πŸ•”
   HOME

TheInfoList



OR:

A clock face is the part of an analog clock (or watch) that displays time through the use of a flat dial with reference marks, and revolving pointers turning on concentric shafts at the center, called hands. In its most basic, globally recognized form, the periphery of the dial is numbered 1 through 12 indicating the hours in a 12-hour cycle, and a short hour hand makes two revolutions in a day. A long minute hand makes one revolution every hour. The face may also include a ''
second The second (symbol: s) is the unit of time in the International System of Units (SI), historically defined as of a day – this factor derived from the division of the day first into 24 hours, then to 60 minutes and finally to 60 seconds ...
hand'', which makes one revolution per minute. The term is less commonly used for the time display on
digital clock A digital clock is a type of clock that displays the time digitally (i.e. in numerals or other symbols), as opposed to an analogue clock. Digital clocks are often associated with electronic drives, but the "digital" description refers only to ...
s and watches. A second type of clock face is the
24-hour analog dial Clocks and watches with a 24-hour analog dial have an hour hand that makes one complete revolution, 360Β°, in a day (24 hours per revolution). The more familiar 12-hour analog dial has an hour hand that makes two complete revolutions in ...
, widely used in military and other organizations that use
24-hour time The modern 24-hour clock, popularly referred to in the United States as military time, is the convention of timekeeping in which the day runs from midnight to midnight and is divided into 24 hours. This is indicated by the hours (and minutes) pa ...
. This is similar to the 12-hour dial above, except it has hours numbered 1–24 around the outside, and the hour hand makes only one revolution per day. Some special-purpose clocks, such as timers and sporting event clocks, are designed for measuring periods less than one hour. Clocks can indicate the hour with
Roman numerals Roman numerals are a numeral system that originated in ancient Rome and remained the usual way of writing numbers throughout Europe well into the Late Middle Ages. Numbers are written with combinations of letters from the Latin alphabet, eac ...
or Hindu–Arabic numerals, or with non-numeric indicator marks. The two numbering systems have also been used in combination, with the prior indicating the hour and the latter the minute.
Longcase clock A grandfather clock (also a longcase clock, tall-case clock, grandfather's clock, or floor clock) is a tall, freestanding, weight-driven pendulum clock with the pendulum held inside the tower or waist of the case. Clocks of this style are common ...
s (grandfather clocks) typically use Roman numerals for the hours. Clocks using only Arabic numerals first began to appear in the mid-18th century. The clock face is so familiar that the numbers are often omitted and replaced with unlabeled
graduation Graduation is the awarding of a diploma to a student by an educational institution. It may also refer to the ceremony that is associated with it. The date of the graduation ceremony is often called graduation day. The graduation ceremony is a ...
s (marks), particularly in the case of watches. Occasionally, markings of any sort are dispensed with, and the time is read by the angles of the hands.


Reading a modern clock face

Most modern clocks have the numbers 1 through 12 printed at equally spaced intervals around the periphery of the face with the 12 at the top, indicating the hour, and on many models, sixty dots or lines evenly spaced in a ring around the outside of the dial, indicating minutes and seconds. The time is read by observing the placement of several "hands", which emanate from the centre of the dial: *A short, thick "hour" hand; *A long, thinner "minute" hand; *On some models, a very thin "second" or "sweep" hand All three hands continuously rotate around the dial in a clockwise direction – in the direction of increasing numbers. *The second, or sweep, hand moves relatively quickly, taking a full minute (sixty seconds) to make a complete rotation from 12 to 12. For every rotation of the second hand, the minute hand will move from one minute mark to the next. *The minute hand rotates more slowly around the dial. It takes one hour (sixty minutes) to make a complete rotation from 12 to 12. For every rotation of the minute hand, the hour hand will move from one hour mark to the next. *The hour hand moves slowest of all, taking twelve hours (half a day) to make a complete rotation. It starts from "12" at midnight, makes one rotation until it is pointing at "12" again at noon, and then makes another rotation until it is pointing at "12" again at midnight of the next morning.


Historical development

The word ''clock'' derives from the medieval Latin word for "bell"; ''clocca'', and has
cognate In historical linguistics, cognates or lexical cognates are sets of words in different languages that have been inherited in direct descent from an etymology, etymological ancestor in a proto-language, common parent language. Because language c ...
s in many European languages. Clocks spread to England from the Low Countries, so the English word came from the Middle Low German and Middle Dutch ''Klocke''. The first mechanical clocks, built in 13th-century Europe, were
striking clock A striking clock is a clock that sounds the hours audibly on a bell or gong. In 12-hour striking, used most commonly in striking clocks today, the clock strikes once at 1:00 am, twice at 2:00 am, continuing in this way up to twelve time ...
s: their purpose was to ring bells upon the
canonical hour In the practice of Christianity, canonical hours mark the divisions of the day in terms of fixed times of prayer at regular intervals. A book of hours, chiefly a breviary, normally contains a version of, or selection from, such prayers. In t ...
s, to call the local community to prayer. These were
tower clock Clock towers are a specific type of structure which house a turret clock and have one or more clock faces on the upper exterior walls. Many clock towers are freestanding structures but they can also adjoin or be located on top of another buildi ...
s installed in
bell tower A bell tower is a tower that contains one or more bells, or that is designed to hold bells even if it has none. Such a tower commonly serves as part of a Christian church, and will contain church bells, but there are also many secular bell tower ...
s in public places, to ensure that the bells were audible over a wide area. Soon after these first mechanical clocks were in place clockmakers realized that their wheels could be used to drive an indicator on a dial on the outside of the tower, where it could be widely seen, so the local population could tell the time between the hourly strikes. Before the late 14th century, a fixed hand (often a carving literally shaped like a hand) indicated the hour by pointing to numbers on a rotating dial; after this time, the current
convention Convention may refer to: * Convention (norm), a custom or tradition, a standard of presentation or conduct ** Treaty, an agreement in international law * Convention (meeting), meeting of a (usually large) group of individuals and/or companies in a ...
of a rotating hand on a fixed dial was adopted. Minute hands (so named because they indicated the small, or ''minute'', divisions of the hour) only came into regular use around 1690, after the invention of the pendulum and anchor escapement increased the precision of time-telling enough to justify it. In some precision clocks, a third hand, which rotated once a minute, was added in a separate subdial. This was called the "second-minute" hand (because it measured the ''secondary minute'' divisions of the hour), which was shortened to "second" hand. The convention of the hands moving clockwise evolved in imitation of the
sundial A sundial is a horological device that tells the time of day (referred to as civil time in modern usage) when direct sunlight shines by the apparent position of the Sun in the sky. In the narrowest sense of the word, it consists of a flat ...
. In the Northern hemisphere, where the clock face originated, the shadow of the
gnomon A gnomon (; ) is the part of a sundial that casts a shadow. The term is used for a variety of purposes in mathematics and other fields. History A painted stick dating from 2300 BC that was excavated at the astronomical site of Taosi is the ol ...
on a horizontal sundial moves clockwise during the day.


French decimal time

During the French Revolution in 1793, in connection with its Republican calendar, France attempted to introduce a decimal time system. This had 10 decimal hours in the day, 100 decimal minutes per hour, and 100 decimal seconds per minute. Therefore, the decimal hour was more than twice as long (144 min) as the present hour, the decimal minute was slightly longer than the present minute (86 seconds) and the decimal second was slightly shorter (0.86 sec) than the present second. Clocks were manufactured with this alternate face, usually combined with traditional hour markings. However, it did not catch on, and France discontinued the mandatory use of decimal time on 7 April 1795, although some French cities used decimal time until 1801.


Stylistic development

Until the last quarter of the 17th century, hour markings were etched into metal faces and the recesses filled with black wax. Subsequently, higher contrast and improved readability was achieved with white enamel plaques painted with black numbers. Initially, the numbers were printed on small, individual plaques mounted on a brass substructure. This was not a stylistic decision, rather enamel production technology had not yet achieved the ability to create large pieces of enamel. The "13-piece face" was an early attempt to create an entirely white enamel face. As the name suggests, it was composed of 13 enamel plaques: 12 numbered wedges fitted around a circle. The first single-piece enamel faces, not unlike those in production today, began to appear . It is customary for modern advertisements to display clocks and watches set to approximately 10:10 or 1:50, as this V-shaped arrangement roughly makes a smile, imitates a human figure with raised arms, and leaves the watch company's logo unobscured by the hands. In the 1970s, German designer Tian Harlan invented the Chromachron, a wristwatch with a clock face that has no dials but a disc with pie-shaped pattern rotating by the minute over color patterns representing both hours and minutes.


Technological obsolescence

In the 2010s, some United Kingdom schools started replacing analogue clocks in examination halls with
digital clock A digital clock is a type of clock that displays the time digitally (i.e. in numerals or other symbols), as opposed to an analogue clock. Digital clocks are often associated with electronic drives, but the "digital" description refers only to ...
s because an increasing number of pupils were unable to read analogue clocks. Smartphone and computer clocks are often digital rather than analogue, and proponents of replacing analogue clock faces argue that they have become technologically obsolete. However, reading analogue clocks is still part of American elementary school curricula; proponents of analogue clocks argue that their inclusion in the curriculum reinforces basic mathematical concepts that are taught in elementary school.


See also

*
List of largest clock faces A list of permanent working clocks with the largest faces in the world. Entries include all clocks with faces at least in diameter. Clocks can be located on the exterior or interior of buildings, and towers as well as on the ground as is the case ...
* Clock position *
Roman numerals Roman numerals are a numeral system that originated in ancient Rome and remained the usual way of writing numbers throughout Europe well into the Late Middle Ages. Numbers are written with combinations of letters from the Latin alphabet, eac ...


Footnotes

{{DEFAULTSORT:Clock Face Timekeeping components