Wool fat

Lanolin (from Latin 'wool', and 'oil'), also called wool yolk, wool wax, or wool grease, is a wax secreted by the sebaceous glands of wool-bearing animals. Lanolin used by humans comes from domestic sheep breeds that are raised specifically for their wool. Historically, many pharmacopoeias have referred to lanolin as wool fat (''adeps lanae''); however, as lanolin lacks glycerides (glycerol esters), it is not a true fat. Lanolin primarily consists of sterol esters instead. Lanolin's waterproofing property aids sheep in shedding water from their coats. Certain breeds of sheep produce large amounts of lanolin.

Lanolin's role in nature is to protect wool and skin from climate and the environment; it also plays a role in skin ( integumental) hygiene. Lanolin and its derivatives are used in the protection, treatment, and beautification of human skin.

Composition

A typical high-purity grade of lanolin is composed predominantly of long chain waxy esters (approximately 97% by weight) with the remainder being lanolin alcohols, lanolin acids and lanolin hydrocarbons.

An estimated 8,000 to 20,000 different types of lanolin esters are present in lanolin, resulting from combinations between the 200 or so different lanolin acids and the 100 or so different lanolin alcohols identified so far.

Lanolin’s complex composition of long-chain esters, hydroxyesters, diesters, lanolin alcohols, and lanolin acids means in addition to it being a valuable product in its own right, it is also the starting point for the production of a whole spectrum of lanolin derivatives, which possess wide-ranging chemical and physical properties. The main derivatisation routes include hydrolysis, fractional solvent crystallisation, esterification, hydrogenation, alkoxylation and quaternisation. Lanolin derivatives obtained from these processes are used widely in both high-value cosmetics and skin treatment products.

Hydrolysis of lanolin yields lanolin alcohols and lanolin acids. Lanolin alcohols are a rich source of cholesterol (an important skin lipid) and are powerful water-in-oil emulsifiers; they have been used extensively in skincare products for over 100 years. Notably, approximately 40% of the acids derived from lanolin are alpha-hydroxy acids (AHAs). The use of AHAs in skin care products has attracted a great deal of attention in recent years. Details of the AHAs isolated from lanolin can be seen in the table below.

Modern developments

In addition to general purity requirements, lanolin must meet official requirements for the permissible levels of pesticide residues. The Fifth Supplement of the United States Pharmacopoeia XXII published in 1992 was the first to specify limits for 34 named pesticides. A total limit of 40  ppm (i.e. 40 mg/kg) total pesticides was stipulated for lanolin of general use, with no individual limit greater than 10 ppm.

A second monograph also introduced into the US Pharmacopoeia XXII in 1992 was entitled 'Modified Lanolin'. Lanolin conforming to this monograph is intended for use in more exacting applications, for example on open wounds. In this monograph, the limit of total pesticides was reduced to 3 ppm total pesticides, with no individual limit greater than 1 ppm.

In 2000, the European Pharmacopoeia introduced pesticide residue limits into its lanolin monograph. This requirement, which is generally regarded as the new quality standard, extends the list of pesticides to 40 and imposes even lower concentration limits.

Some very high-purity grades of lanolin surpass monograph requirements. New products obtained using complex purification techniques produce lanolin esters in their natural state, removing oxidative and environmental impurities resulting in white, odourless, hypoallergenic lanolin. These ultra-high-purity grades of lanolin are ideally suited to the treatment of dermatological disorders such as eczema and on open wounds.

Lanolin attracted attention owing to a misunderstanding concerning its sensitising potential. A study carried out at New York University Hospital in the early 1950s had shown about 1% of patients with dermatological disorders were allergic to the lanolin being used at that time. By one estimate, this simple misunderstanding of failing to differentiate between the general healthy population and patients with dermatological disorders exaggerates the sensitising potential of lanolin by 5,000–6,000 times.

The European Cosmetics Directive lipids; the lipids which help regulate the rate of water loss across the epidermis and govern the hydration state of the skin.

Cryogenic scanning electron microscopy has shown that lanolin, like human stratum corneum lipids, consists of a mass of liquid crystalline material. Cross-polarised light microscopy has shown the multilamellar vesicles formed by lanolin are identical to those formed by human stratum corneum lipids. The incorporation of bound water into the stratum corneum involves the formation of multilamellar vesicles.

Skin bioengineering studies have shown the durational effect of the emollient (skin smoothing) action produced by lanolin is very significant and lasts for many hours. Lanolin applied to the skin at 2 mg/cm² has been shown to reduce roughness by about 35% after one hour and 50% after two hours, with the overall effect lasting for considerably more than eight hours. Lanolin is also known to form semiocclusive (breathable) films on the skin. When applied daily at around 4 mg/cm² for five consecutive days, the positive moisturising effects of lanolin were detectable until 72 hours after final application. Lanolin may achieve some of its moisturising effects by forming a secondary moisture reservoir within the skin.

The barrier repair properties of lanolin have been reported to be superior to those produced by both petrolatum and glycerol. In a small clinical study conducted on volunteer subjects with terribly dry (xerotic) hands, lanolin was shown to be superior to petrolatum in reducing the signs and symptoms of dryness and scaling, cracks and abrasions, and pain and itch. In another study, a high purity grade of lanolin was found to be significantly superior to petrolatum in assisting the healing of superficial wounds.

Applications

Lanolin and its many derivatives are used extensively in both the personal care (e.g., high value cosmetics, facial cosmetics, lip products) and health care sectors such as topical liniments. Lanolin is also found in lubricants, rust-preventive coatings, shoe polish, and other commercial products.

Lanolin is a relatively common allergen and is often misunderstood as a wool allergy. However, allergy to a lanolin-containing product is difficult to pinpoint and often other products containing lanolin may be fine for use. Patch testing can be done if a lanolin allergy is suspected.

It is frequently used in protective baby skin treatment and for sore nipples from breastfeeding.

Lanolin is used commercially in many industrial products ranging from rustproof coatings to lubricants. Some sailors use lanolin to create slippery surfaces on their propellers and stern gear to which barnacles cannot adhere. Commercial products (e.g. Lanocote) containing up to 85% lanolin are used to prevent corrosion in marine fasteners, especially when two different metals are in contact with each other and saltwater. The water-repellent properties make it valuable in many applications as a lubricant grease where corrosion would otherwise be a problem.

7-Dehydrocholesterol from lanolin is used as a raw material for producing vitamin D₃ by irradiation with ultraviolet light.

Baseball players often use it to soften and break in their baseball gloves (shaving cream with lanolin is popularly used for this).

Anhydrous liquid lanolin, combined with parabens, has been used in trials as artificial tears to treat dry eye.

Anhydrous lanolin is also used as a lubricant for brass instrument tuning slides.

Lanolin can also be restored to woollen garments to make them water and dirt repellent, such as for cloth diaper covers.

Lanolin is also used in lip balm products such as Carmex. For some people, it can irritate the lips.

Lanolin is sometimes used by people on continuous positive airway pressure therapy to reduce irritation with masks, particular nasal pillow masks that can often create sore spots in the nostrils.

Lanolin is a popular additive to moustache wax, particularly 'extra-firm' varieties.

Lanolin is used as a primary lubricating component in aerosol-based brass lubricants in the ammunition reloading process. Mixed warm 1:12 with highly concentrated ethanol (usually 99%), the ethanol acts as a carrier which evaporates quickly after application, leaving a fine film of lanolin behind to prevent brass seizing in resizing dies.

Lanolin, when mixed with ingredients such as neatsfoot oil, beeswax and glycerol, is used in various leather treatments, for example in some saddle soaps and in leather care products.

Production

Crude lanolin constitutes about 5–25% of the weight of freshly shorn wool. The wool from one Merino sheep will produce about 250–300 ml of recoverable wool grease. Lanolin is extracted by washing the wool in hot water with a special wool scouring detergent to remove dirt, wool grease (crude lanolin), suint (sweat salts), and anything else stuck to the wool. The wool grease is continuously removed during this washing process by centrifuge separators, which concentrate it into a waxlike substance melting at approximately .

References

External links

*

{{E number infobox 910-919

Animal glandular products
Waxes
Non-petroleum based lubricants