|
Breechblock
A breechblock (or breech block) is the part of the firearm action that closes the breech of a breech loading weapon (whether small arms or artillery) before or at the moment of firing. It seals the breech and contains the pressure generated by the ignited propellant. Retracting the breechblock allows the chamber to be loaded with a cartridge. Breechblocks are categorised by the type or design of the mechanism by which it is locked or closed for firing. The firearm action more fully refers to the mechanism by which the operator actuates the opening and closing of the breech. Variants A way of closing the breech or chamber is an essential part of any breech-loading weapon or firearm. Perhaps the simplest way of achieving this is a break-action, in which the barrel, forestock and breech pivot on a hinge that joins the front assembly to the rear of the firearm, incorporating the rear of the breech, the butt and usually, the trigger mechanism. A breechblock is a separate compon ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Firearm Actions
In firearms terminology, an action is the functional mechanism of a breech-loading firearm that handles (loads, locks, fires, extracts and ejects) the ammunition cartridges, or the method by which that mechanism works. Actions are technically not present on muzzleloaders, as all those are single-shot firearms with a closed off breech with the powder and projectile manually loaded from the muzzle. Instead, the muzzleloader ignition mechanism is referred to as the ''lock'' (e.g. matchlock, flintlock, caplock). Actions can be categorized in several ways, including single action versus double action, break action versus bolt action, and others. The term action can also include short, long, and magnum if it is in reference to the length of the rifle's receiver and the length of the bolt. The short action rifle usually can accommodate a cartridge length of or smaller. The long action rifle can accommodate a cartridge of , and the magnum action rifle can accommodate cartridges o ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Firearm Action
In firearms terminology, an action is the functional mechanism of a breech-loading firearm that handles (loads, locks, fires, extracts and ejects) the ammunition cartridges, or the method by which that mechanism works. Actions are technically not present on muzzleloaders, as all those are single-shot firearms with a closed off breech with the powder and projectile manually loaded from the muzzle. Instead, the muzzleloader ignition mechanism is referred to as the ''lock'' (e.g. matchlock, flintlock, caplock). Actions can be categorized in several ways, including single action versus double action, break action versus bolt action, and others. The term action can also include short, long, and magnum if it is in reference to the length of the rifle's receiver and the length of the bolt. The short action rifle usually can accommodate a cartridge length of or smaller. The long action rifle can accommodate a cartridge of , and the magnum action rifle can accommodate cartridges o ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cartridge (firearms)
A cartridge or a round is a type of pre-assembled firearm ammunition packaging a projectile ( bullet, shot, or slug), a propellant substance (usually either smokeless powder or black powder) and an ignition device (primer) within a metallic, paper, or plastic case that is precisely made to fit within the barrel chamber of a breechloading gun, for the practical purpose of convenient transportation and handling during shooting. Although in popular usage the term "bullet" is often informally used to refer to a complete cartridge, it is correctly used only to refer to the projectile. Cartridges can be categorized by the type of their primers – a small charge of an impact- or electric-sensitive chemical mixture that is located: at the center of the case head ( centerfire); inside the rim ( rimfire); inside the walls on the fold of the case base that is shaped like a cup (cupfire, now obsolete); in a sideways projection that is shaped like a pin ( pinfire, now obsolete); ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Receiver (firearms)
In firearms terminology, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving") components such as the barrel, stock, trigger mechanism and iron/ optical sights. The receiver is often made of forged, machined, or stamped steel or aluminium; in addition to these traditional materials, modern science and engineering have introduced polymers and sintered metal powders to receiver construction. Mounting A barrel can be fixed to the receiver using barrel and receiver action threads or similar methods. In US law For the purposes of United States law, the receiver or frame is legally the firearm, and as such it is the controlled part. The definition of which assembly is the legal receiver varies from firearm to firearm, under US law. Generally, the law req ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bolt Action
Bolt-action is a type of manual firearm action that is operated by ''directly'' manipulating the bolt via a bolt handle, which is most commonly placed on the right-hand side of the weapon (as most users are right-handed). Most bolt-action firearms use a rotating bolt design, where the handle must first be rotated upward to unlock the bolt from the receiver, then pulled back to open the breech and allowing any spent cartridge case to be extracted and ejected. This also cocks the striker within the bolt (either on opening or closing of the bolt depending on the gun design) and engages it against the sear. When the bolt is returned to the forward position, a new cartridge (if available) is pushed out of the magazine and into the barrel chamber, and finally the breech is closed tight by rotating the handle down so the bolt head relocks on the receiver. Bolt-action firearms are generally repeating firearms, but some single-shot breechloaders also use bolt-action design ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Chamber (firearms)
In firearms, the chamber is the cavity at the back end of a breechloader's barrel or cylinder, where the cartridge is inserted before being fired. The rear opening of the chamber is the breech, and is sealed by the breechblock or the bolt. Function Rifles and pistols generally have a single chamber integral to their barrels, but revolvers have multiple chambers in their cylinder, and no chamber in their barrel. Thus, rifles and pistols can usually still be fired with the magazine removed as long as a cartridge is inserted into the chamber, while a revolver cannot be fired at all with its cylinder swung out. The act of ''chambering'' a cartridge means the insertion of a round into the chamber, either manually or through the action of the weapon, e.g., pump-action, lever-action, bolt action, or Autoloading operation generally in anticipation of firing the weapon, without need to "load" the weapon upon decision to use it (reducing the number of ''actions'' needed to di ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Gun Barrel
A gun barrel is a crucial part of gun-type weapons such as small firearms, artillery pieces, and air guns. It is the straight shooting tube, usually made of rigid high-strength metal, through which a contained rapid expansion of high-pressure gas(es) is used to propel a projectile out of the front end ( muzzle) at a high velocity. The hollow interior of the barrel is called the bore, and the diameter of the bore is called its caliber, usually measured in inches or millimetres. The first firearms were made at a time when metallurgy was not advanced enough to cast tubes capable of withstanding the explosive forces of early cannons, so the pipe (often built from staves of metal) needed to be braced periodically along its length for structural reinforcement, producing an appearance somewhat reminiscent of storage barrels being stacked together, hence the English name.''A History of Warfare'' - Keegan, John, Vintage 1993. History Gun barrels are usually metal. Howev ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Fokker-Leimberger
The Fokker-Leimberger was an externally powered, 12-barrel rifle-caliber rotary gun developed in Germany during the First World War. The action of the Fokker-Leimberger differed from that of a Gatling in that it employed a rotary split-breech design, also known as a " nutcracker". Fokker claimed the gun achieved over 7200 rpm, although this may be an exaggeration. Failures during the war were attributed to the poor quality of German wartime ammunition,Weyl"Motor Guns-A flashback to 1914-18"''Flight'', 8 March 1957, pages 313-314 although a British 1950s experimental weapon with the same type of breech had ruptured-case problems. Fokker continued to experiment with this type of breech after his post-war move to the United States. A different Fokker prototype in a US museum attests to the failure of this line of development. Design The Fokker-Leimberger used a rotary split-breech design known as the "nutcracker". In this design a temporary chamber is formed by joining the two ca ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Breech (firearms)
In firearms, the chamber is the cavity at the back end of a breechloader's barrel or cylinder, where the cartridge is inserted before being fired. The rear opening of the chamber is the breech, and is sealed by the breechblock or the bolt. Function Rifles and pistols generally have a single chamber integral to their barrels, but revolvers have multiple chambers in their cylinder, and no chamber in their barrel. Thus, rifles and pistols can usually still be fired with the magazine removed as long as a cartridge is inserted into the chamber, while a revolver cannot be fired at all with its cylinder swung out. The act of ''chambering'' a cartridge means the insertion of a round into the chamber, either manually or through the action of the weapon, e.g., pump-action, lever-action, bolt action, or Autoloading operation generally in anticipation of firing the weapon, without need to "load" the weapon upon decision to use it (reducing the number of ''actions'' needed to dischar ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Kammerlader
The ''Kammerlader'', or "chamber loader", was the first Norwegian breech-loading rifle, and among the first breech loaders adopted for use by an armed force anywhere in the world. A single-shot black-powder rifle, the ''kammerlader'' was operated with a crank mounted on the side of the receiver. This made it much quicker and easier to load than the weapons previously used. ''Kammerladers'' quickly gained a reputation for being fast and accurate rifles, and would have been a deadly weapon against massed ranks of infantry. The ''kammerlader'' was introduced in 1842, and it is thought that about 40,000 were manufactured until about 1870. While the first flintlock breech-loading rifles, such as the Ferguson, were launched decades before 1842, Norway was among the first European countries to introduce breech loaders on a large scale throughout its army and navy. The ''kammerladers'' were manufactured in several different models, and most models were at some point modified in some wa ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Rimfire Ammunition
Rimfire ammunition is a type of firearm metallic cartridge whose primer is located within a hollow circumferential rim protruding from the base of its casing. When fired, the gun's firing pin will strike and crush the rim against the edge of the barrel breech, sparking the primer compound within the rim, and in turn ignite the propellant within the case. Invented in 1845, by Louis-Nicolas Flobert, the first rimfire metallic cartridge was the .22 BB Cap (a.k.a. 6mm Flobert) cartridge, which consisted of a percussion cap with a bullet attached to the top. While many other different cartridge priming methods have been tried since the 19th century, only rimfire and the later centerfire cartridges survive to the present day with regular usages. The .22 Long Rifle rimfire cartridge, introduced in 1887, is by far the most common ammunition in the world today in terms of units sold. Characteristics Rimfire ammunition is so named because the firing pin strikes and crushes ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cocking Handle
The cocking handle, also known as charging handle or bolt handle, is a device on a firearm which, when manipulated, results in the bolt being pulled to the rear, putting the hammer/ striker into a spring-loaded ("cocked") "ready and set" position, allowing the operator to open the breech and eject any spent/unwanted cartridge/ shell from the chamber, and then load a new round from the magazine or belt if required. By opening the breech, it also helps the operator to verify that the weapon's chamber is clear of any rounds or other obstructions; to clear a stoppage such as a jam, double-feed, stovepipe or misfire; to facilitate moving the bolt back into battery, acting as a forward assist (but not necessarily); and to release a bolt locked to the rear by a catching mechanism on a firearm equipped with a "last round bolt hold open" (LRBHO) feature. These devices vary significantly between firearms but may occur in the form of a small protrusion or hook from the side of the bolt ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
