The withers is the ridge between the shoulder blades of an animal, typically a quadruped. In many species, it is the tallest point of the body. In horses and dogs, it is the standard place to measure the animal's height. In contrast,

cattle Cattle (''Bos taurus'') are large, domesticated, cloven-hooved, herbivores. They are a prominent modern member of the subfamily Bovinae and the most widespread species of the genus '' Bos''. Adult females are referred to as cows and adult ...

are often measured to the top of the hips. The term (pronounced ) derives from

Old English Old English (, ), or Anglo-Saxon, is the earliest recorded form of the English language, spoken in England and southern and eastern Scotland in the early Middle Ages. It was brought to Great Britain by Anglo-Saxon settlers in the mid-5th ...

''wither'' (“against”), because it is the part of a draft animal that pushes against a load.

Horses

The withers in

horse The horse (''Equus ferus caballus'') is a domesticated, one-toed, hoofed mammal. It belongs to the taxonomic family Equidae and is one of two extant subspecies of ''Equus ferus''. The horse has evolved over the past 45 to 55 million yea ...

s are formed by the dorsal spinal processes of roughly the 3rd through 11th thoracic vertebrae, which are unusually long in this area. Most horses have 18 thoracic vertebrae. The processes at the withers can be more than long. Since they do not move relative to the ground as the horse's head does, the withers are used as the measuring point for the height of a horse. Horses are sometimes measured in

hand A hand is a prehensile, multi-fingered appendage located at the end of the forearm or forelimb of primates such as humans, chimpanzees, monkeys, and lemurs. A few other vertebrates such as the koala (which has two opposable thumbs on each "h ...

s – one hand is . Horse heights are extremely variable, from small pony breeds to large draft breeds. The height at the withers of an average

thoroughbred The Thoroughbred is a horse breed best known for its use in horse racing. Although the word ''thoroughbred'' is sometimes used to refer to any breed of purebred horse, it technically refers only to the Thoroughbred breed. Thoroughbreds are ...

is , and ponies are up to .

Conformational issues

The withers of the horse are considered in evaluating conformation. Generally, a horse should have well-defined withers, as they are considered an important attachment point for the muscles of the torso. Withers of medium height are preferred, as high withers make it difficult to fit a saddle and are often associated with a narrow chest, and low withers (known as "mutton withers") do not provide a ridge to help keep the saddle in place. More importantly, the dorsal spinal processes provide an attachment for the muscles that support the shoulder and neck. Horses do not have a

clavicle The clavicle, or collarbone, is a slender, S-shaped long bone approximately 6 inches (15 cm) long that serves as a strut between the shoulder blade and the sternum (breastbone). There are two clavicles, one on the left and one on the r ...

, so the shoulder can freely rotate backwards. If the vertebrae of the withers are long front-to-back, the shoulder is freer to move backwards. This allows for an increase of stride length. thus increasing the horse's speed. It is also important in jumping, as the shoulder must rotate back for the horse to bring its foreleg parallel to the ground, which will then raise the animal's knees upward and get the lower part of the forelegs out of the way. Therefore, the withers have a direct impact on one of the most important points of conformation: the shoulder.

Dogs

In dogs, the height of the withers is often used to determine the dog's jump height in various dog sports. It is also often a determining factor in whether the dog conforms to the show-quality

standards Standard may refer to: Symbols * Colours, standards and guidons, kinds of military signs * Standard (emblem), a type of a large symbol or emblem used for identification Norms, conventions or requirements * Standard (metrology), an object t ...

for its

breed A breed is a specific group of domestic animals having homogeneous appearance (phenotype), homogeneous behavior, and/or other characteristics that distinguish it from other organisms of the same species. In literature, there exist several slig ...

References

{{Reflist Animal anatomy Dog anatomy Horse anatomy