Wavetable Synthesizer

Wavetable synthesis is a sound synthesis technique used to create quasi-periodic waveforms often used in the production of musical tones or notes.

Development

Wavetable synthesis was invented by Max Mathews in 1958 as part of MUSIC II. MUSIC II “had four-voice polyphony and was capable of generating sixteen wave shapes via the introduction of a wavetable oscillator.”

Hal Chamberlin discussed wavetable synthesis in Byte's September 1977 issue. Wolfgang Palm of Palm Products GmbH (PPG) developed his version in the late 1970s and published it in 1979. The technique has since been used as the primary synthesis method in synthesizers built by PPG and Waldorf Music and as an auxiliary synthesis method by Ensoniq and Access. It is currently used in hardware synthesizers from Waldorf Music and in software synthesizers for PCs and tablets, including apps offered by PPG and Waldorf, among others.

It was also independently developed by Michael McNabb, who used it in his 1978 composition ''Dreamsong''.

Principle

Wavetable synthesis is fundamentally based on periodic reproduction of multiple arbitrary, single-cycle waveforms. In wavetable synthesis, some method is employed to vary or modulate the selected waveform in the wavetable. The position in the wavetable selects the single cycle waveform. Digital interpolation between adjacent waveforms allows for dynamic and smooth changes of the timbre of the tone produced. Sweeping the wavetable in either direction can be controlled in a number of ways, for example, by use of an LFO, envelope, pressure or velocity.

Many wavetables used in PPG and Ensoniq synthesizers can simulate the methods used by analog synthesizers, such as pulse-width modulation by utilising a number of square waves of different duty cycles. In this way, when the wavetable is swept, the duty cycle of the pulse wave will appear to change over time. As the early Ensoniq wavetable synthesizers had non resonant filters (the PPG Wave synthesizers used analogue Curtis resonant filters), some wavetables contained highly resonant waveforms to overcome this limitation of the filters.

Confusion with sample-based synthesis (S&S) and Digital Wave Synthesis

In 1992, with the introduction of the Creative Labs Sound Blaster 16 the term "wavetable" started to be (incorrectly) applied as a marketing term to their sound card. However, these sound cards did not employ any form of wavetable synthesis, but rather PCM samples and FM synthesis.

S&S (Sample and Synthesis) and Digital Wave Synthesis was the main method of sound synthesis utilised by digital synthesizers starting in the mid 1980s with synthesizers such as Sequential Circuits Prophet VS, Korg DW6000/8000 (DW standing for Digital Wave), Roland D50 and Korg M1 through to current synthesizers.

Ableton addressed some confusion in an article:

Often they now have displays showing a real time 3d graphs of the wave table being played back with the current waveform highlighted which is the signature feature common in modern wavetable synths.

User wavetables

The creation of new wavetables was previously a difficult process unless supported by specialized editing facilities and (near) real-time playback of edited wavetables on the synthesizer. Such editors often required the use of extra hardware devices like the PPG Waveterm or were only present in expensive models like the Waldorf WAVE. More commonly, pre-computed wavetables could be added via memory cards or sent to the synthesizer via MIDI. Today, wavetables can be created more easily by software and auditioned directly on a computer. Since all waveforms used in wavetable synthesis are periodic, the time-domain and frequency-domain representation are exact equivalents of each other and both can be used simultaneously to define waveforms and wavetables.

Practical use

During playback, the sound produced can be harmonically changed by moving to another point in the wavetable, usually under the control of an envelope generator or low frequency oscillator but frequently by any number of modulators (matrix modulation). Doing this modifies the harmonic content of the output wave in real time, producing sounds that can imitate acoustic instruments or be totally abstract, which is where this method of sound creation excels. The technique is especially useful for evolving synth pads, where the sound changes slowly over time.

It is often necessary to 'audition' each position in a wavetable and to scan through it, forwards and backwards, in order to make good use of it, though selecting random wavetables, start positions, end positions and directions of scan can also produce satisfying musical results. It is worth noting that most wavetable synthesizers also employ other synthesis methods to further shape the output waveform, such as subtractive synthesis (filters), phase modulation, frequency modulation and AM (ring) modulation.

Table-lookup synthesis

Table-lookup synthesis (or Wavetable-lookup synthesis) is a class of sound synthesis methods using the waveform tables by table-lookup, called "table-lookup oscillator" technique.
The length of waveforms or samples may be varied by each sound synthesis method, from a single-cycle up to several minutes.

Terminologies

The term "''waveform table''" (or "''wave shape table''" as equivalent) is often abbreviated to "wavetable",

and its derived term "''wavetable oscillator''" seems to be almost the same as "''table-lookup oscillator''" mentioned above, although the word "wave" (or "waveform", "wave shape") may possibly imply a nuance of single-cycle waveform.

However, a derived term "''wavetable synthesis''" seems slightly confusing as its original meaning is essentially the same as "''table-lookup synthesis''",

"''In this section ... we will be introduce the ''table-lookup method'' for generating waveforms. This method is also called ''wavetable synthesis'' ... / Wavetable synthesis is a technique based on reading data that has been stored in blocks of ''contiguous computer-memory locations'', called ''tables''. This sound-synthesis technique was one of the very first software synthesis methods introduced in the MUSIC I-MUSIC V languages developed by Max Mathews at Bell Labs in the late 1950s and the early 1960s. ... / With table-lookup synthesis, it is sufficient to calculate only a single cycle of a waveform, and then store this small set of samples in the table where it serves as a template. ...''"
Note: on the preceding quotation, the authors paraphrased the section title "table-lookup oscillators" as follows: "table-lookup method", "wavetable synthesis", and "table-lookup synthesis".


"''The oscillator generates a cycle of some waveform the appropriate number of times per second for the desired fundamental frequency. This is referred to variously as fixed-waveform synthesis, table-lookup synthesis, or wavetable synthesis.''"


HTML
version available)
"''For example, the wavetable oscillator used i
Fig. 1
made its first appearance in Mathews's Music II (two, not eleven) in the late 1950s. Music II was only one in a long sequence of MUSIC N programs, but the idea of wavetable synthesis has had a pervasive influence throughout the computer music discipline.''"
and possibly several actions on waveform(s) may be expected.
, "''SOS contributor Steve Howell replies: Wavetable synthesis is actually quite easy to understand. In the early days of synthesis, (analogue) oscillators provided a limited range of waveforms, such as sine, triangle, sawtooth and square/pulse, normally selected from a rotary switch. This gave the user a surprisingly wide range of basic sounds to play with, especially when different waveforms were combined in various ways.''"
See also: Karplus–Strong string synthesis

(a simple class of "''wavetable-modification algorithm''" known as digital waveguide synthesis
.
(See also the Wikipedia article Digital waveguide synthesis: "''The term "digital waveguide synthesis" was coined by Julius O. Smith III who helped develop it and eventually filed the patent. It represents an extension of the Karplus–Strong algorithm. Stanford University owns the patent rights for digital waveguide synthesis and signed an agreement in 1989 to develop the technology with Yamaha.''")
).
In the late-1970s, Michael McNabb and Wolfgang Palm independently developed the multiple wavetable extension on the table-lookup synthesis
"Multiple wavetable synthesis" developed by Michael McNabb and Wolfgang Palm in the late-1970s, is merely one of the techniques employed to realize dynamically-changing waveforms, by using an array of single-cycle waveforms in table-lookup synthesis. With this synthesis technique, the waveform can be animated in a similar manner as a flip book.
which was typically used on PPG Wave and known as ''wavetable sweeping'',
, "''However, in the late '70s, Wolfgang Palm used 'wavetable' digital oscillators in his innovative PPG Wave synths. Instead of having just three or four waveforms, a wavetable oscillator can have many more — say, 64 — because they are digitally created and stored in a 'look-up table' ... Now, if the waveforms are sensibly arranged, we can begin to create harmonic movement in the sound. ... you approach something not unlike a traditional filter sweep. ...''"
and it was later referred as "''multiple wavetable synthesis''" by .

Simultaneously, since late-1970s, sample-based synthesis using relatively long samples instead of single-cycle waveforms has become pervasive due to the introduction of the Fairlight CMI and E-mu Emulator.

Background

On the above four terminologies for the classes of sound synthesis methods, ''i.e.'',
# Wavetable synthesis — original, generic meaning (i.e. a single-cycle table-lookup synthesis).
# Multiple wavetable synthesis — developed by McNabb and Palm, typically used on PPG Waves.
# Wavetable-modification algorithm — including digital waveguide synthesis.
# Sample-based synthesis
if these had been appropriately used to distinguish each other, any confusions could be avoided, but it seems failed historically.
At latest in the 1990s, several influential sample-based synthesis products were marketed under the trade names similar to "wavetable synthesis" (including Gravis Ultrasound wavetable card, Creative Wave Blaster wavetable daughterboard, and Microsoft GS Wavetable SW Synth), and these confusions have further affected industry standards (including MPEG-4 Structured Audio ''algorithmic and wavetable synthesis'',

and AC97 ''optional hw acceleration wavetable synth''

).
In the mid-2000s, confusion in terminology cropped up yet-again. A subclass of generic wavetable synthesis, ''i.e.'' McNabb and Palm's multiple wavetable synthesis, tends to be erroneously referred as if it was a generic class of whole wavetable synthesis family, exclusively.
, "''Other synths have employed wavetable synthesis in one guise or another since then, and there are several software synths available today which incorporate wavetable synthesis capabilities.''"

Note: Regarding the previous quotation, a specific wavetable synthesis developed by Wolfgang Palm, known as "multiple wavetable synthesis", is ambiguously referred as "wavetable synthesis".

As a result, the difficulty of maintaining consistency between concepts and terminology during rapid technological development is noteworthy.
For this reason the term "Table-lookup synthesis" is explained at length in this article.

See also

* HuC6280A
* MUSIC-N
* Direct digital synthesizer
* Sample-based synthesis

Notes

References

Bibliography

*
*
Copy on MusicDSP
*
*
*
*
*

External links

* GPL application with graphical interface written in C by Camille Bassuel, implementing several DSP tools, including DFT to generate a wavetable set
* (VSTi plugIn) along with new ''Wavetables '08'' by Wolfgang Palm, and (standalone version) worked with by Hermann Seib, Paul Maddox and Dave Forward.
{{Sound synthesis types

Sound synthesis types

ja:デジタルシンセサイザー#ウェーブテーブル・シンセシス