ASC (dinghy)
   HOME

TheInfoList



OR:

The ASC or Admiralty Sailing Craft (sometimes incorrectly called Admiralty Sea Cadet) is a purpose-built, rugged GRP or wood
sailing dinghy Dinghy sailing is the activity of sailing small boats by using five essential controls: * the sails * the foils (i.e. the daggerboard or centreboard and rudder and sometimes lifting foils as found on the Moth) * the trim (forward/rear angle o ...
, historically with
gunter rig Gunter rig is a configuration of sail and spars used in sailing. It is a fore and aft sail set abaft (behind) the mast. The lower half of the luff (front) of the sail is attached to the mast, and the upper half is fastened to a spar which is ap ...
, with a
Bermuda rig A Bermuda rig, Bermudian rig, or Marconi rig is a configuration of Mast (sailing), mast and rigging for a type of sailboat and is the typical configuration for most modern sailboats. This configuration was developed in Bermuda in the 1600s; the t ...
optional, designed for use by UK naval and
sea cadet Sea cadets are members of a sea cadet corps, a formal uniformed youth organisation for young people with an interest in waterborne activities and or the national navy. The organisation may be sponsored in whole or in part by the navy or a naval s ...
establishments as a pulling or sailing dinghy. It is a substantial craft, usually left on a
mooring A mooring is any permanent structure to which a vessel may be secured. Examples include quays, wharfs, jetties, piers, anchor buoys, and mooring buoys. A ship is secured to a mooring to forestall free movement of the ship on the water. An ''an ...
in quiet waters rather than being
slipway A slipway, also known as boat ramp or launch or boat deployer, is a ramp on the shore by which ships or boats can be moved to and from the water. They are used for building and repairing ships and boats, and for launching and retrieving small ...
launched. It is intended for a total crew of up to 8 although it can be sculled single-handed. It has a heavy metal centreplate, and is equipped for pulling in addition to sailing. There is also a
sculling Sculling is the use of oars to propel a boat by moving them through the water on both sides of the craft, or moving one oar over the stern. A long, narrow boat with sliding seats, rigged with two oars per rower may be referred to as a scull, it ...
notch on the
transom Transom may refer to: * Transom (architecture), a bar of wood or stone across the top of a door or window, or the window above such a bar * Transom (nautical), that part of the stern of a vessel where the two sides of its hull meet * Operation Tran ...
. This type of boat is gradually being phased out of the Sea Cadets due to the production of the new Trinity 500 rowing boats. As of 2012, ASCs are no longer in use on cadet courses, and have been completely replaced by trinity 500s


Notes

Dinghies {{ship-type-stub