot ignore the inertial term (one must take into account the ageostrophic wind). *Along the front, the Rossby number is on the order of udv/dx/fu = (10 m/s)/(1000 km)*(1e-4 s-1)*(10 m/s) = 0.01, which means it is in geostrophic and thermal wind balance. Finally, looking at a cross section (y-z) through the confluent flow, using Q-vectors (Q pointing toward upward motion), on the warm side (bottom of confluent schematic), there is upward motion and on the other hand, the cold side (top of confluent schematic), there is downward motion. The cross-section points out convergence (arrows pointing towards each other) associated with tightening of horizontal temperature gradient. Conversely, divergence is noticed (arrows point away from each other), associated with stretching horizontal temperature gradient. Since the strength of the ageostrophic flow is proportional to temperature gradient, the ageostrophic tightening tendencies grow rapidly after the initial geostrophic intensification.


Development of the Frontogenetical Circulation

During frontogenesis, the temperature gradient tightens and as a result, the
thermal wind The thermal wind is the vector difference between the geostrophic wind at upper altitudes minus that at lower altitudes in the atmosphere. It is the hypothetical vertical wind shear that would exist if the winds obey geostrophic balance in the ...
becomes imbalanced. To maintain balance, the geostrophic wind aloft and below adjust, such that regions of divergence/convergence form. Mass continuity would require a vertical transport of air along the cold front where there is divergence (lowered
pressure Pressure (symbol: ''p'' or ''P'') is the force applied perpendicular to the surface of an object per unit area over which that force is distributed. Gauge pressure (also spelled ''gage'' pressure)The preferred spelling varies by country and e ...
). Although this circulation is described by a series of processes, they are actually occurring at the same time, observable along the front as a thermally direct circulation. There are several factors that influence the final shape and tilt of the circulation around the front, ultimately determining the type and location of clouds and precipitation.


3-Dimensional Equation

The three-dimensional form of the frontogenesis equation is :\begin F = \frac\cdot \frac\left \ \\ + \frac\left \ \\ + \frac\left \\end where each dimension begins with a
diabatic One of the guiding principles in modern chemical dynamics and spectroscopy is that the motion of the nuclei in a molecule is slow compared to that of its electrons. This is justified by the large disparity between the mass of an electron and th ...
term; in the x direction \frac \left ( \frac \right )^\kappa \left \frac \left (\frac \right ) \right /math> in the y direction \frac \left ( \frac \right )^\kappa \left \frac \left (\frac \right ) \right /math> and in the z direction \frac \left \frac \left (p^ \frac \right ) \right /math>. The equation also includes horizontal and vertical
deformation Deformation can refer to: * Deformation (engineering), changes in an object's shape or form due to the application of a force or forces. ** Deformation (physics), such changes considered and analyzed as displacements of continuum bodies. * Defor ...
terms; in the x direction -\left ( \frac \frac \right ) - \left ( \frac \frac \right ) and in the y direction -\left ( \frac \frac \right ) - \left ( \frac \frac \right ) and in the vertical z direction -\left ( \frac \frac \right ) - \left ( \frac \frac \right ). The final terms are the tilting term and the vertical
divergence In vector calculus, divergence is a vector operator that operates on a vector field, producing a scalar field giving the quantity of the vector field's source at each point. More technically, the divergence represents the volume density of t ...
term; the tilting term is represented in the three-dimensional frontogenesis equation in the x and y directions -\left ( \frac \frac \right ) -\left ( \frac \frac \right ) and the vertical
divergence In vector calculus, divergence is a vector operator that operates on a vector field, producing a scalar field giving the quantity of the vector field's source at each point. More technically, the divergence represents the volume density of t ...
term is present as -\left ( \frac \frac \right )


See also

*
Frontolysis Frontolysis in meteorology, is the dissipation or weakening of an atmospheric front. In contrary to areas of "Frontogenesis", the areas where air masses diverge are called areas of frontolysis. See also *Frontogenesis *Outflow boundary Reference ...


References

1. Holton, J. R. (2004). An introduction to dynamic meteorology. (4 ed., Vol. 88, pp. 269–276). San Diego, CA: Academic Press. 2. Hoskins, B. J., & Bretherton, F. P. (1972). Atmospheric frontogenesis models: Mathematical formulation and solution. J. Atmos. Sci., 29, 11-13. 3. Martin, J. E. (2006). Mid-latitude atmospheric dynamics. (1 ed., pp. 189–194). England: Wiley. {{reflist Synoptic meteorology and weather